Question about Chevrolet Uplander LS

Open Question

Where is the rear blower motor relay on a 2007 chevy uplander

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dgjtex
  • 405 Answers

SOURCE: Front blower motor doesn't work, rear does

yes, all blower motors have them to control their speed, High, medium, low.. etc. I earn nothing by helping you, but my rating, a fixya rating and I will walk you through this

Posted on Dec 20, 2008

  • 1596 Answers

SOURCE: 2005 Town Country front blower motor inop fuse/relay ok

Break Down And Replace The Blower Motor


REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIR-BAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH OR DEATH.

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel.
  3. Position the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
    1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
    2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.
    3. Push the rubber grommet through the opening in the lower air inlet housing.
    4. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
    5. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
    6. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal
      1. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary.
      INSTALLATION

      1. Gently flex the recirculation-air door downward to gain access to install the blower motor into the HVAC housing.
      2. Position the blower motor to the HVAC housing and tilt and rotate the blower motor as necessary to install it into the HVAC housing.
      3. Align the blower motor mounting tabs to the locations noted during removal and install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      4. Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet.
      5. Position the recirculation door pivot shaft into the lower air inlet housing and install the inlet housing.
      6. Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      7. Install the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. Tighten the screw to 2 N·m (17 in. lbs.).
      8. Connect the blower motor wire lead connector to the blower motor resistor or power module, depending on application.
      9. Install the recirculation door actuator.
      10. Reposition the carpet.
      11. Install the passenger side cowl trim panel.
      12. Reconnect the negative battery cable.
      13. Perform the heater-A/C control calibration procedure.

Posted on Feb 07, 2009

  • 1 Answer

SOURCE: can't locate fuse

The Fuse is loacated in the instrument fuse panel fuse #3 located on the passenger side of the dash, there is round handle to pull the cover off

Posted on May 19, 2009

  • 1 Answer

SOURCE: rear wiper on chevy uplander does not work. fuses

i have a 2006 chevy uplander and i need to change the low beam headlamp how do i do it, also about a month after we had got the van the rear wiper stopped working i haven't checked the fuse yet, but is this a common problem for the uplander, and also the abs light stays on what should i do for that problem, and also when we drive it and then shut it off it does not want to turn on right away.

Posted on May 04, 2010

noranda21
  • 1547 Answers

SOURCE: My 2007 chevy uplander blows

do you have the heat on up front there two seperate units check to make sure you have it on the proper setting up front

Posted on Dec 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 uplander Both front and back Blower motor quit working suddenly. I checked the fuses (under the hood and on the passenger side) for the blower and they are not getting any electric to the fuses, the...


Check main switch for power with a test light or run a sepe rate length of wire to the fan from the battery as a tester ,don,t have a big short out.

Sep 25, 2016 | 2007 Chevrolet Uplander

1 Answer

Rear blower not working on 2008 Chevy uplander


First think I would do is take an ohm meter and see if you are getting power to the rear blower resister. They go bad before the blower does. Also check your fuses and rear fan blower relay. Good luck.

Jan 07, 2015 | 2008 Chevrolet Uplander

1 Answer

REAR WIPER ON 2007 CHEV UPLANDER QUIT WORKING. IS STUCK HALFWAY UP REAR WINDOW.


Your motor is more then likely locked up. Replace the wiper motor. First check the relays.

Oct 13, 2014 | 2007 Chevrolet Uplander

1 Answer

Chevy uplander fan remains on


Could be stuck relay or bad motor controller switch.

Jan 15, 2013 | 2007 Chevrolet Uplander

1 Answer

How to replace rear wiper motor on 2007 chevy uplander


FIRST TURN OFF RADIO THEN DISCONNECT NEGATIVE BATTERY. MARK POSITIONS OF WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE PUTSIDE OF THE LIFT GATE, THEN THE BEZEL, DONT SCRATCH PAINT ON THE LIFT GATE, REMOVE THE UPPER AND LOWER LIFTGATE INTERIOR TRIM PANELS, DISCONNECT THE ELECTRICAL CONNECTOR AT THE REAR WIPER MOTOR, THEN REMOVE THE TWO BOLTS SUPPORT WIPER MOTOR HOLD WIPER MOTOR IN PLACE WHILE REMOVING MOUNTING BOLTS THEN INSTALL NEW WIPER MOTOR THEN PUT EVERYTHING BACK VISA VERSA.

Jul 27, 2011 | 2007 Chevrolet Uplander

1 Answer

I have a 2007 Chevy Express 3500 Ext. - My rear air just stopped. A/c works as normal up front but no blower running in the rear. I have checked all the fuses, what I could find. What next?


the rear blower has its own motor in the back the rear blower motor may be bad or the wires going to it may be bad test for power going to blower motor if you have power in harness hooking to blower motor then blower motor may be at fault auto parts store sells the book on your vehicle its about 18 dollars if not lesser buy a test light trace down your problem if the fuse is good your rear blower motor will be in the back of your vehicle theres a cover that pulls air in back there take the cover of it off you will see your blower motor test wireing going to it for power theres also blower motor relays research it read and you will find the problem good luck

Feb 24, 2011 | 2007 Chevrolet Express Passenger

1 Answer

The heater fan does not turn on in the front of my 2006 chevy uplander the fuses are all fine and can hear the resistance when i turn the control knob


COULD BE FAULTY BLOWER MOTOR RELAY.CHECK TO SEE IF BLOWER MOTOR GETTING POWER USING A TEST LIGHT.WHEN YOU TURN ON BLOWER SWITCH POWER SHOULD BE AT PURPLE WIRE.IF YES BLOWER MOTOR FAULTY.IF NO YOU HAVE FAULTY HVAC CONTROL MODULE OR BLOWER MOTOR CONTROL SWITCH.

Jan 09, 2011 | 2007 Chevrolet Uplander LS Minivan

1 Answer

2007 Chevy Uplander Rear Overhead A/C Vents Won't Work


Have you checked the Aux switch near the bottom of the center control console.
There should be a knob with: Aux, Off, 1, 2, 3. This is the switch for the rear AC blower.
If the driver wants to control the rear AC, use the 1, 2, 3 settings.
If you put it on Aux, Than the rear AC is controlled by the passenger in the back seat using the extra controls located on the Overhead DVD player. (The front AC must be on the rear to work)

Jul 09, 2009 | 2006 Chevrolet Uplander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...