Question about 1999 Chevrolet Silverado 1500

2 Answers

I am trying to replace the door pins on a 1999 chevy silverado Is there an easy way to do this they are being quite troublesome

Posted by on

  • nheeley Jun 23, 2009

    Thanks. It took a bit but i figured out how to at least adjust them so there is less slop. Otherwise it will be going in to be done.



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I prefer to keep my money in my pocket to spend on fun stuff so when i did mine i used a floor jack and a 2x4 between them so the jack didnt scrap the door. using a chisel i pounded the pins out used channel locks to press the bushings out. now to press them in i used channel locks and put a semi deep socket on the side where the bushing would come through the hinge so i can use the pliers to press it in and it would go into the socket rather than being crushed by lower jaw of pliers

Posted on Jun 30, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 365 Answers

The EASY way is to take it to a body shop and pay them $75 to do it for you...honestly, this is a BIG job.
Good Luck

Posted on Jun 23, 2009

  • messstat
    messstat Jun 25, 2009

    You know the body shop might not charge you that much...maybe only $25?
    Best of Luck



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 chevy silverado actuator door is stuck blowing heat instead of cold air

It is likely that you'll need to replace the temp door actuator, more likely it is bad than the temp control.

Mar 07, 2018 | 1999 Chevrolet Silverado 1500

2 Answers

Repair heater control in a 2000 chevy pick up

The best way to get an answer for this go onto Youtube and they usually have fixrs for everything. Between last year and this year I have saved myself thousands of dollars repairing stuff myself through youtube.

Dec 31, 2014 | Cars & Trucks

1 Answer

How do I replace rear axle seal on a 1999 chevy Silverado?

Watch the You Tube Video

Remove the rear axle cover
Remove the carrier bolt & pin
Push the axles in
Remove the C-Clips
Pull the Axles
R & R the housing end seals

Sep 30, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

How do I remove old pins and bushings in a 99 chevy silerado

put a jack under door to hold up take a big screw driver pull spring out the use screw driver to drive both pins out thenpull door away from truck replace bushings then put door back put pins back in hinges

Jan 21, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

How do you replace door hinge pins on a 1999 chevy silverardo

The pins are driven out since they are driven is. Have the door supported on some sort of lifting device securely since it will become wobbly upon removal. Do one hinge at a time. The upper one gets the most wear

Jul 10, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

Can the door pins be replaced one at a time on a 1999 silverado

Try can be, but your better off replacing both upper and lower pins since your there.
Here is a link that should help give you a better look on what work needs to be performed.
Thank you for using fixya and be safe.

May 13, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Can you make it so that your doors automatically unlock when you turn the key off or put it in park on a 1999 Chevy 1500

yes its very easy but hard to describe it in writing, basically you need several relays and 2 hrs each door to connect it.........

Feb 16, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Replace the neutral safety switch on my 1999 Chevy Silverado

If it looks like this:

It is mounted on the side of the tranny. It also says a special to remove it.991cb34.jpg

Apr 01, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

1999 Chevrolet silverado exterior door handle replacement

Got to remove inside panel & remove nuts holding it on.

Dec 13, 2008 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides