Question about Cars & Trucks

Open Question

95 max 5 spd man, has infi gearbox. just put a stage 4 clutch in it, everything was smooth about a week later, car starts running very bad, runs but I have to shift it at 2k rpm into every gear or it back fires very bad, then as it idles it revs up and down(slightly).never did that before.i am about to change the fuel filter(looks o very old) Any other suggestions, I'm up for anything and I could almost do it all myself tools, time are limited Thanks guys so, so much

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ginko
  • 19396 Answers

SOURCE: Engine vibration on 1.6 L Cyl. Tracker 4x4

Vibrations are caused by engine components, they can also be caused by piston slap, excessive valve lash, excessive bearing clearances, deformation of parts under stress, crankshaft and camshaft deformations. Also problems with axel and wheel bearings can cause abnormal vibration. If you detect an abnormal vibration in your vehicle consult immediately a mechanic, the safety of the vehicle may be compromised.

Posted on Jul 24, 2008

  • 740 Answers

SOURCE: 95 maxima rough idle

The injector could definitely trigger a misfire code, but you also mentioned that you had a mass airflow sensor code , that code code be responsible for te sluggish moment of the vehicle and rpm going up and down. However if you have a misfire onCyl#6 and the coil and the plug is good the ONLY other thing to cause a mis-fire would be the injector. To check the injector get a NOID light, you can get one at almost any auto-parts place. To use unplug injector plug from the bad injector and connect it to NOID light the light should have a steady PULSE/ligt flickering. If light flickers fine then injector is bad and will need to be replaced. If light doesn't flicker or flickers intermittently then you may have a bad wiring to that injector. Check if wiring is good, then you may have a bad cam sensor or sensor gear. Good Luck and contact if you need more help. Thanks for using FIX YA

Posted on Jan 13, 2009

  • 1147 Answers

SOURCE: 95 nis max, covert. Stick.ok car runs fine put new

It's starving for fuel OR air.Replace the air filter first.If still does this,replace the fuel filter.Higher rpm calls for more fuel and air.

Posted on May 14, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 04 Ranger Edge dropped speed and the a/c stopped working while driving on the Interstate. The road is smooth, 91degrees, and had been running for about 1 hour after fill up. I pulled off the road, shut...


Make sure your system is charged properly. Also make sure your cooling system is properly clean and filled up to max levels. Sometimes low freon or old cooling system fluid will cause a delay in the A/C to work. Also chech to see if there is any black powder around your A/C clutch, if so, this is a sign that the system is about to go out of service. You can get a great deal on the part from Amazon.

Jun 12, 2017 | 2004 Ford Ranger

1 Answer

95 nis max, covert. Stick.ok car runs fine put new clutch in it. Now shifts smoothly then around 2k rpms, it starts back firing, like it wants to steal unless I switch to 2nd, then 3rd, and so on....


It's starving for fuel OR air.Replace the air filter first.If still does this,replace the fuel filter.Higher rpm calls for more fuel and air.

May 14, 2014 | Cars & Trucks

1 Answer

Transmission 300zx


any noise from gearbox when you engaging clutch when engine is running? Check for oil as well. Firstly I suggest to drain oil out and check for particles in the oil, synchros could be damaged

Apr 14, 2014 | 1990 Nissan 300ZX

2 Answers

Throwout bearing is bad, 5 spd manual. I have a good amount of mechanical ability. What does replacing the throwout bearing entail?


Hi Ryan,here's a link to show you how to work on your clutch and do repairs,also join the site,it's free,then you can use their repair guides like me,hope this helps.

Oct 02, 2013 | 1998 Nissan Altima

1 Answer

Kia Sephia 5 spd won't shift gears


You need to bleed the lines with a special tool, contact the dealer on this.

Jun 13, 2012 | 2000 Kia Sephia

1 Answer

Runs bad


check fuel line

Jan 05, 2009 | 1992 Buick LeSabre

2 Answers

1989 mazda astina 323 5 spd manual clutch fluid??


open your bonnet check to see @ gearbox if the-res is cable, or a cylinder, the cable is Usualy visible on the top of the gearbox if theres a cable theres no clutch flu-ed needed. Note that your gearbox uses oil. Usualy on older models like 1989 the use a clutch cable no flu-ed needed

Jan 03, 2009 | 1989 Mazda 323

1 Answer

Excessive fuel consumprion - 2.3 L 4 cyl engine


Not for the home mechanic, but you could try a fuel system service. Basically they add chemicals to your fuel tank via a machine, and these chemicals clean the fuel system... fuel injectors, lines, filter, basically everything... that seemed to help my fuel mileage and also throttle response.

Dec 19, 2008 | 1997 Ford Ranger SuperCab

2 Answers

79 F-150 4 speed trans.


If I were you I would stay with the automatic because a 5 speed will actually use more gas in the long run and cost you less than replacing everything to a 5 spd.. Try playing with the timing and carburetor to get the max mpg.

Jul 14, 2008 | 1982 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...