Question about Ford Bronco II

1 Answer

'88 Ford Bronco injectors not spraying fuel - Bronco II Ford Cars & Trucks

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Ford Expert
  • 496 Answers

Use a Noid Light to see if you are getting power to your injectors and do a Fuel Pressure test.

Posted on Mar 31, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 28 Answers

SOURCE: Fuel Problem

fuel pressure regulator? This diverts excess pressure from the rail back to the tank. When they wear out they usually stay stuck open thus diverting all pressure back to the tank. Pressure tests do not reveal this as pressure is checked before the rail not in it. I do believe you have a bad fuel regulator. They are 75US ouch.

Posted on Dec 10, 2008

  • 14 Answers

SOURCE: 87 ford bronco fuel gauge problems

The problem is most likly the sending unit in the fuel tank but check the float. drain tank, there are two bolt in the straps on the fuel tank lossen enuf to lower tank to get to top to unplug wires and fuel lines once tank is on the ground thee is a ring on the top of tank holding the pump and sending unit in tap ring around with a screw driver to lossen once you have that off just pull unit out of tank and follow directions that come with sending unit. reverse removal procedure. good luck.

Posted on Apr 07, 2009

  • 166 Answers

SOURCE: no power to electric fuel pump 88 5L 302

check the fuel pump relay this sends the power to the fuel pump,

also has the car been in a smash even a small one if so the car may be fit with a enersher switch that cuts off the fuel circuit.

recommend you by a repair manual from your local parts retailer for the exact locations of these 2 units

Posted on Jul 18, 2009

Exhaustking
  • 43 Answers

SOURCE: fuel injectors spraying to much gas

to be honest, with an 89, all you can do is replace the injector. how an injector works is there is a small amount of current that is run to a coil around a rod (if you are unaware, this produces magnetic fields). the magnetic field produced pulls up what is usually a small ball, allowing fuel to go through the tip of the injector nozzle. all you can do to fix this is to buy different injectors.

just a question..why do you think they are spraying too much fuel? because it may just be that you have excessive fuel pressure and your fuel pressure regulator is bad. hit me back.

Posted on Jan 02, 2010

Testimonial: "fuel pump regulator it keeps on flooding"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 88 ford bronco full size 302 I put a new fuel pump and relay and it still don't start


are you getting spark at the plugs is this fuel injected or carbed try spraying gas in to it to prime it is the coil working did you check the fuse

Feb 21, 2015 | Ford Cars & Trucks

2 Answers

I have a 88' bronco its not getting fuel as long


Hello! lets first make sure the Inertia cut-off switch isn't tripped...See location diagram below...Guru...saailer



2_12_2012_9_31_23_pm.gif

Feb 12, 2012 | 1988 Ford Bronco

2 Answers

I have a 1992 Ford Bronco wih a 5.0. Truck came to me with a no start condition. I checked fuel rail pressure and found i had low fuel pressure. I changed the fuel pressure regulator and now have...


Im assuming the fuel pump is working and inertia switch, fuel filter, and fuel pump relay are good, check the ignition switch, if its worn/broke and not making good enough contact.

Mar 30, 2011 | 1992 Ford Bronco

1 Answer

I am getting very confused. On my 88 Bronco II i have replaced a number of things ie; computer, MAP sensor, both fuel pumps, fuel filter, fuel pressure regulator, all 6 injectors, cap , rotor, plugs ,...


does it sound like it cranks funny if so r u sure that it hasn't jumped time maybe not but if u have to spray starting fluid in it t get it to run then then either the injectors aren't opening (obviously ) lol

when u put the distributor in r u sure u have it in time and if u r sure u did then have u got someone to crank it while u turn the distributor a little from left to right and see if it will start

also check all ur grounds under the hood and make sure they r all intact especially the grounds going to the neg battery terminal

Jan 24, 2011 | 1988 Ford Bronco II

1 Answer

I have a Ford BroncoII 88 2,9 V6, changed 2 fuel pumps but still have problems starting when motor is cold, looks like not enough gas is coming trough, I have to accelerate a little and then motor is...


It may be equipped with a cold start injector. This injector spray extra fuel when the motor is cold to allow normal startup. I'm not too familiar with this vehicle but I had a similar problem on an 88 camaro and it turned out to be a faulty cold start injector.

Jan 15, 2011 | 1988 Ford Bronco II

1 Answer

No power to fuel pump


check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down injectors and fuel pump, if you are looking for the shut off switch to reset the relay, it is on the passagers side floor board under the dash, gas two wires, orange and pink, I don't remember the color of the stripes, I removed this switch and wired them together without a problem

Mar 27, 2010 | 1988 Ford Bronco II

1 Answer

Bronco fuel pump 89 to 88


i dont think they will. you would be better off finding the right one versus trying to make something work and then you might have even more problems to deal with

Jan 05, 2009 | 1989 Ford Bronco

2 Answers

Bronco 2


possibly a fuel blockage. Is it getting fuel up the top?

May 23, 2008 | 1989 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...