Question about Scion xB
Replace power steering belt 2006 scion xb
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: scion xb wont start
Hi.. Yes i fix my problem by disconecting the neutral suitch and reconecting it ,,they get dirty with time and dont make contact ,Is a good idea to disconect and clean as many contacts as you can and put some special grease on them to prevent other problems ...
Posted on Jul 29, 2008
1st ...that should be covered under 6 year 50k power train warranty from the dealer.
But if your over....you need to unbolt the right side motor mount (on the water pump side) and lift the engine some with a floor jack to get clearance,
Posted on Apr 11, 2009
There is a little cubby by the drivers left knee pull the cubby out a fuse pannel is located behind that cubby, change the "ACC" fuse which should be a 15 amp fuse
Posted on Apr 25, 2009
I just looked at my '04 xB. It looks very straight forward.
loosen the bolt that holds the alternator to the bracket.
carefully slide the alt to the bottom. (Also be aware of the plug and wires on the alt.They should never hold the weight of the alternator. You dont want them breaking prematurely.)
Pull the belt off, remove the belt from the crank shaft pulley.
Do the reverse, and you will have replaced the belt.
Make sure to check the belt in about a week or so.
New belts will stretch over time. Make sure you keep the tension tight enough to work correctly, but not so tight that the alernator shaft is warped.
I usually place the new belt on both pulleys and give a good "medium" pull on the alt while tightening. Find the middle of the belt and squeeze them together, depending on the type and length of the belt, there should be about 1/4" of flex on both sides.
Posted on Jun 29, 2009
I had the same problem. The cause (at least on my box) was a bad charcoal canister and the valve going to it. These go bad on the boxes fairly often. If you "top off" your tank, the overflow spills down into the charcoal canister and it will not function properly. IE: Engine, Trac, and VSC lights come on. It doesnt hurt it to drive with a bad canister, but you will lose mileage and that light will be staring you in the face every time you drive. The parts are pricey, dealer only parts and the canister is about $400. I found a totalled xb with a good canister and nabbed it for $40.....solved my problem. Hope this helps!
Posted on Jan 15, 2010
Tips for a great answer:
Jan 20, 2016 | Toyota Cars & Trucks
Jan 05, 2016 | 2006 Scion xB
Aug 13, 2014 | Cars & Trucks
Aug 18, 2013 | 2006 Scion xB
Aug 01, 2012 | 2005 Scion xB
Feb 26, 2011 | 2006 Scion xB
Jul 19, 2010 | 2006 Scion xB
Nov 30, 2009 | 2006 Scion xB
Feb 21, 2009 | 2006 Scion xB
Feb 18, 2009 | 2006 Scion xB
24 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: