Question about 2007 Chevrolet Malibu Maxx LTZ Hatchback

Open Question

Where is the iat sensor located on a 2007 chevy malibu

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
JShreader
  • 50 Answers

SOURCE: locating the iat sensor on a chevy tahoe 2008

Yes. That is exactly it. The Air Intake Temp Sensor is built into the Mass Air Flow Sensor on the Air Filter Box. Below is a picture...
29f8daa.jpg
6d7178d.jpg
I personally have not connected one of these Chips to a Tahoe...What I can provide you with, is the Connector Diagram so you know exactly what Wires you need to Splice in to. See below...
ce630fe.jpg
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesisitate to ask...Thanks again, JShreader.

Posted on Mar 31, 2009

Ad
  • 14036 Answers

SOURCE: where is the crank sensor located on a chevy

the 3.1 engines crank shaft sensor is located behind crank shaft pulley.the 2.4 engine crank sensor is next to oil filter.

Posted on Dec 20, 2009

  • 3640 Answers

SOURCE: dtc code p0121 and p2135 2007 chevy malibu

both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.

Posted on Feb 20, 2010

roniecon
  • 6927 Answers

SOURCE: were is the crankshaft position sensor located on 2001 chevy mali

It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.

Posted on Mar 22, 2010

ZJLimited
  • 17970 Answers

SOURCE: where is the iat sensor located on a 1999 chevy cavalier 4cyl

The Intake Air Temperature (IAT) sensor determines the air temperature inside the intake manifold. Resistance changes in response to the ambient air temperature. The sensor has a negative temperature coefficient. As the temperature of the sensor rises the resistance across the sensor decreases. This provides a signal to the PCM indicating the temperature of the incoming air charge. This sensor helps the PCM to determine spark timing and air/fuel ratio. Information from this sensor is added to the pressure sensor information to calculate the air mass being sent to the cylinders. The IAT is a two wire sensor, a 5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature.

a8b6fbb.jpg

Fig. 1: The IAT sensor is located in the air cleaner outlet tube-2.2L engine and 2.4L engine

Hope helped.

Posted on Apr 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 chevy malibu has p1404 & p1133 codes


P1133 HO2S Insufficient Switching Sensor 1
P1404 IAT - B Circuit Malfunction/ Exhaust Gas Recirculation Closed Position Performance
_____________
supervag k can

Dec 07, 2012 | 1999 Chevrolet Malibu

1 Answer

Engine diagram for the iat sensor location for 1995 3.4 monte carlo z34


For its exact location on your vehicle,click the link below:----
Chevy Monte Carlo IAT Location http://technoanswers.blogspot.com/2012/11/chevy-monte-carlo-iat-location.html

--------
These will help.
Thanks.

Nov 22, 2012 | Cars & Trucks

1 Answer

Where is po311 intake sensor in a 2001 chevy malibu


po311 is cylinder 11 is misfiring. so you must have the wrong code. are you talking about the intake air tempurature sensor, IAT. if so it is located in big hose from air cleaner, the first sensor in hose. po113 is this sensor.

May 27, 2010 | 2001 Chevrolet Malibu

1 Answer

My check engine light is on and I had it checked at


the iat sensor(intake air sensor) it is in big hose from air cleaner and has a 2 wire plug on it.iat sensor monitors tempurature of air entering engine. the pcm uses this info, to balance air and fuel mixture. if bad it can cause; poor idle when cold, stumble on cold excelleration, and surging when engine is warm. I replaced the iat on my malibu and it was less then 20.00, any auto parts store shold have this, I know advance auto does. the sensor just pulls out from hose.

Apr 19, 2010 | 2000 Chevrolet Malibu

1 Answer

Where is the iat sensor located on a 1999 chevy cavalier 4cyl


The Intake Air Temperature (IAT) sensor determines the air temperature inside the intake manifold. Resistance changes in response to the ambient air temperature. The sensor has a negative temperature coefficient. As the temperature of the sensor rises the resistance across the sensor decreases. This provides a signal to the PCM indicating the temperature of the incoming air charge. This sensor helps the PCM to determine spark timing and air/fuel ratio. Information from this sensor is added to the pressure sensor information to calculate the air mass being sent to the cylinders. The IAT is a two wire sensor, a 5-volt reference signal is sent to the sensor and the signal return is based upon the change in the measured resistance due to temperature.

a8b6fbb.jpg

Fig. 1: The IAT sensor is located in the air cleaner outlet tube-2.2L engine and 2.4L engine

Hope helped.

Apr 11, 2010 | 1999 Chevrolet Cavalier

1 Answer

Locate the IAT SENSOR ON A 2007 CHEVY SILVERADO 1500 4.8 LITER


most are located on the air duct between the air filter and throttle body

Mar 14, 2010 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

Find the themperature sensors in the radiator for chevy malibu ltz 2007. I need the respective diagram. thanks.


heres a picture diagram that shows the switch, this switch is located on the coolant surge tank, hope this helps,95a3698.gif

Mar 09, 2010 | 2007 Chevrolet Malibu SS Sedan New Cars

1 Answer

IAT sensor on 2001 chevy silvrado 2500hd 6.0 L need location


The iat looks like the mass air flow its a hard plastic cylinder that connects to the intake tube after the air cleaner

Sep 20, 2009 | 2003 Ford Ranger Regular Cab

2 Answers

Same


po113 is--IAT sensor curcuit high input, po403--egr curcuit flow malfunction. IAT is intake air tempurature curcuit, for egr take off and clean carbon build up from inside of engine to egr valve.

Jun 06, 2009 | 1999 Chevrolet Malibu

1 Answer

2007 gmc sierra 2500 IAT sensor


Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.

May 18, 2008 | 2004 GMC Sierra 2500

Not finding what you are looking for?
2007 Chevrolet Malibu Maxx LTZ Hatchback Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...