Question about Mercedes-Benz ML350

1 Answer

Windshield washer fluid reservoir - MB ML 350

The windshield washer fluid reservoir or the tubing has a leak somewhere in the system. I am looking for any suggestions that would help me repair or replace. Thanks

Posted by on

  • Anonymous Mar 18, 2014

    need to refill my washer fulid

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Right where the lines connect to reservoir, has little black seals that leak. I recommend removing reservoir, empty it out, then use RTV silicone and place it between seals and reservoir. Let it dry for FULL day. than reinstall.

Posted on Jun 23, 2009

  • M. Alexandre Arraes Aug 31, 2013

    Can you explain how to remove it? What tools will I need and what steps should I follow. Thanks.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

7 Answers

How do I add wiper fluid to my car?


Hello. Usually when you raise your hood look to the left or over to the passenger side against the side wall there will be a blue cap covering the washer fluid tank remove it fill the the tank and snap the lid back into place.

Nov 13, 2015 | Honda CRV Cars & Trucks

1 Answer

How do you replace the windshield washer pump on 2008 ford focus, wipers work but no spray comes out


The hose could be clogged ! Do you know where you add the washer fluid ? Somewhere on the bottom of that plastic bottle is the washer pump .
Removal and Installation
> WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on label of washer solution container. Failure to follow these instructions may result in personal injury.
> CAUTION: When replacing the windshield washer pump be careful not to damage the rubber grommet.
> CAUTION: Do not operate the windshield washer pump before filling the reservoir. Failure to do so could result in premature pump failure.
  1. NOTE: When installing the reservoir, the filler neck must be lubricated using a water-based lubricant.
    Remove the bolt and the windshield washer reservoir filler neck.
  1. Remove the RH fender splash shield. For additional information, refer to Section 501-02 .
  1. Remove the foam filler and remove the retainer.
  1. Remove the 2 screws and the accessory drive splash shield.
    • To install, tighten to 5 Nm (44 lb-in).
  1. Remove the nut, 2 bolts and position the A/C accumulator aside.
    • To install, tighten to 9 Nm (80 lb-in).
  1. Unclip the A/C lines from the inner fender well.
  1. Drill out the rivet and remove the bracket.
  1. Remove the 2 bolts, slide the windshield washer reservoir assembly forward to release it, and position the washer reservoir aside.
    • Install the upper bolt followed by the lower bolt, and tighten to 5 Nm (44 lb-in).
  1. Disconnect the windshield washer tube assembly from the pump and release the windshield washer tube assembly from the washer reservoir.
  1. Disconnect the electrical connector from the windshield washer pump.
  1. Release the wiring harness from the reservoir, and remove the washer reservoir.
  1. To install, reverse the removal procedure.

Apr 07, 2015 | Ford Cars & Trucks

1 Answer

Where is the rear windshield washer reservoir on my 2006 Subaru forester


Hello, The washer reservoir for the rear is the same as the one for the front. It has two small fluid pumps on the bottom of the reservoir, one for the front and one for the rear. If your rear washer isn't spraying, I would suspect there is a clog somewhere in the wash fluid tube leading back to the nozzle. If you have an air supply with a small tipped air blower, you can usually put a small amount of air through the line to see if it clears. I would advise to gain access to the rear washer tube and disconnect it and introduce the air at that location. Just figured I'd add that bit of diagnosis in case that was your problem. Hope this info helps!

Mar 09, 2015 | 2006 Subaru Forester

1 Answer

My windshield washer reservoir won't hold washer fluid.


The seam on the windshield fluid container is broken and leaking like crazy.

Jun 10, 2017 | 2001 Oldsmobile Intrigue

1 Answer

WASHER FLUID leak


windshield washer reservoir has a crack in it or look for leaking washer reservoir hose leaking fluid.

Dec 06, 2011 | 2002 Audi A6

1 Answer

Where can i buy a window washer resavoir for my 3.2 jaguar 1996 xj6


WINDSHIELD WASHER FLUID RESERVOIR
Part #: JLM12455 RESERVOIR, WINDSHIELD WASHER FLUID, FITS 1995-1997 XJ6. This is the large lower reservoir the top filler tube will need to be removed from your old reservoir ITS ABOUT 155.00

Aug 10, 2011 | 1996 Jaguar Xj Series

2 Answers

The windshield washer for both the front and back doesn't dispense fluid. The pump motor seems to be working. I tried tracing the line to see if it had become disconnected, but i couldn't follow it all the...


try and fill up the washer bottle with water for test and use it. if you hear the pump work keep using it till you see where fluid is leaking out. my guess is a hose is broken and all the fluid is leaking out

Dec 16, 2010 | Jeep Liberty Cars & Trucks

1 Answer

Windshield wiper fluid reservoir goes dry


After you pour the stuff in watch where it comes out. It is buried in the fender ...drivers side. Wheel well shield is removeable.

Oct 27, 2009 | 2006 Honda CR-V

1 Answer

Windshield washer fluid will not pump


the windshield washer pump might be bad. It should be located somewhere on the reservoir

Nov 25, 2008 | 1997 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,080 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

79186 Answers

Joseph Prosser

Level 3 Expert

772 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...