Question about Toyota Camry

Open Question

2000 toyota camry 3.0L crank no start . Fuel but no spark

Change crank and cam sensor want to start but spark plugs wet

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 1195 toyota camry v6 3000 four cam

http://wiki.answers.com/Q/How_do_you_change_spark_plugs_in_a_1995_V6_Toyota_Camry

Posted on Aug 16, 2008

  • 11 Answers

SOURCE: 1990 Toyota Camry just stopped running has no spark but has fuel.

check the main fuses under the hood to see if any are blown

Posted on Jul 23, 2009

GARYca
  • 672 Answers

SOURCE: No spark, 1988 Toyota Camry 3SFE 4cyl, 5 speed.

there is no crank sensor on this vehicles 2.0L. If you have power to the coil, new coil, cap and rotor try this if not done yet>>>Unplug coil power first....Try pulling off the distributor cap, and make sure the rotor is spinning with the cam...If this fails to spin, inspect the entire distributor assembly. If it passes, Inspect all the power circuit and wiring to the dist assembly, if ok possible ecu. i recommend having a mechanic check it out!! Hopefully this helps...please rate...thanks

Posted on Aug 11, 2009

  • 603 Answers

SOURCE: crank no start ,got fuel got spark, when trying to

You pinched the fuel line????
If you crank for too long to start the car, the engine will "flood", this is why the plug was wet. It had too much gas and wouldn't start.
Pull out ALL plugs and dry them off.
Install them.
HOLD your gas pedal to the floor and crank.
This will stop gas from entering the engine.
you need to get that extra gas out beofre it will start.
If you have so much gas in there you can do damage to your engine!!
Now after a few crnaking attempts with your foot to the floor, take your foot of the gas pedal and try to start it again.
But remember if it doesn't start in 3 tries, you need to do the pedal to the floor once or twice to remove the excess gas.
When you crank the car to start it sprays gas into the engine, even if it won't start. So it very easy to "flood" the engine, and then you'll have a hard time to get it going!

Posted on Jan 08, 2010

  • 100 Answers

SOURCE: i have an 02 dodge ram 1500 4x4 it started

You probably have a bad ignition coil. Which engine is in this truck? 3.7, 4.7, 5.7 or hemi

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Toyota camry 1995 engine cranks but no start


First crankshaft sensor, also called engine speed sensor, next cam shaft sensor.

Apr 18, 2014 | 1995 Toyota Camry

1 Answer

2000 mercury cougar will not start


If it is getting spark I will assume the timing belt is working.
You say the fuel pump is good, so what is the fuel pressure at the rail ?
Are the spark plugs wet or dry ? Can you get it to try to start by using starting fluid ?
You may have to get someone to check the computer for trouble codes which requires a scanner or code reader.

Apr 06, 2013 | 2000 Mercury Cougar

1 Answer

I have a Toyota camry 2000 L.E it cranks but wont start i replace the Spark plugs and wires fuel pump fuel filter the Starter works i check for sparks the fuel line is good timing belt is good what can it...


is the engine check light on
do you have enough pressure at the fuel rail is the pump running when u swing the engine
is the MAP sensor and crank angle sensor faulty

Mar 24, 2013 | Cars & Trucks

1 Answer

1998 Toyota Camry will not start


if the plugs are wet with fuel that means not spark. it can be a few things. crank position sensor, ignition control module or the cam position sensor

Dec 29, 2012 | Cars & Trucks

1 Answer

2000 Toyota Camry did not start on first try - yellow symbol


Hard to say what it is without testing so I 'm gonna give you a list of things you or a repair shop can check out:
SYMPTOM :NO CRANK
Battery,battery cables,ignition switch, neutral safety switch, starter relay, starter.
SYMPTOM: CRANK NO START
MAKE SURE TIMING BELT DIDN'T BREAK OR SKIP A TOOTH,STARTER current draw test , coil, coil pack, ignition module( only if no spark at the plug wires) fuel pump relay, fuel pump, injector module and drives, fuel pressure regulator.

This year Camry is a good year. Very little problems except annoying EVAP system. TIMING BELT SHOULD BE DONE EVERY 60K . ALONG WITH CAM, CRANK, OIL PUMP SEALS AND WATER PUMP.
I recommend taking your car to Sears Auto Center
they are pretty good with this kind of work.

May 11, 2010 | 2000 Toyota Camry

1 Answer

2000 toyota camry is flooded with fuel and will not start. spark plugs all fire, but cranking the engine with plugs out will push raw fuel out of the cylinders


Saw this happen once Somone had attached the fuel feed hose to the brake booster pipe on the manifold Not saying that your problem but check all pipes to manifold

Jan 27, 2010 | 2000 Toyota Camry

1 Answer

No spark, 1988 Toyota Camry 3SFE 4cyl, 5 speed.


there is no crank sensor on this vehicles 2.0L. If you have power to the coil, new coil, cap and rotor try this if not done yet>>>Unplug coil power first....Try pulling off the distributor cap, and make sure the rotor is spinning with the cam...If this fails to spin, inspect the entire distributor assembly. If it passes, Inspect all the power circuit and wiring to the dist assembly, if ok possible ecu. i recommend having a mechanic check it out!! Hopefully this helps...please rate...thanks

Aug 11, 2009 | 1988 Toyota Camry

1 Answer

1994 Toyota Camry Won't start.


you should check 3 things. AIr, Fuel, and "spark"
your cars could have many problems. Ignition module, fuel injectors, Mass Airflow Sensor.
You should check into all of these 3 things.
a crank-no start could be many things.
it could even be a cam positions sensors resistance going up when the engine heats up. Cracnk- no start means testing. n like i said
The motor is getting Air, There is Fuel being put into the cylinders, and the Spark plugs are firing.

Mar 17, 2009 | 1994 Toyota Camry

4 Answers

Won't start


Is this a 4 cyl. or a 6 ?
It's possable the EGR valve is stuck wide open also causing it to dump fuel. Are the plugs wet after cranking for a while?
Talk to ya soon, Dan

May 25, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...