Question about 2008 Toyota Prius Hybrid
Key will not unlock doors with button, I pressed the power button and it turned orange. Then the check engine light came on. I just changed the oil, my lights were off, and the engine light was not on when I drove it this morning. Only half of the doors were locked when I came out to my car, which leads me to believe it is the key itself. Help!
Try changing the batteris in the key fob as may not be sending a strong enough/complete signal
Posted on May 15, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Check engine and VSC lights on
I talked to you on the live chat, and I think that you may have missed the end of my typing...
What I went on to say is that more often than not, on the 02 4Runners, the Check and VSC lights in tandem look mainly after the emission system, and, since you stated no issues during the road test, I would guess that it is a fuel issue (too full/loose gas cap). But, if you can get the vehicle scanned, I will be very glad to provide you with more and better info if you provide me with the DTC codes. That would require your guy or an autozone hookup to a scan tool. I hope my clarification helps; and the graciouness of a FIxYa rating for this question would be greatly appreciated
Posted on Nov 06, 2008
SOURCE: 99 Sienna pwr door lock failure
Sounds electrical/relay to me if you cannot lock by pressing the lock button on the door itself. Driver and passenger acting the same AND the remote all the same result point to only one culprit.
Let me know how it goes and best of luck!
Posted on Nov 21, 2008
have you tried the spare key..usually the red light comes on even when the battery for the remote is low.you can tell when the battery is low as you have to get nearer the car to unlock it.....
Posted on Mar 06, 2010
If your car has an alarm with a separate remote, it is a separate system and it is probably self-arming. When you lock the doors with the key central lock, the alarm gets armed by the RAV4 being OFF and the door locking action. When you unlock the doors with the key, the alarm is still armed because the key is not comunicating with the alarm just the cars factory keyless system.
Posted on Apr 10, 2010
Tips for a great answer:
Feb 18, 2014 | Peugeot 206 Cars & Trucks
Jul 10, 2008 | 1996 Subaru Legacy
Dec 01, 2011 | 1998 Jeep Cherokee
Jul 05, 2011 | 1999 BMW 323 Series
Mar 04, 2011 | 2003 BMW 330
Battery Constant 12v+ Positive Wire (+): Black/Yellow
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Blue/Red
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire (+): Red
Ignition Positive Wire Location: Ignition Switch Harness
Accessory Positive Wire (+): Red/Yellow
Accessory Positive Wire Location: Ignition Switch Harness
Parking Light Positive Wire (+): Red
Parking Light Positive Wire Location: Low In Drivers Kick Panel
Power Door Lock Negative Wire (-): Add Actuator. This vehicle uses a central door locking system. When connecting a keyless entry, you will need to add a door lock actuator and some units will also require (2) extra relays.
Power Door Lock Negative Wire Location: To Drivers Door Only
Power Door Unlock Negative Wire (-): Add Actuator. This vehicle uses a central door locking system. When connecting a keyless entry, you will need to add a door lock actuator and some units will also require (2) extra relays.
Power Door Unlock Negative Wire Location: To Drivers Door Only
Door Trigger Negative Wire (-): Red/White
Door Trigger Negative Wire Location: In Black Plug, Above Hood Release
Domelight Supervision Wire: Use Door Trigger, Requires Relay
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Red/Green
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Black/Blue
Tachometer Wire Negative Wire Location: At ECM, Under Drivers Side Dash
Brake Light Positive Wire (+): White/Black
Brake Light Positive Wire Location: At Switch Above Brake Pedal
CODE ALARM SYSTEM
Lock: Left button will lock all doors. Double chirp indicates locked.
Unlock: Right button will unlock driver's door only. Hold unlock button app 6 seconds, it will unlock all doors including rear gate. Single chirp indicated unlock.
If the car chirps or lights flash 4x the alarm was triggered.
Panic. Press both buttons to activate emergency honk and flashing lights.
Valet mode: With optional alarm onlyPress the red alarm button on the left of the steering wheel. The light will quickly double flash. To re-set back to normal mode, press the red alarm light button again
Battery failed and lights flashing?
Parking lights will flash when the vehicle's battery is disconnected and reconnected.
To stop lights from flashing, either:
Press remote transmitter "UNLOCK" button once OR turn the ignition switch to the "ON" position and press programming button for one second (see below).
The vehicle interior (courtesy) light and door open warning light (DOOR AJAR indicator) will then illuminate for 60 seconds when the ignition is turned off, or until the doors are locked with the remote transmitter. Yes, the dashboard instrument panel lights will flash when the parking lights flash.
Programming or Overriding the Alarm when you have lost the remote
Open driver's door.
Turn ignition key to 'On'
Press and *hold programming button* in (see diagram, button under dashboard)
After 15 seconds the the door locks will cycle 3 times. Do not release Programming button.
Press lock (left) button the remotes to be programmed. The door locks will cycle one time. Exit programming mode by releasing Programming button under dashboard and turning key to off.
Code Alarm Programming Button is under dashboard on the kick panel by the driver's left knee, left of the steering column. If you can't find it, it might still be tucked up in the wiring harness higher up in that same general area. The botton is recessed in a plastic ring (see diagram).
This button must be pressed while programming remotes or if the battery was disconnected and the lights are flashing.
Jan 05, 2011 | Subaru Impreza Cars & Trucks
Apr 18, 2010 | 2004 Volkswagen Passat
Aug 21, 2009 | 1999 Dodge Durango
Apr 06, 2009 | 2007 Honda Pilot
Oct 05, 2008 | 2001 Volvo S60
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: