Question about Cars & Trucks
If you can't hear the sound of the motor when you push the button it's probably the motor went out. If you hear the motor then it's probably not on track or it wore out and you'll need to replace the assembly.
Posted on Jun 15, 2014
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
1. Close all vehicle doors.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold
down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock
the doors automatically.
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
the door locks and unlocks.
This step may take up to 30 seconds.
11. Repeat step 10 NOW for each additional transmitter (including any existing
12. Turn the ignition switch to the ON position in order to exit the transmitter programming
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
Posted on May 27, 2009
It sounds like it just needs to be reinitialized. Turn your key to the on position with motor off and hold the up/full vent button down for at least 30 seconds or until your sunroof either clicks or goes to the full vent position. That should fix your problem.
Posted on Jun 25, 2009
Fuel filter. Timing/timing chain. Idle air control valve. Idle sensor. Vacuum leak. Probably one of the above, but the filter is cheapest place to start. Change your air filter too, if you haven't for a while.
Posted on Sep 12, 2009
Testimonial: "Great thanks so much! This will be a place to start, more than chevy dealerships have given me! Appreciate your time :) Thanks again!"
You will need to remove the door panel and check that all the linkage is in the proper place and snugged down. The gears from the motor to the window mechanism may be stripped or not making proper contact. The motor may also be bad as it takes more power to roll the window up than down. Please rate this answer, thanks.
Posted on Feb 05, 2011
Tips for a great answer:
Jan 16, 2016 | 2002 Chevrolet Tahoe
Jun 10, 2015 | 2002 Chevrolet Chevrolet Tahoe
May 14, 2014 | Cars & Trucks
May 22, 2012 | 2002 Chevrolet Tahoe
Jun 30, 2011 | 2006 Chevrolet Tahoe
Jun 18, 2010 | 1995 Chevrolet Tahoe
Oct 09, 2009 | 2002 Chevrolet Tahoe
Jul 01, 2009 | 2002 Chevrolet Tahoe
Oct 16, 2008 | 2005 Chevrolet Tahoe
May 22, 2018 | Nissan Cars & Trucks
84 people viewed this question
Usually answered in minutes!