Question about Cars & Trucks

1 Answer

Blower motor stays on with key out replaced resister but no change. any ideas?

Posted by on

1 Answer

If the blower stays on medium or high, or stays on for more than five minutes, the blower relay is stuck. Replace the blower relay. (VERY common problem on these.) If the blower is low speed, and it only stays on for a minute or two, it is your automatic cabin air system (feature).

Posted on Jun 11, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 833 Answers

SOURCE: 2001 kia sportage blower motor resister

Rule of thumb...unless you get a better answer:  look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit.  The resistor pack is always air cooled by the fan.

Posted on Nov 11, 2008

emissionwiz
  • 75822 Answers

SOURCE: Blower motor stays on high, even with key out

the blower motor speed control module is defective, replace it.

Posted on Dec 24, 2008

  • 2 Answers

SOURCE: air conditioner blower motor resister on dodge grand caravan

in my 2004 grand caravan it's behind the glove box and left of the blower motor. disconnect the wires first then remove the 2 screws to pull out the resistor unit. First make sure you have removed the negative of your batterie. I had the same pm that prevented the blower motor to operate in any speed. I hope this will help

Posted on Dec 25, 2008

  • 7353 Answers

SOURCE: Blower motor on 96 Isuzu Rodeo does not blow on

if fuses are good, check for power at blower motor, when truck is running and a/c on. the resistor and the switch provide ground, so the blue/white wire should have power, and the blue/black wire should have NO power, if it does have power, then most likely the resistor is bad. if it has no power and the motor doesnt run, the motor is bad.

Posted on Oct 20, 2009

Testimonial: "I will give that a try.. and post the results.."

  • 401 Answers

SOURCE: my blower motor stays on after key is off and door is open

hi for the blower motor staying on replace the resistor
check the connector make sure it is not corroded or melted
should have nothing to do with the remote start
this is an after market remote start
then the module could be feeding the blower motor
i have seen the after market modules do some strange things
hope this helps

Posted on Nov 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Buick park ave the climate control lights stays on when the key turn off


Is the blower motor staying on too? If so, the blower resister is bad...this is located on the firewall...

Aug 14, 2015 | Buick Cars & Trucks

1 Answer

How to change blower motor resister 2010 jeep compass


its under your glove box it may be your whole blower motor that has to be replaced. it also might be right next to your blower motor. you just need to remove the bolts and disconnect the wires. if they give you new wires i would replace them too. they tend to get a high resistance so that the blower motor doesnt get enough power

Jun 17, 2015 | 2010 Jeep Compass

2 Answers

Started the car and the A/C motor speed went to high and stayes there.


the blower motor resister is bad. go to a mechianic and get it replaced

Feb 19, 2015 | 2007 Honda Pilot EX-L

1 Answer

Heater fan not working on my 2003 cavalier


From your symptoms I would suggest, inspect the Climate Control and the Blower Motor Resister. Locate and remove the resister and test. You are looking for power at the plug (going to the resister). One wire will always be hot (with the ignition key on). The other four wires are ground wires that through the resister, changes the blowers speed. Connect a test-light to 12volts positive, test that the test-light is working, and then start testing for ground. Unplug the resister and test at the plug. With the ignition key on, test each wire. Each wire should light up your test-light depending on the position of the speed control knob. If it passes then plug the resister back in and probe at the blower motor. The blower motor needs both ground and power to run. Find out which is missing and write back. Good luck.

Apr 26, 2014 | 2003 Chevrolet Cavalier

2 Answers

I have a 1993 sel, had problems with ac unit changed the eveparotor. The ac now works but the fan will only operate on slow speed. As in on low there is nothing when u set the fan speed to max then some...


Yes,could be your blower resistor is bad,it's right next to the blower motor,it controls the blower motor speed,easy to replace. Duralast Blower Motor Resistor Just took a guess at the model type since you didn't state,wow,high dollar price,guess it comes with a Mercedes,paid about 18 bucks for mine on my 85 Nissan.

Aug 11, 2017 | Cars & Trucks

1 Answer

1988 Celebrity blower motor inop


check the resister is a couple inches away from the blower motor a bout 5 -6 wires

Apr 13, 2012 | 1988 Chevrolet Celebrity

1 Answer

Replace blower motor 1998 plymouth voyager


it is located behind and below the glove box,you might want to remove the glove box assembly to see it easier,
there are four screws holding a blower motor cover you to take off first,now remove the screws holding the blower motor up,disconnect the motor wires.
if your changing this because you think its bad,you should test the blower motor wires with a test light with the key on and blower switch turned on.if you have power in the wires,then it is bad.
but if you have no power in wires it could be blower motor resister,or switch.

Nov 28, 2009 | 1998 Plymouth Voyager

1 Answer

Heater motor problem!!!!


Hi my name ia Allen!

This is a tough one, because when something is still working its hard to penpoint the problem.

This can be a lot of things, one a blower motor resister, two blower motor relay could be going bad, three could be a wiring problem.

But here is the most common problem with that year. Under your hood on the left side as you are facing the vehicle, back on the firewall there is a connector that burns up on the blower resister.

Here is what I need you to do, turn the key on with the blower on high so you can here it, you need to wiggle that connector and listen for the blower motor to go of and on. If this happens, you will need a resister and wiring pigtail, because the wiring will have to be replaced and the resister will have to be replace, but we can get to that when we get there.

Let me know what you find, waiting for your reply.

Jan 01, 2009 | 1998 Dodge Caravan

2 Answers

Blower motor stays on high, even with key out


the blower motor speed control module is defective, replace it.

Dec 24, 2008 | 2002 Chevrolet Silverado

3 Answers

Heater switch only has hi speed


This was wrong with my 01 Stratus and it was the blower motor. Between the part and the labor to have it fixed, it was around $130.

Nov 26, 2008 | 2001 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...