Question about Cars & Trucks
Check with Toyota service manual but most CPU programs can be reset using a scanner tool.
Posted on Jun 15, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I've been resetting pajero's compasses but try to get to an area where you can do 360 degrees turns (empty car parks, ) press the reset button and make 2 complete 360 turns slowly and normally this should set the compass bearing.
Let us know how you get on. Cheers.
Posted on Oct 29, 2008
if you have just bought the car change the oil and the filters asap on the grounds that the oil and filters may have not been changed for quite a while also change air and fuel filters also and grease any steering and tail shaft joints check brake fluid and water levels also and for any leaks around brakes gearbox and differential then every 5000km change oil and every 10000 change filters and spark plugs start with 4liters of oil let settle check level and keep topping up until close to full mark fill oil slightly under than over too much oil will build up pressure and burst oil seals in motor the more expensive the oil the better the quality its a bit like scotch whiskey best of luck glenn.......
Posted on Nov 12, 2008
1. Hard time for your drive train (clutch, cv joint, tranny, diff gears) , power steering, brakes
2. Slow acceleration
3. possible fender damage
4. turning radius problem
5. increase body roll and instability
1. good ground clearance
2. softer ride
3. Enhanced off-road ability
tires your planning to buy can fit into your existing rims.
My personal opinion is for you to go for the bigger tires!
Posted on Dec 04, 2008
Refer to the diagram and torque bolts in sequence as shown in 3 passes. Bolt thread should be lightly oiled. Bolt holes clean of dirt.
1st pass : 39 N.m. (29ft lb)
Make a mark on the bolt with white-out/chalk or similar in the forward facing edge of the bolt.(see diagram)
2nd pass : turn bolt through 90 degrees
3rd pass : turn bolt through a further 90 degrees.
Using a mark on the bolt makes it easier to keep track of where in the sequence you are.
Posted on Dec 05, 2010
Tips for a great answer:
Feb 21, 2011 | 2008 Toyota Land Cruiser
Nov 02, 2010 | 2007 Toyota Land Cruiser
Sep 07, 2010 | 2001 Toyota Land Cruiser
Apr 11, 2010 | 2004 Toyota Land Cruiser
Aug 29, 2009 | 2004 Toyota Land Cruiser
Oct 28, 2008 | 2000 Toyota Land Cruiser
Sep 14, 2008 | 1996 Toyota Land Cruiser
Sep 09, 2008 | 2004 Toyota Land Cruiser
19 people viewed this question
Usually answered in minutes!