Question about 1999 Jeep Wrangler

1 Answer

1999 jeep wrangler guages went crazy

Our 1999 jeep wrangler 4 cylinder 5 speed 4 x 4 started having the engine light come on and off and then the amp guage began saying it was over charging while the gas guage began rising as well as if we had a full tank when we knew we only had about a 1/4 tank of gas. Could this be the computer going bad or is it the instrument cluster? We had the alternator checked and it is fine.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Put a volt meter on the battery itself and take a reading when it is doing that. If charge rate is over 14v the alternator may be working but the output is not being cut down to "useful voltage" You may have a regulator problem.

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1999 jeepn wrangler 4 cyl 5 speed rough idle


rough idle is from faulty injectors or maf/vaf sensors or vacuum leaks
run the fault codes to determine the fault area

Jun 09, 2014 | 1999 Jeep Wrangler

1 Answer

1994 jeep wrangler 6 cyl 5 spd no start


have u ck out the ignition switch [not the key & tumblers],, or the neutral safety switch to see if u have power ,,also seen broken wire at solenoid on starter too,,hope it helped,,

Apr 05, 2010 | 1994 Jeep Wrangler

1 Answer

1997 2.5L CRANK NO START


clog in your fuel line or you need to change your fuel filter.

Jul 09, 2009 | 1997 Jeep Wrangler

2 Answers

Where can i find the transmission model number for my 95 jeep grandcherokee lerado the transmission is not original it has been replaced with a diferent one 2 times so just need to know where to find the...


These pages cover the transmissions used in Jeeps over the years. Transmissions are arranged by the most recently introduced transmissions first.
Factory Transmissions 45RFE: The 45RFE four speed automatic transmission was used in 1999 Jeep Grand Cherokees with 4.7L engines. 46RE: The 46RE four speed automatic transmission was used in 1998 Jeep Grand Cherokees with 5.9L engines.
44RE: The 44RE four speed automatic transmission was used in 1996 to 1998 Jeep Grand Cherokee's with 5.2L engines.
42RE: The 42RE four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines.
46RH: The 46RH four speed automatic transmission was used in 1993 to 1995 Jeep Grand Cherokees with 5.2L engines.
32RH: The 32RH three speed automatic transmission was used in 1992 to 1995 Wrangler with 4.0L engine and it continues to be used in 1997+ Wrangler with 4.0L engine.
30RH: The 30RH three speed automatic transmission was used in 1992 to 1995 Wrangler & 1992 to 1996 Cherokee with 2.5L engine.
AW4: The AW4 four speed automatic transmission was used in 1987 to 1990 Jeep Cherokee (XJ), & Jeep Comanche with 2.5L & 4.0L engines. The AW4 was also used in 1987 through 1992 Jeep Comanche & 1991 through 1998 Jeep Cherokee & 1993 through 1993.5 Jeep Grand Cherokee with 4.0L engines.
AX-15: The AX-15 is a medium duty 5 speed manual transmission. It was introduced in mid 1989 in YJs with the 4.2L engine and XJs and MJs with this engine. The first year of the Grand Cherokee (ZJ), the AX-15 was rare option only with the 4.0L engine. The AX-15 is still used in TJs and XJs with the 4.0L engine.
AX-5: The AX-5 (and AX-4, the non-overdrive version) is a light duty 5 speed manual transmission. It was used in all Wranglers from 1987 equipped with the 2.5L I4 engine. It was also used in Cherokees (XJ) and Comanches (MJ) with the 2.8L V6 and 2.5L I4.
BA10/5: The BA 10/5 is a light duty 5 speed manual transmission. It was used in all 4.2L equipped Wranglers (YJ) from 1987 to mid-1989, and all 4.0L Cherokees (XJ) and Comanches (MJ) for the same years.
T-5: The T-5 is a light duty 5 speed transmission used in CJs from 1982 until 1986. It was also found in some 84-85 Cherokees (XJ).
TF727: The TF 727 is a heavy duty 3 speed automatic used in full sized Jeeps (SJs and J series pickups) from 1980-1983. From 1984-1992 the 727 was only used in these trucks with the AMC 360 V8.
999: The 999 is a medium duty 3 speed automatic used in CJs from 1980-1986. It was also used in 1984-1990 SJs and J pickups with the 4.2L engine, in the YJ from 1987-1991 with the 2.5L and 4.2L engine, and in the XJ and MJ through 1986.
904,909: The 904 and 909 are light duty 3 speed automatic used in CJs from 1980-1986 only with the I4 engine. It was also used during this time period with XJs and MJs with the I4 and V6 engine. The 909 is a 904 with a lock-up torque converter.
SR-4, T-4: The SR-4 and T-4 are light duty four speed manual transmissions used in CJs from 1980 until 1986.
T-176, T-177, T-178: The T-176, T-177, and T-178 are a medium duty four speed manual transmission used in Jeep CJs, SJs, and J pickups from 1980-1986.
T-150: The T-150 is the 3 speed manual transmission that was used in CJs from 1976 to 1979.
T-18: The T-18 is a heavy duty four speed used in Jeeps from 1971 until 1981. It was only used in the CJ from 1971-1979.
T-15: The T-15 was used only in V8 equipped CJs and Jeep trucks from 1972 to 1975.
TH400: The TH 400 is a heavy duty three speed automatic that was used in CJs with the BW 13-39 transfer case from 1976-1979. The TH 400 was also used in full sized Jeeps (SJs and J series pickups) from the late 60s until 1979.
T-14: he T-14 is a three speed transmission used with the "Dauntless" Buick V6 and AMC I6 from 1967 to 1975.
T-86: The T-86 is one of the three speeds used with the many CJs and Jeepster Commandos with the "Dauntless" Buick V6.
T-98: The T-98 varies only slightly from the T-18. It was used from the 50s until 1970 in different Jeeps.
T-90: The T-90 was the standard three speed for CJ and their military counterparts built from 1945 until 1971. It was also the standard transmission for Willys Wagons, Willys Pickups, FC trucks, and Jeepster/Commandos during this time period.
T-84: The T-84 is a light duty three speed used in MBs and GPWs during WWII

Good luck!!!

Jun 26, 2009 | 1995 Jeep Grand Cherokee

1 Answer

2000 jeep wrangler are sythetic lubes used in axils and trans


Hello grega1967, your Jeep Wrangler came from the factory with gear oil in the axles and manual transmission, but the transfer case uses transmission fluid. It is a NP231 and your axles are Dana 30 in the front and Dana 35 in the rear. They should have a 4.10 gear ratio due to you having a 2.5 liter 4 cylinder.

I hope this helps,

map6260

Mar 12, 2009 | 2000 Jeep Wrangler

2 Answers

Temp Guage Issue


could b thermostat....when car warmed up check hoses from radioator if not hot change thermostat

Dec 19, 2008 | 1988 Jeep Wrangler

1 Answer

1999 Jeep wrangler


if it's a top end tick from the engine. probably because oil ran down and it just needs to lubricate the head again.

Jul 08, 2008 | 1999 Jeep Wrangler

Not finding what you are looking for?
1999 Jeep Wrangler Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...