Question about 2006 Scion xA
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: IAT location on my Scion XA
Your intake air temperature sensor is part of the MAF (mass airflow sensor) and located right off the air filter housing in the large tube going to the throttle body.Its held on with 2 screws and has a 5 wire electrical plug going to it.
Posted on Apr 24, 2009
SOURCE: my scion xa is shaking when idle
It might just be that the air filter holder is somehow knocking on a part of the engine. When I turned the holder away from the engine and then retightened the strap that holds the filter housing properly, I lose the "knocking"/"shaking" noise!
Posted on Jul 09, 2009
Recommended oil is 5W30. You can go one step better by using a synthetic 5W30 oil. It may a bit more expensive than conventional oil but it will extend the life of your car's engine (as long as oil changes are done on a regular basis). Cheers!
Posted on Dec 17, 2009
Testimonial: "Great! Synthetic all the way "
SOURCE: How do you replace the
Remove the three bolts and two screws from the front of the lens. You will need a ten mm socket with and extension to reach the outside recessed bolt. The other two are located directly in front of the radiator area and are easily removed. You may need to remove one or two screws holding the rubber seal. That depends on your model and year. Head light unit now slides out forward and allows access to the bulb connections. You may have to wiggle it a bit to get it to move.
More detailed procedure as follows:--
Open up the hood. Get the Phillips Screw Driver in Hand. There is 4 Tabs with screws in them that hold the xA's Headlight on. Take the Screw driver and remove all the screws from those 4 points.
In order to remove the bottom screw, you will have to pull away the bumper Up then Out Slowly and Gently at these points.
Then push the bumper down, very little, just enough to stick the Phillips screw driver in and remove the 4th screw. It is alot easier than it sounds. After you remove the screws, gently pull out the headlight, remove the bulbs, (which in turn frees the headlight) and finish removing the headlight.
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
Posted on Aug 31, 2010
Tips for a great answer:
Sep 13, 2014 | 2006 Scion xA
Sep 02, 2014 | 2005 Scion xA
Jan 21, 2013 | 2005 Scion xA
Oct 26, 2010 | 2006 Scion xA
Jan 16, 2009 | 2006 Scion xA
86 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: