Hi I was replacement the transmission oil a week ago.I driving today appear the warning sigh.Could you give me advice please?
It most likely has a timer built into the computer. The reset is a braking sequence: most commonly is turn key to on position, pump gas three times. Key off, start car. I would advise to check you fluid levels and make sure you replaced the drain plug and everything else tightly.
If you replaced the fluid with the proper type (NOT ENGINE OIL) the transmission system has to be checked by someone equipped to determine the problem - before it fails.
SOURCE: 92 Honda Accord Flashing Oil Light
Are you positive it is the oil light .. If it is then it could be an issue with your oil pump...
SOURCE: How to reset Service 4wheel drive warning light on 2005 ChevTahoe
I have a 2005 Tahoe that recently had a similar problem. To resolve, I did the following.
This will cycle the fluid within your transfer case, and hopefully clean out the sensor. I did this, and my Service 4WD light went away after one day of normal driving. Hope this helps. Note: When I went into 4L the first go around, it had a hard time shifting due to non use. I changed between 4H and 4L a few times until it got smoother.
SOURCE: Oil light/warning sound on Jetta after changing oil pressure sending unit switch
my 95 vw jetta oil light is on and there is a beeping sound what might be wrong
85 views
Usually answered in minutes!
×