Question about Cars & Trucks

1 Answer

95 nis max, covert. Stick.ok car runs fine put new clutch in it. Now shifts smoothly then around 2k rpms, it starts back firing, like it wants to steal unless I switch to 2nd, then 3rd, and so on. helppppp!!!!!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,108 Answers

It's starving for fuel OR air.Replace the air filter first.If still does this,replace the fuel filter.Higher rpm calls for more fuel and air.

Posted on May 14, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 122 Answers

SOURCE: Shifting problem

TRY TO DRIVE IT SLOW TO NORMAL BUT DO THE MANUAL IF ALL THE GEAR WORK WITH OUT SLIPPING I WOULD SEE IF THERE A CABLE THAT GOES TO THE TRAND THAT WILL ADJEST THROTTLE PRESURE BY MAKING CABLE LONGER OR SHORTER . CABLLE IF IT WORKS DONT DEAT IT CAUSE ITS GETTING TIRED

Posted on Feb 16, 2013

  • 1 Answer

SOURCE: 2001 Saturn SL Manual Transmission stuck in 2nd Gear

I had this same problem with my 1998 SL2 after about 170,000 miles. There is a plastic bushing at the end of the shifter cable that holds the cable to the shifter - it probably broke. Remove the center console inside the car to access the bottom of the shifter. I checked my local Saturn dealer to find the replacement cables (come as a set) are more than $200. So I went to Lowes and bought a beam clamp and a large washer to hold the cable to the shifter. It has been working fine for more than 28,000 miles and cost less than $3

Posted on Sep 22, 2009

  • 1 Answer

SOURCE: 91 Mitsubishi Mighty Max stalls during acceleration

Try changing your fuel filter, like on all fuel injection and electronic ignition problems the shade tree has to use the process of elimination. This is one of the cheapest.

Posted on Apr 08, 2009

godspeed808
  • 125 Answers

SOURCE: 98 Civic Auto Trans Slippage

you need to replace clutch pack for that gear can be ordered seperately from parts store or dealer if you want to save money call peach street auto recycling at 1800-365-2341 for a warrantied used one! also might be time for change trans filter and fluid filter could be slightly clogged but I lean towards clutch pack I replace these alot on Hondas

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep YJ stalls while clutch is depressed


thrust bearings are bad and the flywheel is moving out of range of the crankshaft sensor, or the crankshaft sensor is sitting too close to the flywheel.

Mar 12, 2013 | 1998 Jeep Wrangler

1 Answer

95 volkswagen cabrio clutch problems?


Sounds like your clutch may need to be replaced

Jan 07, 2013 | 1995 Volkswagen Cabrio

1 Answer

Relaced transmission and now have a rattle sound comind from torque coverter area,noise gets louder when gas pedal is applied and noise goes away during shifting of transmission btu comes right back after...


your torque converter is rattling that is the clutch on the stator inside is worn out... You can stall test your torque converter ...Do this but follow correctly. put on parking brake..on the asphalt,,,, block all four wheels...push the gas to the floor for just 2 seconds...down one, two lift off gas pedal quickly..
when your doing this WATCH your RPMs they should reach to around 2200-2400 between the 2-4 rpm if not the Torque Converter is toast!!!! If your car passes the STAll test then when you tranny was put back on one of the fly wheel covers are rubbing....!!!.

May 17, 2010 | 2003 Lincoln Navigator

1 Answer

I have a 1983 Mitsubishi Starion. I recently purchased it from a neighbor who has let the car been sitting. The fuel hose that connects to the Throttle body has a pin size leak in it and squirts fuel out....


check air mass flow sensor, with this unit going bad it will make the car runs horrible. also make sure you getting proper fuel pressure with good working fuel regulator. If it has a tubo, check if the turbo charger still working and hook up especially down at the wast gate control vacuum line still hook up to the wast gate control.

Oct 04, 2009 | 1983 Mitsubishi Starion

1 Answer

Clucth not disengauging....


try this.you have 2 shifter cables.one is select cable the other is shift cable.first put the transmission selector lever in neutral.then move transmission shift lever to 4th gear.depress clutch to if necessary to shift.move the shift lever to the 4th gear position until contacts stop.then you turn the adjuster turn buckle so the shift cable eye aligns with the eye in the gear shift lever.when installing the cable eye. make sure the flange side of plastic bushing at the shift cable end is on the cotter pin side.the cables should be adjusted so the clearance between the shift lever and both stoppers are equal when the shift lever is moved to 3rd and 4th gear. move the shift lever to each position and check that the shifting is smooth.

Jul 12, 2009 | 1996 Mitsubishi Galant

1 Answer

With clutch pushed-in, RPMs start to go up to around 2000-2500


if it isnt the iac probably the pcv valve positive crankcase vent. it is on a vacuum line somewere under hood. or check the air cleaner, the hose with the small filter underneath the air filter. i take its fuel injected?

Feb 16, 2009 | 1987 Ford F 150

3 Answers

1995 nissan maxima bogging


so you hear any different sound from the exhaust?
sounds like a plugged cat.
paul

Sep 24, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...