Question about 2007 Volkswagen Beetle

1 Answer

Fuel pump pressure specs

Need engine running fuel presure spec for a 2007 Volkswagen Beetle with 2.5L engine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 641 Answers

Kindly check this specs.
2007VolkswagenNew Beetle

Posted on May 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ourhowse
  • 2007 Answers

SOURCE: 1976 vw 1600 need engine tq specs

1970 - 1979 Engine Torque Wrench settings LB FT Nm mkg Connecting rod nut 22 - 25 29.8 - 33.8 3.0 - 3.3 Crankcase screws M8 (halves) 14 19.0 2.0 Crankcase nuts M12 (halves) 18 24.4 2.5 Cylinder head nuts (M10) 23 31.2 3.2 Cylinder head nuts (M8) 18 24.4 2.5 Rocker shaft to Cylinder head nuts 14 - 18 19.0 - 24.4 2.0 - 2.5 Oil Pump to crankcase nut 14 19.0 2.0 Oil drain plug 25 33.8 3.5 Oil strainer cover nuts 5 6.7 0.7 Flywheel to crankcase bolt 253 343.0 35.0 Clutch to Flywheel bolt 18 24.4 2.5 Spark Plugs 25 33.8 3.5 Engine to Transmission nut 22 - 29 29.8 - 39.3 3.0 - 4.0 Converter to Drive plate bolt 81 109.8 2.5 Generator Pulley 40 - 47 54.2 - 63.7 5.5 - 6.5 Special nut for Fan (M12) 40 - 47 54.2 - 63.7 5.5 - 6.5 Crankshaft Pulley bolt 29 - 36 39.3 - 48.8 4.0 - 5.0

Posted on May 06, 2009

alicantecoli
  • 22156 Answers

SOURCE: diagrahm for 2006 volkswagen bettle fuel pump

its in the fuel tank,access under the baCK SEAT

Posted on Aug 22, 2009

  • 1757 Answers

SOURCE: need to get timing spec and locate timing marks

Click on the following free, direct Link. It has two sets of Diagrams including the Timing + Marks: Belt Diagrams for your 2001 Volkswagon Bettle 2.0L SOHC 4-Cylinder. The other set of Diagrams is for the 1.8L DOHC 4-Cylinder. Further it has Instructional and Directional Diagrams that will help you out.

Let me know if this helped....

http://www.2carpros.com/car_repair_information/year/2001/make/volkswagen/model/new_beetle/2001_volkswagen_new_beetle_timing_belt_diagram_marks.htm

Posted on Apr 22, 2010

brandon_m618
  • 63 Answers

SOURCE: 2001 vw 1.8 litre gas awv engine spec

Bore × stroke 81.00 mm × 86.40 mm 3.19 in × 3.4 in Cylinders s-4 SOHC Single overhead camshaft DOHC Double overhead camshaft OHV Overhead valves TS Two stroke SV Side valves

  • Sl
  • Sleeve valves
  • oise
  • Overhead inlet side exhaust
  • 5 valves per cylinder
    20 valves in total
    compression ratio
    9.30:1 fuel system
    MPFi Maximum power 150.1 PS (148.0 bhp) (110.4 kW)
    @ 5700 rpm Specific output 83.1 bhp/litre
    1.36 bhp/cu in Maximum torque 210.0 Nm (155 ft·lb) (21.4 kgm)
    @ 1750 rpm bmep 1481.7 kPa (214.9 psi) Specific torque 117.91 Nm/litre

    Posted on May 01, 2010

    alicantecoli
    • 22156 Answers

    SOURCE: What are the specs for front headlight for 2007

    yes you can do it yourself ,if access is limited then just take the headlight out

    Posted on Jul 28, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    What is the fuel presure specs on honda 1998 cr-v.


    With fuel pressure regulator vac line disconnected and pinched, engine running, 38--46 psi. Found that info in database.

    Apr 04, 2017 | 1998 Honda CR-V

    1 Answer

    How can I check the fuel presure in Toyota tacoma engine 2.4


    Sorry am not sure whether Tacoma engine is petrol or diesel, what age it is or what fuelling system but assuming it is a conventional petrol injection system, the fuel pressure test is just one of four tests carried out when a problem with fuel delivery is suspected and begins with fitting the appropriate adaptors to the fuel line and then fitting a pressure gauge.

    It is not just the correct fuel pressure(s) needed for satisfactory engine performance but also sufficient fuel volume.

    Before carrying out the tests is is usually necessary to fit a switch in place of the fuel pump relay so the pump can be started with an open line and the engine switched off. The amount of fuel delivered into an appropriate container in a set time is measured and compared with specs.

    The next test is the peak pressure test - a momentary test with a closed fuel line to test the mechanical strength of the pump and lines.

    The next test is the regulated pressure test with the fuel line again connected to the engine and the enriched pressure recorded and compared with specs and finally the engine is started or vacuum applied to the regulator valve with a hand pump and the lean or normal pressure is recorded.

    With some older engines it is possible to easily install a pressure gauge with universal adaptors but as later engines tend to use quick release fittings an number of special adaptors will be needed.

    Sep 13, 2015 | Toyota Cars & Trucks

    1 Answer

    1997 subaru impreza 2.2 engine random cuts out and stalls


    fuel pressure should be 34 - 38 psi.fuel pump could be failing.

    Apr 05, 2013 | 1997 Subaru Impreza

    1 Answer

    When i try to start my 99 vw passat gls v6 it will barely start and stay started for possibly 5 sec with no presure on gas pedal if i keep my foot on the gas it will stay running but the rpms wont rise...


    it hard to say there few things that could cause this but sounds like it a Fuel issue
    Possible bad fuel pump totallly clogged fuel filter bad injectors Out of gas etc.
    first thing you need to do is check your fuel pressure ( I bet it be low ) if it low check fuel filter if fuel filter good replace fuel pump
    If Fuel pressure is within Specs then test the injectors
    if Fuel pressure is ok and injectors test out ok then check ignition system (spark plugs, coils, module etc)

    May 11, 2011 | 1999 Volkswagen Passat

    1 Answer

    Code PO171 bank 2 system too lean How do I fix it ?


    Sounds like low fuel pressure check pressure to see if its within specs if not rplace fuel pump.

    Apr 25, 2011 | 2001 Volkswagen Beetle

    1 Answer

    Have a 97 VW Passat VR6, it died one day as the check engine light came on, it would run for a few minutes and then die, running shorter each time. Took it in to the shop and got the fuel pump replaced,...


    You need to check fuel pressure at the fuel rail.if pressure is at spec. Check spark at the plugs. Also replace relay for fuel pump if it isn't working. Could be a bad new fuel pump. Pull the codes first.

    Jun 19, 2017 | 1997 Volkswagen Passat

    1 Answer

    2001 vw 1.8 litre gas awv engine spec I am rebuilding my 2001 new beetle engine after the head cracked and I need the engine torque specs. Thanks


    Bore × stroke 81.00 mm × 86.40 mm 3.19 in × 3.4 in Cylinders s-4 SOHC Single overhead camshaft DOHC Double overhead camshaft OHV Overhead valves TS Two stroke SV Side valves
  • Sl
  • Sleeve valves
  • oise
  • Overhead inlet side exhaust
  • 5 valves per cylinder
    20 valves in total
    compression ratio
    9.30:1 fuel system
    MPFi Maximum power 150.1 PS (148.0 bhp) (110.4 kW)
    @ 5700 rpm Specific output 83.1 bhp/litre
    1.36 bhp/cu in Maximum torque 210.0 Nm (155 ft·lb) (21.4 kgm)
    @ 1750 rpm bmep 1481.7 kPa (214.9 psi) Specific torque 117.91 Nm/litre

    May 01, 2010 | 2001 Volkswagen Beetle

    2 Answers

    Gasoline presure


    Fuel pressure at the shredder valve should be 62 to 65 PSI with fuel pump primed (engine not running) and will drop about 5 psi when the engine running. Good luck, any other readings the engine will not start.

    Nov 13, 2009 | 1997 GMC Yukon

    1 Answer

    Fuel presure @ idle is 70, reg connected with new regulator


    fuel pressure is too high. Should be 40 to 45.
    You intermittant no start may be a bad crank sensor or hall effect sensor.

    Mar 23, 2009 | 1986 Volvo 740

    1 Answer

    No start


    Hello,

    2000 Ford Windstar Fuel Pressure Specifications:

    Key On, Engine Off-- 35-45psi

    Engine Running-- 28-45psi

    Note- whenever you have an 'Engine Cranks No Start' condition you want to check for spark...

    Nov 20, 2008 | 2000 Ford Windstar

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    105 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Volkswagen Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8273 Answers

    Are you a Volkswagen Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...