Question about 2004 GMC Envoy

1 Answer

Why wont my 04 Envoy wont go into drive

At first it would run fine untell about 55mph then it would feel like it just shifted into neutral had to pull over restart and shift back into drive it would go but we changed trans filter it run fine tell one day shifted out of passing gear into neutral now it wont shift into drive at all

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 9,639 Answers

The valve body has failed inside the transmission. . It's possible the shift solenoids or the transmission control module are faulty as well.

Posted on Jul 24, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 625 Answers

SOURCE: 2007 gmc envoy

you might have an electric problem since the brake switch comunicates with the transmission module

Posted on May 28, 2008

  • 132 Answers

SOURCE: 99 gmc no power when passing or climbing

It could be the cat. it sounds like this could be your problem

Posted on Feb 07, 2009

Molson02536
  • 3854 Answers

SOURCE: I have a 1995 GMC Jimmy with auto trans., it wont

Your going to have to get the Jimmy scaned before youhurt the transmission, It sounds like it's on a Limp mode which can range from a tune up to a bad ground. Good luck.

Posted on Apr 05, 2009

Testimonial: "Thanks for the info. I ended up sell the jimmy and passed on the info to the buyer they also found it helpful."

  • 126 Answers

SOURCE: 1998 gmc jimmy shifts fine through 3 gears wont shift into overdrive

check transmission fluid .

Posted on Jun 03, 2009

  • 15 Answers

SOURCE: The button on our 2004 GMC Envoy gear shift will not depress when

The brake rlease switch for the gearshift might need adjusted-replaced or the shifter itself might need adjusted

Posted on Mar 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission pump failure?


You may need a tranny or vacuum modulator that controls the shifting of the tranny. You may also need a new filter. Did the fluid smell burnt? That\'s alot of miles if original tranny.

Jan 25, 2013 | 2004 GMC Envoy

1 Answer

I had to pull my car home one day with my truck and it was fine just felt a little sluggish car was a ford escape. i got it home and left again the tranmission slipped a little when i pulled out of my...


Common problem with the GM transmissions, does it feel like no engine back pressure when takeing foot off gas ( feels like neutral) high RPM when shifting, Sorry, time for another transmission.

Feb 09, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

04 gmc envoy ,can't move the gear shifted even though car is on and brakes are applied


ingition switch has a sending unit to release shift...may be bad replace ignition modual or check for loose connection...theres also a lockout on transmission..if theres a problem there..like a bad shaft pulling out of the trany housing..the shafts have c clips on the ends that hole the shaft in ,,if they fail it locks you out so you cannot drive the car..first run scan to code it

Jan 05, 2011 | GMC Envoy Cars & Trucks

1 Answer

04 Envoy xuv 4 wh. drv. stays in 4 wh drv. HI


Try putting your transmission in neutral and slowly shifting the 4wd selector to each position but you have to wait a few seconds between selsctions as it has to go through your vehicles computer, shifting to fast will cause your symptoms. I hope this helped you out. Roger

Feb 08, 2010 | 2004 GMC Canyon

3 Answers

Wont shift back from 4x4 low, to 2x2


I also have a 2002 Envoy. Shifting to and from 4wh and 4wa can be done on the fly but shifting to 4wL has to be done stoped and while in neutral. Try that. Otherwise I'm afraid its a new computer for you. Its located under the left rear seat and you need a loan for one.

Sep 05, 2009 | 2002 GMC Envoy

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...