Question about 2010 Ford Edge

Open Question

Blueooth isn't working after windshield repair

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Peugeot forum


Usually not - if blueooth was fitted there would be no need for the sim to be inserted. This was common around 2000 isn when bloutooth was still n it's relative infancy and so was expensive to fit to cars whilst not being that reliable. I used to sell range rovers with this and the problem was that the phone companies didn't do second sims with the same number. Many clients took a second contract sim for the car and set the main phone to auto divert to the car if it was not answered

May 10, 2014 | Cars & Trucks

1 Answer

One Windshield wiper isn't working


Your windshield wiper motor is probably bad.

May 03, 2013 | 2004 Toyota Corolla

1 Answer

How do I repair my 2005 Mazda Tribute S rear windshield washer


That depends on what is wrong. Does the pump run when you activate the wash switch? If not pull the reservoir out and check to see if voltage is reaching the washer fluid pump, if it isn't then replace the switch, if it is replace the washer fluid pump.

Jul 27, 2012 | Mazda Cars & Trucks

2 Answers

My windshield washer pump isn't working on my 2006 Dodge Durango. I want to know which fuse to check for my windshield washer pump.


More than likely it's the pump itself. I say this because in a nutshell your pump is computer controled. It receives power through the CAN system on your vehicle. If it were just a fuse MANY other things would not be working. I would see if you are geting power and ground to the pump. If you are then replace the pump. If you are not you may be looking at the switch or a wiring problem or in the system itself. Wish I could give you just a fuse but it's not that simple on your vehicle. I gave you a descrition of how it works but it can be a little confusing.

12_10_2011_11_09_06_pm.jpg

Dec 10, 2011 | Cars & Trucks

1 Answer

Water leaking unto front floor carpet when driving through rain


Check around the edges of the windshield for any place water could be forced into the car. Especially if the windshield has been replaced. Check around the cowl that covers your windshield wiper motor. Remove the cowl if possible to check for rust holes or separated seams in the metal. The blower motor intake for the cars HVAC (heater) is often under this cowl. Make sure water isn't getting in through there. If you find a leak around the windshield or a separated seam, some windshield urathane or clear bathroom caulking would work. If you find a rust hole in a non visible place affix a tin or metal patch over it using rivets or your choice of fastener. Welding is the best method. Then cover the patch with short strand fiberglass bondo or something else to seal out water. If you have a hole in the floor you could put a patch on it with rivets or weld, then tar the underside well and put rocker panel coating on the top.

Sep 20, 2011 | Toyota Corolla Cars & Trucks

1 Answer

How do you install a new windshield washer pump


the windshield washer motor is at the bottom of the reservoir,you will need to remove the water reservoir, the motor usually pull out of a rubber grommet & goes back in the same way, just make sure that the rubber grommet isn't perished, if it is replace it.......cheers

Jun 21, 2011 | 1998 Oldsmobile Intrigue

2 Answers

Windshield wiper sprayer won't spray and fluid tank is full


your motor could be bad you could have a bad fuse or there is something in the line or there is something in the sprayer head. if you listen around the sprayer motor you should be able to here is it is working or not if it is working it is probably something in the line or sprayer head if it is not working than it is either a bad motor or it isn't getting power if the motor isn't working I would start with the fuses.

May 30, 2011 | 2008 Hyundai Elantra

1 Answer

I have a 1992 dodge shadow.but the windshield wipers isn't working.I checked the motor is well,the terminal voltage is 12V,how can I continu to repair the 1992 dodge shadow's windshield wipers?


You posting is slightly confusing but I gather your windshield wipers stopped working.
The repair method is as follows;
) Check the fuse.
) Check the wiper motor. Turn the wipers on and listen for the hum of the motor.

If you hear the hum then the linkage has probably come loose. You will have to take the covers off
to get to the linkage for the wiper. You can either repair the parts, get salvage yard parts or replace with new part$.

If you do not hear the motor hum then you should verify electricity is getting to the motor. A simple
voltmeter can be used. If the motor is bad you can replace it. Call some auto supply stores for after-market motors or call salvage yards for parts.

May 07, 2009 | 1990 Dodge Shadow

1 Answer

Windshield wiper sprayers


You seem to have the motor not working or there is not any power going to the washer pump motor. Check the fuse in the box first.
Ken S.

Mar 23, 2009 | 1994 Toyota Corolla

Not finding what you are looking for?
2010 Ford Edge Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...