Question about 1988 Mazda B2600 Cab Plus

Open Question

Substitution for 87 mazda b2600 egr valve

Can't find replacement part, any other type suitable

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 10515 Answers

SOURCE: need to no step bye



Before attempting to troubleshoot or repair a suspected exhaust gas recirculation (EGR) system on a vehicle, the following conditions should be checked and be within specifications.

  • Engine is mechanically sound.
  • Injection system is operating properly.
  • Mechanical-vacuum advance is properly adjusted or the electronic advance system is operating properly.
If one or more of these conditions is faulty or operating incorrectly, perform the necessary tests and services to correct the problem before servicing the EGR system.


Before attempting any tests of the EGR system, visually inspect the condition of all vacuum hoses for kinks, bends, cracks, and flexibility. Replace defective hoses as required. Check vacuum hose routing. (See the underhood decal or the manufacturer's service manual for correct routing.) Correct any misrouted hoses. If the emissions system if fitted with an exhaust-gas-recirculation valve position (EVP) sensor, the wires routed to it should also be checked.
If the EGR valve remains open at idle and low engine speed, the idle operation is rough and surging occurs at low speeds. When this problem is present, the engine may hesitate on low-speed acceleration or stall after deceleration or after a cold start. If the EGR valve does not open, engine detonation occurs. When a defect occurs in the EGR system, a diagnostic trouble code (DTC) is usually set in the powertrain control module (PCM) memory.


Posted on Nov 07, 2009

  • 340 Answers

SOURCE: How do you replace the EGR valve on a 2000 Mazda

if you are lockey to have one it is on the intake manifold two bolts or three depending on the engine and some have a tube / and eather vaccum or electric wires attached // if you don't have an egr try changing your o2 sensors ( some manufactures use the o2 sensors as the up & down stream and have removed the egr valve

Posted on Mar 01, 2010

  • 383 Answers

SOURCE: 2000 mazda 626 check engine light went on . code

probley not egr valve it probley egr control solenoid or wiring

Posted on Apr 11, 2010

  • 365 Answers

SOURCE: i need to set up the camshaft timing marks on a 1994 mazda b2600

its not just the camshaft timing marks you set up, you also have to have the crankshaft timing mark set right to or you may damage your engine
check the internet for the right timing procedure for you model car ok

Posted on Jun 11, 2010

  • 17970 Answers

SOURCE: were is the egr valve located for mazda rotege5

2002 Mazda Protege5 with the FS2.0 Motor. The EGR Valve is located below the throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body.


Fig. Exploded view of the intake manifold assembly with 2.0L (FS) engine

Good luck (remember rated this).

Posted on Jun 25, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

EGR valve Mazda 2002 V-6 Tribute replacement


  1. Remove the EGR valve.
  1. Disconnect the vacuum line.
  2. Disconnect the EGR tube.
  3. Remove the EGR valve and discard the gasket.
NOTE: The EGR valve sealing surfaces are soft metals.

  1. To install, reverse the removal procedure.
  1. Carefully clean all sealing surfaces and install a new EGR valve gasket.

Jan 01, 2015 | 2002 Mazda Tribute

1 Answer

B2600 oil pressure relief valve is missing oil leaking

b2600???? is that a MAZDA? oops.....a .....daisy......
what car? jeep>? you posted to jeep. if not a jeep go to correct forum.
what engine, there are many.
is this an engine part or tranny, both have pumps. and relief valves.
just a clue here.

Feb 11, 2014 | 2001 Jeep Grand Cherokee

1 Answer

Are mazda B2600 gearbox same to Mitsobishi. Can I replace Mitsobishi gearbox on Mazda B2600..1992?

Mazda and Ford parts will change,your B2600 with swap out with a 92 Ford Ranger.

Dec 25, 2012 | 1992 Mazda B-Series

1 Answer

Engine rough idles on start up. it also started using some coolant. what do you think the problem is?

Here are some of the reason why engines idle rough or erratically at start up.

1. Vacuum leakage
2. Leaking EGR Valve
3. Spark Plugs or Wires fouled
4. Air Filter clogged
5. Fuel pump not delivering sificient fuel
6. Leaking head gasket this may also be the cause of the coolant usage
7. Timing Belt and/or Pulleys worn
8. Camshaft lobes worn

I hope this help you fix your issue.

Jul 03, 2010 | 1988 Mazda B2600 Cab Plus

1 Answer

I need to know how to change an egr valve on my 2003 mazda protege 5

This link is to a "How To Replace an EGR Valve" video. While he is doing this on a Ford F150 pickup, the tips he gives you should translate over to your Mazda easily, especially as he talks about the stickers under the hood designed to tell you where your EGR valve and solenoid is located. Give it try...I think it will work for you.

Aug 13, 2009 | Mazda Protege Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides