Question about 1997 Volkswagen Jetta

1 Answer

What do i do when the hazard lights wont turn off

Battery died then hazard lights stay on without the hazard button being pushed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

I recently had a very similar problem on a audi was doing exactly the same thing is was the central locking control box on the floor under the carpet just infront of passengers seat was full of water shorting the board I took the board out dried it then cleaned the drain pipe under the bonnet under battery tray works fine now

Posted on May 13, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the hazard light relay located?


The button is bad. the flasher is in the fuse panel.

Mar 15, 2016 | 1987 Cadillac Seville

1 Answer

No turn signals. hazard lights work only when button is held in. Hazzards will not stay on. Is problem in turn sig switch or hazard light switch


If hazard switch wont stay engaged and the turn signals run through it I would replace hazard switch then retest

Apr 11, 2015 | Cars & Trucks

1 Answer

My ford falcon is draining the battery with the hazards staying on


Try checking the voltage of the battery after charging and disconnecting the leads.. Batteries die if being drained too much..

Jul 19, 2014 | 1999 Ford Falcon

1 Answer

Hazard light button wont stay down to keep the hazard light from coming on. if you hold the button down the hazard lights will turn off. It seems like the button has moved up on the shaft.


GM sells a repair kit for the switch. you don't have to remove anything but the switch. I believe instructions come with switch/button kit. first time you do it is pain but not too bad

Oct 19, 2013 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Hazard light button pushed thru housing. Can't turn off hazard lights


REMOVE HAZARD FUSE IT WILL TURN OFF FLASHER UNTIL YOU FIX HAZARD BUTTON.
YOU GOING HAVE TO REMOVE SPEEDOMETER AND TACH CLUSTER TO GET TO HAZARD SWITCH.TURN OFF RADIO FIRST BEFORE REMOVING NEGATIVE BATTERY CABLE BECAUSE YOU WILL DISABLE AIRBAGS WHILE WORKING AROUND STEERING WHEEL AND DASH AREA. WAIT 20 MINUTES BEFORE WORKING AROUND DASH AREA AFTER DISCONNECTING NEGATIVE BATTERY CABLE.

Jan 13, 2011 | 1999 Oldsmobile Alero

1 Answer

Hazard light stays on and wont turn off plymouth acclaim 94. can you help. just replaced battery and problem happened


there is a switch for them to turn on and off. I think it's a push button. do you have a owners manual? it will tell you where it is.

Feb 25, 2010 | 1993 Plymouth Acclaim

1 Answer

Hazard lights wont come when you push hazard button turn signals will not work push it again and they work


it sounds like the relay has gone for your hazard lights, when you press the button to turn them on, it will disconect the power to the main indicators hence wont work when hazards pused in, try locating either the hazard flasher unit, or the relay , have you checked the fuses?

Feb 01, 2010 | 2000 Hyundai Elantra

1 Answer

1994 Ford Probe GT - 1. Key stuck in ignition 2. Hazards on


Hello , I am a locksmith in Az. The Ford, Chevy& Dodge igns up until 2004 all had this problem. You will need a new updated "side-bar free" ignition to cure that problem. If you decied to splice wires , yes it will work, but you will need to be extra EXTRA CAUTIOUS IN RE-ATTACHING WIRES AND MAKE SURE THAT WIRES ARE IDENTICAL IN COLORS. (not yelling) just making sure you understand the importance of this procedure.

Quinn

Jan 23, 2010 | 1994 Ford Probe

1 Answer

I have an 04 s4 and recently the horn goes off and gets stuck in that orinentation. it wont shut off unless i pull the horn fuse or battery lead. when the horn gets stuck on the hazards also come on n stay...


methinks a stray wire in aftermarket alarm system. Most horns are negative switched (ie they are operated by earthing a wire on the steering column) and would not interfere with positive-switched items such as the hazard lights. Does your car have an aftermarket alarm?

Sep 17, 2009 | 2004 Audi S4

Not finding what you are looking for?
1997 Volkswagen Jetta Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...