Question about 2001 Mitsubishi Mirage

1 Answer

2001 mitsubishi mirage de coupe. starts but will not stay on. checked filter and is ok.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 11 Answers

You need to clean the throttle body .. then earth out the singke pin brown connector on the firewall to reset base idle .... the car needs to be a normal operating temperature

Posted on May 29, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: Mirage Mitsubishi 2000

The fuel filter is located in the engine compartment,mounted to the firewall..Lower right hand side

Posted on Mar 14, 2009

  • 10 Answers

SOURCE: How to replace a fuel filter for a Mitsubishi Mirage 2000

There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!

Posted on Mar 15, 2009

  • 208 Answers

SOURCE: Problem with air conditioning on 2001 mitsubishi mirage.

the air conditioning system has most likely drawn moisture this is not good take it to have the system recovered and a new restrictor valve put in. leak checked and recharged

Posted on Jun 22, 2009

Transdoc
  • 829 Answers

SOURCE: Replaced input turbine/speed sensor---Did not fix

Is the sensor threaded or held in with a bolt.

Posted on Jan 19, 2011

ZJLimited
  • 17970 Answers

SOURCE: que significa SRS en el panel de mi mitsubishi mirage 1995

Hola:
EL codigo SRS se refiere al sistema de seguridad del vehiculo (Air Bag System), y aparece cuando se presenta algun codigo de falla en el mismo.

La presencia de un codigo de este tipo no sera eliminada con solo desconectar la bateria durante algunos minutos; necesariamente tendra que llevar el vehiculo a su representante o algun taller que cuente con lector de codigos (scanner) para determinar exactamente que codigo de falla se ha presentado, Solamente con este codigo podriamos ofrecerle mayores detalles.

Suerte.

Posted on Jul 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Necesito codigo para desbloquear mi radio de mitsubishi mirage


El codigo de radio, generalmente esta ubicado en las ultimas paginas del manual del propietario, consta de 4 o 6 digitos; si Usted no tiene el manual correspondiente, necesariamente debera visitar al representante de Mitsubishi y demostrar la proppiedad del vehiculo con su tarjeta de propietario y el numero VIN (Vehicle Identificaction Number). A veces esto requiere de algun pago, pero no siempre.

FInalmente, podria intentar enviando todos los datos de su vehiculo (incluyendo el modelo y serie del radio) a " restoredclassic@aol.com ", quizas podrian ayudarlo.

Espero que esto le haya servido. Suerte.

Feb 14, 2011 | 2001 Mitsubishi Mirage

1 Answer

Where is my fuel filter on my 95 mitsubishi mirage coupe


look under the car along the driver side, could be under a little cover follow the gas lines

Jan 09, 2011 | 1997 Mitsubishi Mirage

1 Answer

Break light on my 2001 Mitsubishi Mirage stays on. Break fluid is full what could the problem be.


many things can be air on the sistem check the sensor fluid if the deposit is full ..how you feel the pedal loose or hard check the hose from the brakebooster

Dec 14, 2010 | 2001 Mitsubishi Mirage

2 Answers

Where is the cig lighter fuse located on the fuse box of a 1999 Mitsubishi mirage coupe de


your owners manual should have a diagram as to the location of that fuse. Just check in the index under fuse.

Mar 21, 2010 | 1999 Mitsubishi Mirage

1 Answer

Donde está localizado el módulo de la alarma en un Mitsubishi Mirage 2001


hay dos paneles de fusible en el coche uno bajo el arranque dejo lado uno bajo la capucha lado de izquierda














Mar 03, 2010 | 2001 Mitsubishi Mirage

1 Answer

We took our 2001 mitsubishi mirage to a freind to install new breaks, the car wont start today? he says has power but won't start?


first off has nothing to do with the brake install!!!could be wires,fuel filter,GAS,weak battery/starter.....

Dec 06, 2009 | 2001 Mitsubishi Mirage

1 Answer

2000 Mitsubihi Mirage DE coup 1.5L -P.S. Belt


a225cad.gif
GENERATOR DRIVE BELT TENSION ADJUSTMENT/ PS

  1. Loosen the nut of the generator pivot bolt.
  2. Loosen the lock bolt.

Jun 05, 2009 | 2000 Mitsubishi Mirage

1 Answer

Can't find flasher can


Your flasher is

Below the instrument panel, left of the steering column

Jan 29, 2009 | 1991 Mitsubishi Mirage

Not finding what you are looking for?
2001 Mitsubishi Mirage Logo

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...