Question about Cars & Trucks

1 Answer

I have a 2001 polo playa 1.6i the car swings but jst wouldn't start I put in a new battery(bigger size),new distrubutor cap n roter still having the same problem bt if I put jumper cables its starts there's no error codes on the dash please help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 145 Answers

Clean contact surfaces of your battery clamps

Posted on Jun 12, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

DrElectrics
  • 199 Answers

SOURCE: vw polo electrical problem

If spark is good, it could be fuel pump or filter, or even your solenoid. Message me with more info. does it:
1. Try to start? - Fuel issue, or battery issue?
2. Click - Battery issue
3. Nothing? - Solenoid issue

Posted on Jun 05, 2008

  • 1 Answer

SOURCE: Toyota error code P2118

I don't have a Sienna but I do have a 2008 Toyota Camry SE. After it being in the garage for many months, 8 months I think, I had to give the battery a jump to finally start it up. Well The jumper cables I used weren't that great. They flickered and seemed to smoke a little. So i removed them and put a better set on to get a charge. I didn't think anything of it. After that charge came through and i was able to accelerate at all... The throttle was to the floor and the car would not even go up .5 RPMs... After several days and talking to the dealer, I was about to call a Tow to have it taken to the dealer. Luckily my friend came by with one of those diagnostic readers and it spit out the P2118 error code. Immediately we looked it up and found this site. Thanks to Fixya.com I was able to determine that it was a freakin measly fuse that blew due to bad jumper cables... Thank god for the Fuse and thank you to Fixya.com that I was able to determine this so quickly!!!

Posted on Mar 17, 2010

  • 14585 Answers

SOURCE: 02 saturn car starts then shuts off within 5 sec

Check security light, if it is flashing , it is set. try this, turn ignition on, don't try to start, let set for ten minutes on. turn off don't take the key out. do this three times ten minutes each, after the third time turn it off, then try to start. This resets the security. If this does not work, then it needs reprogrammed to the new computer you installed. dealer only, about $100.00
Randy

Posted on Nov 10, 2010

jturcotte
  • 7743 Answers

SOURCE: 2001 sunfire put new starter in car would not

Hi, it sounds like the starter solenoid was not wired properly. You have 2 wires at the starter, right? The bigger wire goes to the big top post on the solenoid, right? The smaller wire is called the start wire and it goes to the smaller terminal labeled "S." Is that how you wired it? You also have to be careful when tightening the nuts on the terminals that the start wire terminal does not touch the other terminals and vice versa. Do you have the starter in the car now? Can you take a picture to send me?

Posted on Apr 05, 2011

  • 11800 Answers

SOURCE: i have a VW Polo

There are several sites that will give you the immobilizer code based on your VIN and there are independent repair shops that have an ABRITES Commander diagnostic program that allows the reading of the PIN directly from the memory of the immobilizer. Since these tools and sites can be used to bypass the security on a car and steal it i cannot give you a direct link - you will have to search for them yourself.
But i can give you the link to this

http://www.autotronics.co.uk/cscart/vw-polo-0002-immobiliser-transponder-recoding-and-replacement-car-key-service-clone.html

Posted on Jun 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 1.4 polo playa. It started fine and the following morning nothing. The starter doesnt turn over and does nothing when you turn it, help pls. The battery is fine


If the battery is fine , then it will either be a faulty starter motor or a problem with the ignition switch, did you have the battery checked for Amperage ? if you just were able to power the lights etc this could still mean the battery isn't holding enough charge, another reason for a battery fault would be the alternator not charging at the correct rate, especially at night when using lights, heater if cold , all these will take charge away from battery if alternator fault/drive belt to loose .Have you tried to jump start the vehicle , if it starts with a jump start then definately a problem with the battery/charging system, hope this helps

May 06, 2017 | Cars & Trucks

1 Answer

Where is the fuse for the cluster polo playa 2001?


How to access the fuse box in a Volkswagen - YouTube

? 1:17
https://www.youtube.com/watch?v=Nr-TKfDhw8c
Dec 5, 2012 - Uploaded by Jay Pichardo
where do I find the fuse values for a vw polo 2002? in the manual there ... hello need to know how to make ...

vw polo fuse box layout - Volkswagen Forum



Dec 10, 2015 | Cars & Trucks

1 Answer

I have a 2001 polo playa 1.6i I put in a bigger size band new battery,new roter,new distrabutor cap n the car wouldn't start it jst swings and as soon as I put the ignition on the battery light flickers...


sounds like the starter motor isn't releasing bendix spring ,try hitting starter firmly but carefully a few times, then try starting may get you going ,if does get a new starter.Replacing the battery with a bigger size isn't a good idea what was the difference in amp hour out put ?

May 14, 2014 | Cars & Trucks

1 Answer

Polo playa manual


REPLACE GROMET AND READJUST SHIFTER IF NEEDED!

May 05, 2014 | 1995 Volkswagen Polo 1.6

1 Answer

VW POLO PLAYA 1.6I NOT STARTING WITH FIRST SWING


have your starter and starter solenoid cleaned.

Jun 11, 2013 | Cars & Trucks

1 Answer

2002 polo playa all belts changed serviced.car still sluggish.what's the cause of car still being sluggish?


I just bought a polo playa 1.6 from a personal owner and I want to do a
major service on it how much am I looking at to service it?

Mar 31, 2012 | 2004 Volkswagen Polo 1.4

1 Answer

'06 VW Polo cooling fan not working - fuse inside fine - fuse on top of battery (5) blown - put in new one and blown again - need bigger size or what?


Don't put in a bigger size. If it blew once, it means something inside the fan has failed. Take a look for any obvious shorts in the wires: Failing that, Take out the fan, and see if it works. Most likely the short is right at the connector, where it vibrates out the most.

Jun 05, 2011 | Volkswagen Polo Cars & Trucks

1 Answer

CONFIGURATION FOR THE DISTRUBUTOR CAP 93 FORD E


You didn't mention your engine size, so I've put the three diagrams in the following order... V6, V8 5.0L, V8 5.7L
e454c8f.gif 269d27e.gif 03c7f89.gif

Sep 17, 2009 | 1993 Ford Econoline

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...