Question about 1989 Toyota Corolla 1.6

1 Answer

1989 toyota corolla 1.6 gl, where can i find the terminal for speedometer in the engine bay..

Posted by on

  • denver
    denver May 17, 2014

    ok, it did stop working suddenly one day...i'll check on the wiring then...thank you very much...

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 71 Answers

Output speed sensor usually located in transmission usually close to where axles go into transmission. The sensor can be identified by having 8 mm headed bolt that hold the sensor in. These speed sensors just don't quit one day. A wire is usually the culprit or debris on magnet of sensor or physically broken sensor. If speedometer intermittently starts working then its always a wire with bad connection.

Posted on May 16, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: speedometer quit working in my 93 toyota corolla

CHECK YOUR VECHICLE SPEED SENSOR WIRE FOR DAMAGE.OR THE MAGNET GEAR ON TRANSMISSION OUT PUT SHAFT IS BROKEN OR DAMAGE.IF THEY ARE GOOD YOUR PROBLEM IS IN THE DASH.BROKEN SPEEDOMETER.

Posted on Aug 16, 2009

  • 1 Answer

SOURCE: toyota corolla 1994

theres no cable in toyota corolla 1994 check the speed sensor or replace speedometer have same problem with my 1993 toyota corolla

Posted on Nov 14, 2008

  • 18 Answers

SOURCE: need to know how to adjust valves, or a print-out

This engine utilizes shims to set proper clearances, you will need a micrometer, valve clearance adjustment tool set for shimmed lifters,small magnetic arm, appropriate shim selecting charts (manufacturer will have this if you can get the nec. measurements).
Measure thickness of shims removed (using micrometer) and use this formula where T=Thickness of old shim; A=Valve clearance measured; N=Thickness of new shim required.
Intake valves:   N = T + (A - 0.02 mm (0.008 in.)) Exh. valves:     N = T + (A - 0.25 mm (0.010 in.))
Then you need to find shims as close as possible to the calculated values.
Valve clearances (cold) are as follows: Intake 0.15 - 0.25 mm (0.006 - 0.010 in.) Exhaust 0.20 - 0.30 mm (0.008 - 0.012 in.)
Note, if you are not familiar with precision measuring using a micrometer, this may be better left to a trained tech. These are high revving little power plants and you don't want a problem at 8K rpm.

Posted on Aug 06, 2009

  • 1861 Answers

SOURCE: Speedometer is erratic

It sounds like the core of your speedometer cable is rubbing the outer housing. The speedometer cable runs from the inst panel, thru the firewall, and onto the side of the transmission that faces the driver. This is not a hard job to do, but, when replacing the cable, take care to not break the ears off of the part that hooks on to the back of the speedometer.

Posted on Sep 16, 2009

  • 1752 Answers

SOURCE: 1990 Toyota Corolla - engine overheating, maybe

Blown head gasket, get it replaced.

Posted on Dec 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to know what is the piston numbers, which one is 1,2,3and 4 etc.on a toyota corolla 1.6 gl Carburator engine 1994 model petrol, automatic.


Number 1 is closest to the front of the engine. The front has all the pulleys and the serpentine belt.

Oct 28, 2016 | 1994 Toyota Corolla

1 Answer

My 1989 toyota corolla xe starter does not engage when i turn the key ?


try checking the starter fuse...its the fuse box just above the positive terminal (that's where it is in my car). try removing the fuse then connect a wire instead of a fuse..

May 31, 2014 | 1989 Toyota Corolla 1.6

2 Answers

Toyota Corolla Problem 1989 gl


It could be distributor cap they get electric arking on inside terminals and probably need good scrape of. Or a new cap and the rotor probably needs a sandpaper. To check if valve is stuffed borrow compression tester it will tell new straight away if its a internal engine problem chances are its your dizzy 9 times out of ten its electrical and just needs agood sand paper

Nov 17, 2013 | Cars & Trucks

2 Answers

HOW TO REPAIR STARTER FOR TOYOTA COROLLA 1989


There are several faults that give this indication. 1 is that the positive battery lead has a build up of lead sulphate on the inside of the terminal wqhich shows up as a thick black coating. The same will be on the bat terminal. Clean with course sand paper / file etc until the areas are shiny lead (silver) next the starter commutator may have a dead bar which means that the current will not flow through the armature making it turn. This can be checked by taking a jumper lead and momentarially shorting between the 2 main terminals on the starter. The motor wont move but the starter will spin . That narrows it down to the solenoid. When you turn the key the solenoid is energised and pulls the starter clutch into the ringear first and then bridges out the two main terminals just like you bridged out the terminals with the jumper lead. They have atendency to burn out the copper inside but you should hear the clutch gear hitting the ring gear. If nothing then I would say that the solenoid is at fault. You can replace it with a replacement part but be careful that you reassemble it exactly as you removed it.

Jan 23, 2013 | 1989 Toyota Corolla 2 Door

1 Answer

Can engine oil leak into transmission on toyota corolla 1989


Sounds like you need to get your transmission serviced as the darkened color is a sign of deteroration. As for oil to somehow make it into the transmission you would need one serious oil leak and the grommet around the tranmission dipstick would have to be pretty much gone for oil to somehow make it into the housing. Needless to say I've never seen it happen.

Oct 23, 2012 | 1989 Toyota Corolla Station

1 Answer

Changing 1989 toyota corolla engine to fuel injectoin


Yes, and you need a computer, and a different fuel tank system, fuel lines, and emission components from the new engine's car.

Jul 14, 2010 | 1989 Toyota Corolla 2 Door

1 Answer

How to change a starter motor on a 1989 Toyota Corolla


Hi you did not say what engine or model but based on a 1.3 12v remove disconnect the battery black (negative terminal) then the air filter housing on top with a wing nut.
then you have the carb underneeth it you can remove this to make access easier label all of the vacum hoses etc. and remove the carb by removing four bolts at all four corners at the base of the carberetor.
the starter is at the back of the engine underneeth the manifold undo the solenoid (one bolt with a wire connected) undo the bolts for the starter sorry cant remember how many. you may need to give it some gentle persuasion with a copper hammer. remove and replace.

Feb 05, 2010 | 1989 Toyota Corolla 2 Door

1 Answer

Defective tachometer and speedometer


Do the following:1)key in the ON position:remove the 7.5 gauge fuse.Tach needle should read "0:". 2)put it back,go on the engine and unplug the green plug on the igniter -the big one,with 5 or 6 wires on it.The needle on tach reading should be zero.If not you have a short circuit on the black wire between that plug and the plug on the conbination meter.3) If the reading is zero with the plug disconnected,the black wire for the tach is short-circuited inside the igniter. I have one available.email daddykouki@gmail.com

May 30, 2009 | 1989 Toyota Corolla 2 Door

1 Answer

My radio, clock and internal light don't work


The graciousness of a FixYA would be much appreciated; glad to be of assistance.

Oct 16, 2008 | 1989 Toyota Corolla 2 Door

Not finding what you are looking for?
1989 Toyota Corolla 1.6 Logo

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...