Question about 2005 Mercury Grand Marquis

1 Answer

2005 mercury grand marquis driver air bag circut open after replacing airbag,clock spring,and control module

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 156 Answers

You need to have the system checked for what the fault code is...are you sure it's the drivers side air bag or the drivers side, side air bag(located in the seat back?)They're could be a problem with the wiring under the seat.

Posted on Jul 02, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 58 Answers

SOURCE: Odometer stopped working

output shaft speed sensor in the transmission

Posted on Jul 25, 2009

  • 186 Answers

SOURCE: 2001 mercury grand marquis. Engine stutters or

Start car and use a squirt bottle of water to wet the wires and coil, if you see it spark or run rough one or both are bad, repair the wires first as they are more common.

Posted on Aug 02, 2009

  • 1168 Answers

SOURCE: 94 grand marquis cruise control does not work and

Hello dogjasper.
Both of these issues will be caused by a part under the steering wheel called a "clockspring".
This part allows the transfer of electrical energy through a plastic spring with wire leads impregnated into it.
The plastic over time will crack and the wire along with it.
The clockspring carries current for both the air bag and your cruise control.
The steering wheel will need to be removed to access this part to be replaced.

Posted on Mar 13, 2010

  • 5 Answers

SOURCE: Where is the headlight control module on 2005

your lcm is located under the steering wheel to your right its that rectangle box with a connector showing.

Posted on Jul 10, 2010

  • 5 Answers

SOURCE: where is the lighting control module on a 2005

it is located under steering wheel to your right

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1997 mercury grand marquis air bag light is blinking code 41 how do i fix it or find the problem


Code 41 could be a few things.
Most likely a front crash sensor or the "clock spring" under the steering wheel which transmits power to the steering wheel and drivers air bag while still allowing steering wheel rotation.

May 22, 2017 | Mercury Cars & Trucks

1 Answer

What do I have to do to replace air bag/horn switch on a 2005 Ford F350 6.0L diesel?


Horn swith or clock spring ? Is air bag light lit on the instrument cluster ? You would have to take air bag module off the steering wheel .An to do that you have to deenergize the air bags , pull a fuse an disconnect the negative battery cable . Then you have to pull the steering wheel . Videos on youtube showing to replace clock spring ! Steering Column Airbag Clockspring Repair Ford Superduty 1999 Up

Nov 11, 2016 | Ford F-350 Cars & Trucks

1 Answer

What does code 33 mean 2006 Grand Marquis airbag


Mercury Grand Marquis diagnostic code 33 Questions ...

www.fixya.com > ... > diagnostic code 33 > Cars & Trucks > Mercury
Mercury Grand Marquis cars & trucks diagnostic code 33 questions and ... 2006Mercury Grand Marquis air bag light flashes ... What does code po1151 mean.

2006 Mercury Grand Marquis air bag light flashes three ...

www.fixya.com/.../t19845434-2006_mercury_grand_marquis_air_bag_l...
Sep 3, 2013 - It then stay on. I assume - Mercury 2006 Grand Marquis question. ...What does a flashing air bag light mean on a 1993 Grand Marquis? Jul 23 ...

Mercury Grand Marquis airbag code 33 Questions ... - Fixya

www.fixya.com > ... > Tags > airbag code 33 > Cars & Trucks > Mercury
Mercury Grand Marquis cars & trucks airbag code 33 questions and answers. ... What does a flashing air ... 2006 Mercury Grand Marquis air bag light flashes.Missing: mean

Jan 11, 2016 | 2006 Mercury Grand Marquis

3 Answers

I have a 1998 chrysler concorde. The airbag light on the dash stays on and my horn doesnt work. How do i fix this without costing me tons of money?


Could be a wiring problem or the clockspring in the steering column.
You would need to pull the steering wheel and test the circuits.

Mar 26, 2015 | Chrysler Cars & Trucks

1 Answer

Drivers airbag codes for 2003 mercury grand marquis


Some of the air bag computers are mounted under the driver's seat. If it is, than the wiring can be dislodged by rear seat passenger's feet. If so try repluging in the wiring while the car is shut off.

Jan 21, 2015 | 2003 Mercury Grand Marquis

1 Answer

Peugeot 807


it is possible the clock spring i agree,it is the common problem of the open circuit at the system

Jan 27, 2014 | Cars & Trucks

1 Answer

2001 pontiac grand am air bag module reset


Yes!!! You can replace it yourself.(Dont let others fool you into paying extra or telling you otherwise.)
-This is for pontiac grand ams 1999-2005 only.
-There are no frontal airbag impact sensors nor are there belt tensioners.
-The SRS system consists of only the (driver airbag) ,(passanger airbag),and the (airbag control module) in 1999-2005 grand ams.

If you crash/wrecked and airbags deployed you will need.
-Driver and Passanger airbags
-Airbag control module

You can buy cheap airbags from a local junkyard any year from 1999-2005 will fit.
You can also find an airbag control module for cheap at your local junk yard BUT YOU MUST FIND ONE WITH THE SAME (PART NO.) AND (SERV NO.) AS THE ONE YOUR REPLACING.The (part no.) and (serv no.) should be at top left of airbag control module.However it does (Not) have to match numbers under barcode or the numbers at the far bottom right of airbag control module.

After you get both airbags and airbag module
-Disconnect car Battery
-Replace airbags
-Replace airbag module (under passanger seat)
-Double check all connections and connect battery.

Congradulations!Your airbags should be back online.

Notes: Two torx 35 head screws hold the driver airbag, access is through two holes behind steering column.
To remove passanger airbag you have to remove glovebox it uses (7mm)screws.After you remove you will see a pair of (10mm)screws holding airbag.
To remove airbag control module First remove passanger seat 2(15mm).Then after removing you will notice a raises area kinda like a vertical bump.Take a razor blade to your carpet and cut it to explose the module underneath.
The airbag module is held by three screws depending on the year of your car it varies.Most likely 3 (10mm).

Mar 24, 2013 | Pontiac Grand Am Cars & Trucks

3 Answers

My rear air suspension on my 2001 mercury grand marquis blew and now my mechanic says that he has to order the part from ford and each bag is $500.00 so minimum cost is $1200. Does this sound right?


You need to listen to the mechanic in this situation. If you really believe this is wrong, you can get a second opinion from a different mechanic. Hope this helps! Please rate 4 thumbs up!

Apr 18, 2011 | 2001 Mercury Grand Marquis

1 Answer

Air bag light blinks a code 13 continuously, It doesn't come on and stay on it blinks 1---1-1-1......1---1-1-1.....etc. I have change the two sensors in the front, checked fuses(no fuses with a direct link...


The Supplemental Air Bag Restraint System consists of two basic sub-systems:
  • Driver side air bag module (043B13) and passenger side air bag module (044A74).
  • Electrical system, including RH primary crash front air bag sensor and bracket (14B004) , LH primary crash front air bag sensor and bracket (14B005) , LH kick panel safing rear air bag sensor and bracket (14B007) and air bag diagnostic monitor (14B056) .
---------------------------------------------------------------------------------------
13 Air Bag or Primary Crash Sensor Circuit Shorted to Ground
  • Inspect air bag sliding contact wiring in steering wheel , driver side air bag module , and passenger side air bag module for damaged, chafed or pinched wires.
  • -------------------------------------------------------------------------------------

    Oct 28, 2010 | 1993 Mercury Grand Marquis

    2 Answers

    94 grand marquis cruise control does not work and air bag lite blinks on and off. Are these two problems associated together ?


    Hello dogjasper.
    Both of these issues will be caused by a part under the steering wheel called a "clockspring".
    This part allows the transfer of electrical energy through a plastic spring with wire leads impregnated into it.
    The plastic over time will crack and the wire along with it.
    The clockspring carries current for both the air bag and your cruise control.
    The steering wheel will need to be removed to access this part to be replaced.

    Feb 23, 2010 | 1994 Mercury Grand Marquis

    Not finding what you are looking for?
    2005 Mercury Grand Marquis Logo

    229 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Mercury Experts

    yadayada
    yadayada

    Level 3 Expert

    75066 Answers

    fordexpert

    Level 3 Expert

    5470 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Are you a Mercury Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...