Question about 2005 Chrysler Town & Country

1 Answer

How do I "reset" the check engine light in my 2005 Chrysler T&C?

It came on after the radiator fan started running by itself in the middle of the night. I pulled the fuse and now it seems to be fine, but the warning light is still on. I do I reset it, to see if the same problem exists?

Posted by on

  • bblue1967191 Jun 23, 2009

    OMG!!! I didn't believe your commonet about Autozone so I called them! Thank you so much. You just saved me a ton! I will try the battery disconnect too and keep you posted!

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 314 Answers

You will have to hook a scan tool up to it and then remove the trouble code. you can do this for free at autozone. another possibility is to disconnect the battery for 30 minutes and that should clear the computer's memory.

Posted on Jun 23, 2009

  • dillardw Jun 27, 2011

    by dillardw you can also remove the IOD fuse in the power distribution center next to the battery for only a few seconds to reset the computer.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the cooling fan temperature sensor on a 1993 Chrysler lebaron?


The LeBaron uses the Coolant temperature sensor data for both the engine control and the radiator fan control. The PCM sends a closure signal to the Radiator Fan Relay when it wants the cooling fan to run. There is no separate switch for the fan itself.


25982302-uve11oxnzgjhln0dje3jwl4n-2-0.gif

Nov 27, 2015 | Chrysler Cars & Trucks

2 Answers

My 95 Chrysler Concorde is running hot on short distance driving


Have the cooling system pressure tested with a special tool and see if the source of the leak is the water pump, also feel under the pump for antifreeze.

Jul 10, 2012 | 1995 Chrysler Concorde

1 Answer

Location of the temp.cooling switch /or sensor for radiator cooling fans on 2006 chrysler 300 c


The radiator cooling fans are controlled by the engine managment computer, it uses the signal from the Engine Coolant Temperature Sensor (ECT), unless the engine is hard starting or runs poorly the sensor is not the problem. Also the Check Engine light would be on, is that the case?

Apr 21, 2012 | Cars & Trucks

1 Answer

My engine in my 04 Sebring is running hot, andthe a/c is blowing hot air. Doesn't happen everyday. What's wrong?


Your A/C has it's own little radiator that sits right in front of your engine's water-filled radiator. Heat from your engine radiator is prolly transferring itself into the other smaller radiator and over-whelming it. When any engine is running hot, it usually turns out to be a bad themostat, bad temp-sensors (that run your electric cooling fans on the radiator (or one (or both) radiator fans have died). I would start with the thermostat since it's the cheapest....

Aug 08, 2011 | 2004 Chrysler Sebring

1 Answer

Engine fan starts running when cold and not running


Disconnect one of the wires on the thermostatic switch on your radiator. If this stops the fan from running, the switch is stuck in the closed position. Lightly tapping it may release the contacts but this will probably prove to be a temporary solution and the switch should really be replaced. If the fan runs with the wire disconnected there must be a relay in the system that has failed. Check the fuse box or the handbook for the location of this relay.

Jan 19, 2011 | 2005 Chrysler Town & Country

1 Answer

Why does my 2005 Town & Country radiator fan


The fan is computer controlled and will not come on untill it reaches 212Deg . It should come on though if you turn on the air conditioning, if not you could have a bad fan relay or relay plug.

Feb 22, 2010 | 2005 Chrysler Town & Country

1 Answer

Cannot separate radiator from A/C Consensor/Tranny on T & C


I dont remember for sure on yours but if any plastic on top take off , take any bolts on top of radiator core support , take fans off , take bolts out of top , middle , and bottom of radiator from engine side. and of coarse hoses. that should be it.

Jun 11, 2009 | 2000 Chrysler Town & Country

1 Answer

2005 town & country van radiator fan runs after van sits


fuse/relay center underhood possibly corroded internally..lots of issues with these fuse blocks

May 09, 2009 | 2005 Chrysler Town & Country

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

566 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...