Question about 1984 Dodge D150

Open Question

Free wiring diagrams

Both rear signal light flash in rear front signal light work fine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: Right front turn signal and side lights won't turn on when van turns to the right.

Are you sure you have a good ground at those bulbs ? Spray sockets good with cleaner or penetrating fluid, (WD-40 or similar) clean contacts at bottom and try to squeeze or pry outside of socket inward to help get better contact with side of bulbs and see if that helps. If 12 Volt test light confirms power to contact in socket, then I'd be looking for a bad ground. Careful not to touch side while checking contact at bottom of socket or you'll blow a fuse real quick.

Posted on Oct 26, 2008

Ad
  • 290 Answers

SOURCE: needing wiring diagram for 1991 dodge dynasty le

here is what I found:
http://www.the12volt.com/installbay/stereodetail/715.html

Posted on Mar 26, 2009

BPALepine
  • 61 Answers

SOURCE: Driver side signals only work when headlights are OFF

What may have happened is either the headlights wiring or the parking lights wiring somewhere along the wiring fused to the left turn signals wiring. Depending on if the turn signals go on when you put the parking lights on or the headlights on.

If the signals come on when you turn on the headlights than you only need to locate the light green wire that comes off the left turn signal harness.

Next follow that wire the entire way back to the firewall looking for another wire fused to that wire as you go.

If there are no signs of this you need to continue looking on the other side of the firewall all the way back to the turn signal and hazard flasher unit which is a black box that connects to a black harness located next to a grey harness behind the knee bolster.

But if the signals come on when you turn on the parking lights than you will also need to check the wiring from the rear left signal and follow that light green wire all the way back to the turn signal and hazard flasher unit.

This should fix your problem, but if not than your problem may lay within the the wiring between the turn signal/hazard switches and the turn signal and hazard flasher unit.

Also you may have a burnt circuit in the junction block. This block is where the light green from the rear left signal and front left signal meet. Don't have a description but if you cannot find it let me know and I will go out to the yard and look myself and let you know.

Posted on Apr 24, 2009

  • 1 Answer

SOURCE: 2003 Dodge Ram 2500 diesel 4x4 wiring diagram

TPIM PROBLEM , MUST HAVE COMPUTER FLASHED AT DEALERSHIP

Posted on Jun 04, 2009

  • 1168 Answers

SOURCE: I have a 2006 dodge

Hello Durant.
Your rear signal lamps are turned on by the body control module (BCM).
You could have some broken wires from the BCM to the rear signals or the BCM isn't providing power to them. The BCM must be getting a signal input because the front ones are functional.
If you want to trace the wires here are the colors you are looking for.
Left rear wire is white/dark green.
Right rear wire is white/brown.
You may need to have your BCM scanned to verify.
If you would like more information to solve this yourself ask me.

Posted on Mar 27, 2010

Testimonial: "If I gave you 2 thumbs out, I do not know how. I am not used to this system. You need as many thumbs up are available. I do not know how to do that."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My rear turn signals are not working. front turn signals work rear parking lights work brake lights work


In the diagram for rear lamp, the top wires are voltage, the bottom black wire is ground. The brown wire on either side should be tail lamps, goes hot when you turn on the headlamp switch. The other top wire on either should be for turn signal. With everything turned on, is there voltage on that wire?
Because the front works and the rear don't, possible wiring circuit problem? The voltage for turn signals comes from bcm. The bcm knows when you turn on turn signal switch, either side, then the bcm sends voltage to turn signal lamp at the rear and front.

rear-turn-signals-not-working-front-nrw1b5lbo1usuvcsnuvurzx3-3-0.jpg

Oct 17, 2016 | 2009 Chevrolet Chevrolet HHR LS

1 Answer

How can I repair a malfunctioning left front signal light?


The flasher unit for the four ways is separate from the turn signal.
If the rear light is flashing fast means the front light is malfunctioning. Check all wiring from the dash to the light itself. I had one a wire was pinched and had broken

Jul 19, 2015 | Cars & Trucks

1 Answer

How do I find location of junction of signal lights front left signal works rear left staying in right front and rear doesn't work fuses and relay work fine


Go to dealer's service department and they should be able to print the wiring diagram you need. Your problem could be caused by plug and socket bad and the pages would show where all these are in the vehicle.

Nov 23, 2014 | Cars & Trucks

2 Answers

Left back signal light doesn't work but front one flashes really fast


Check and replace the bulb first before you do anything else.

Jul 10, 2012 | 1999 Plymouth Voyager

1 Answer

My vehicle is a 1994 C1500 pick-up. My rear tail lights do not work neither does the rear turn signals or brake lights . The clearance lights do work. The bulbs have been replaced. Is there a fuse that...


check wireing at rear of truck from frame rail to lite and all connections for pulling apart at rear end around bumper area towards front of truck for several feet follow wires up towards front if you dont see any thing wires comea down by master cyl and to frame rail and folllow to rear visal is best good luck

Aug 24, 2011 | Chevrolet 1500 Cars & Trucks

1 Answer

Both rear turn signal lights flash


I did 15a and electrical for over 30 for chevrolet and seen some pretty weird stuff.To me you still have a ground problem.your idea of checking the brake light switch is a good start.both rear lamps flashing to me means the hazards are shorting across the turn and brake light circuits,because hazards stop flashing when brakes are applied.The brakes light switches in the 90's were really weird because they also incorporated the abs system.Good luck,let me know what happens.Thanks

May 26, 2009 | 1991 GMC C1500

4 Answers

Both rear turn signal lights flash


Why don't you just cut 2 wires where you know they're good, add 2 new wires, and run them to the back, and by-pass whatever the problem area is, and your done?

May 01, 2009 | 1991 GMC C1500

1 Answer

Right Turn Signal not flashing.


quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Apr 21, 2009 | Plymouth Acclaim Cars & Trucks

1 Answer

2003 Dodge Ram 2500 diesel 4x4 wiring diagram


TPIM PROBLEM , MUST HAVE COMPUTER FLASHED AT DEALERSHIP

Apr 21, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

Turn signal left front won't flah


I dealt with a similar problem on an 01 Alero (very similar car) and found that the wire that grounds the signal filament of the bulb was broken inside the harness. I tapped into it and grounded it to the chassis and resolved the problem. It's no guarantee but if you have a multimeter, check each wire's continuity to ground as well as the impedance between each of the wires on the harness, on both front signals (for comparison purposes), and it'll show you if you have a problem such as the one I dealt with.

Nov 23, 2008 | 1992 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...