Question about Cars & Trucks

Open Question

07 Ford Explorer Sport Trac P0135 code Replace oxygen sensor did not repair wat would u do

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix my headlights


Search Results

    Explorer Headlight Problem and Interior Stuff - YouTube

    ? 10:53
    https://www.youtube.com/watch?v=f1j-H1dGT4o
    Jan 1, 2011 - Uploaded by justhes
    Explorer Headlight Problem and Interior Stuff ... Thank's to your movie I fix my car. .... 2001 Ford F150 Headlight Switch Replacement - Duration: 5:05. Jon Olson 10,273 views. 5:05. 2003 Ford F-150 4X4 Repair Part #3 The GEM Module ... EXCLUSIVE: 2016 Ford Explorer Sport with Mark Mills at Athens ...

    Replace 2001-2005 Ford Explorer Headlight / Bulb, How to ...

    ? 4:49
    https://www.youtube.com/watch?v=cQJrO0L_tSM
    Sep 16, 2013 - Uploaded by Go-Parts
    Replace 2001-2005 Ford Explorer Headlight / Bulb, How to Change Install ... How To Install Replace Headlight Ford Explorer Sport Trac 01-05 ...

    How To Install Replace Headlight Ford Explorer Sport Trac ...

    ? 4:28
    https://www.youtube.com/watch?v=NzMVcCsZ860
    May 11, 2010 - Uploaded by 1A Auto Parts
    How To Install Replace Headlight Ford Explorer Sport Trac 01-05 1AAuto.com .... I did this on my wifes 2003 Explorer only difference was the screw was a ... Replace 2001-2005 Ford Explorer Headlight / Bulb, How to Change ...

    2001 Ford F150 Headlight Switch Replacement - YouTube

    ? 5:05
    https://www.youtube.com/watch?v=l84h2PUHS0E
    Mar 1, 2014 - Uploaded by Jon Olson
    Headlamp Switch was purchased through Auto Parts Warehouse: ... to help me with my 2001 Ford Explorer Sport-HeadlightSwitch, but the .... Ford F150 Explorer 2000 2001 2002 Overhead Console Repair - Duration: 6:38.




Jan 10, 2016 | 2001 Ford Explorer Sport

1 Answer

I have the check engine light on and the scan read P0135 error - what is this?


P0135 code is: Oxygen O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)

This code refers to the front oxygen sensor on Bank 1.

The heated circuit in the oxygen sensor decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it. The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0135.

Symptoms: You will likely notice poor fuel economy the illumination of the MIL.

Causes: A code P0135 may mean that one or more of the following has happened: O2 Heater element resistance is high Internal short or open in the heater element O2 heater circuit wiring high resistance open or short to ground in the wiring harness.

Possible Solutions: Repair short or open or high resistance in wiring harness or harness connectors Replace oxygen sensor (cannot repair open or short that occurs internally to sensor)

Dec 29, 2015 | 2006 Ford Focus ZX3

1 Answer

My 2005 ford sport trac floods while driveing it or when idles to long


Unlikely to be oxygen sensor. More likely a leaky injector.

Nov 12, 2015 | 2005 Ford Explorer Sport Trac

1 Answer

How do I fix my 07 Ford Sport trac Emission Oxygen sensor?


Check dtcs diagnostic trouble codes, bank 1or 2 sponsor one or two bank one or two sensor one fault = bad sensor, could be be wiring concern, or could be a problem with the ecm. Most likely it is the sensor, this sensor effects fuel/air ratio. Bank one or two sensor two monitors the health of the catalytic converters and does not effective fuel ratio. Same scenario as sensor one could be wiring but most likely you will be replacing the sensor. Post repair clear faults and you should be good to go.

Nov 23, 2014 | Ford Cars & Trucks

2 Answers

How do I replace Oxygen sensor for 07 Explorer Sporttrac


First a question for you? Intake side or exhaust?. Most cars are just a bolt-on type of o2 sensor. If you know which one then simply unbolt it after disconnecting car battery ground and disconnecting o2 sensor. Some sensors from autoparts stores Dont have original plug/jack. You will have to splice the wires/jack to the new one. But if just trying to pass smogcheck I recommend a full tune-up including fitlers for motor and a fuel system treatment. If diagnostic computer says replace probly just replace. Too many things can fail a smog check but no reason stated so this is all I can really say without more info. Good luck.

Nov 23, 2014 | 2007 Ford Explorer Sport Trac

1 Answer

What is PO430 code on 07 explorer trac xlt?


catalyst efficiency below threshold and (bank2).

Try tune up and clean o2 sensor. If that doesn't clear it could be bad cats.

May 29, 2014 | 2003 Ford Explorer Sport Trac

1 Answer

How to clean the MAF for a ford explorer sport trac 2003


there is no cleaning of this with solvents of any kind it will contaminate the sensor. you can blow it out with air but if it is acting up and setting a code replace it. hope this helps

Jan 31, 2011 | 2003 Ford Explorer Sport Trac

1 Answer

P2195 CODE ON 2003 FORD EXPLORER SPORT TRAC 4.O SOHC. I CHANGED OUT ALL THREE OXYGEN SENSORS, AS ADVISED, AND STILL COMING UP WITH P0171, P0174, AND NOW P2195. HAVE ALSO CHECKED ELECTRICAL CONNECTIONS,...


Hello,
Very common concern with the Explorer, Explorer Sport Trac and Ranger with the 4.0l SOHC engine! The upper and lower intake manifold gaskets fail, causing vacuum leaks..It can be Extremely difficult to detect these leaks, because they only leak intermittently (usually in the AM after a cold soak)... As the engine warms up they seal back up! Sometimes the vehicle will idle rough, surge or stall after initial start up, then the symptoms will clear after it gets to operating temperature... Usually there will be no driveability symptoms at all, except the engine light coming on and setting lean codes.. The gaskets have been redesigned to correct this concern..


Bill Andrade Ford Master Technician/ASE Master Technician

Sep 22, 2009 | 2003 Ford Explorer Sport Trac

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...