Question about 2000 Dodge Ram 3500

Open Question

2000 dodge 3500 ram trouble codes 1693

Trouble codes 1693 and 0500 low power

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2007 Dodge Ram 3500 5.9l

check out the following article:
http://dodgeram.info/tsb/2000/21-08-00.htm

Posted on Jan 31, 2009

  • 29 Answers

SOURCE: Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel

I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours

Posted on May 03, 2009

fingaz22
  • 1068 Answers

SOURCE: Where is Fuel Relay for 2004 Dodge Ram 3500 Diesel Truck

it doesn't have a fuel pump relay it has a fuel pump control unit and it is located on the chassis back quarter drivers side near the tube cross member for chassis on top of chassis rail near bed mount. locate the rear springs front perch and it will be above that on top of rail.

hope this helps. good luck and please ask any question you have.

Posted on Oct 25, 2009

Testimonial: "Thanx for info..no wonder I couldn't find Relay! "

  • 26 Answers

SOURCE: How to change transmission fluid and filter. 2004 dodge ram 3500

remove trans oil pan. there you will also see your trans filter,

Posted on Apr 11, 2010

  • 1 Answer

SOURCE: 2001 Ram 3500 Truck: replacing powersteering pump on 1999 dodge 1 ton 3...

it is best to remove the pwr st. pump and vaccum pump assy as a unit which is held to the front cover w/2 15mm head bolt and a support bracket on the bottom bolt next to the block @ the pwr st pump. and disconnect all lines. get the seal kit and replace them @ this time. if you don't and just replace the pump you will probably develop an oil leak where the shaft meshes w/ the adapter. 

Posted on Oct 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Miss fire #6 cyl 2000 dodge 3500 van 5.9 egine


100 PSI is way to low, I think you have a burnt valve. Check the cylinder compression on all cylinders, no cylinder should be 5% lower than the highest cylinder pressure measured or the engine will run rough or misfire.

Jan 31, 2017 | 2000 Dodge Ram 3500

1 Answer

I am getting codes P1688 and P0254 on 2000 Dodge Ram 3500. Do these codes indicate I need to change the injector pump?


means u hav too much pressure in pump--shud be inspected by a pro-also a haynes manual is helpful-may need a rebuild--library has chilton books

Oct 20, 2010 | 2000 Dodge Ram 3500

3 Answers

Where is Fuel Relay for 2004 Dodge Ram 3500 Diesel Truck


it doesn't have a fuel pump relay it has a fuel pump control unit and it is located on the chassis back quarter drivers side near the tube cross member for chassis on top of chassis rail near bed mount. locate the rear springs front perch and it will be above that on top of rail.

hope this helps. good luck and please ask any question you have.

Oct 25, 2009 | 2004 Dodge Ram 3500 Truck

1 Answer

Erroe codes on Dodge Ram 3500 Diesel, dually


The 1682 code is - Charging System Voltage Too Low

The 1693 code is - DTC Detected In ECM Or PCM

The 0523 code is - Engine Oil Pressure Sensor/Switch High Voltage

Jun 11, 2009 | 2000 Dodge Ram 3500

1 Answer

Dodge 3500 diesel trouble codes


the code is for low turbo boost which may have been caused by the snow.if you arent detecting any power problems try unhooking the batteries for about 10 min to clear the codes or take it to like and auto zone or advanced auto and have them clear the codes. if the light comes back on you may need to take it to the dealer because it may have a bad turbo ..a bad sensor ...or and air leak in the charge air system

Jan 03, 2009 | 2006 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...