Question about 2010 Peugeot 5008 1.6

Open Question

What is the normal expected rear tyre wear in miles for my Peugeot 508 ,2013 ?

I do not carry any large loads and only use the car privately

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

What is the rate on a 4 ton truck?

You need to contact your local licencing authority. The rate payable might depend on the payload capability or on the gross vehicle weight or even the train weight if it tows a trailer.

In the UK what used to be known as a three tonner became a 7.5 tonne vehicle under European rules (payload vs. GVW) but this applied only to goods carrying vehicles. When used for private purposes such vehicles were known as heavy motor cars and licenced at the same rate as cars.

The rules on such things vary depending on State, region or nation...

May 30, 2016 | Cars & Trucks

1 Answer

How many miles will I get to the gallon in a 2.5litre diesel van engine

Use 25mpg as a rough estimate.

Vans are intended to carry heavier loads and are therefore lower geared than cars. If you have a large van which is heavily laden your mpg may be 18-20 mpg.

Much depends on the size of your van and the weight of whatever you are carrying in it.

A small car sized van of about 1900cc would probably do 35mpg+

A bigger van has more wind resistance and lower gearing. However, a diesel van is your best option

Mar 25, 2016 | Cars & Trucks

1 Answer

How do I keep my transmission from downshifting itself out of overdrive, and turning the O/D On dash light off?

they are supposed to downshift if the load gets too great , like climbing a hill and they do not have to be big hills . a lot depends on the load being carried .5 large adults works a vehicle harder than 1 adult and 5 children

Jan 23, 2016 | 2007 Ford Expedition Eddie Bauer

1 Answer

How to remove a remote starter on a 2008 honda civic

Hello! I'll send you the procedure via e-mail...It is to large through this system...Here is my e-mail, send an e-mail to me which keeps yours private;


Sep 30, 2011 | Cars & Trucks

1 Answer

How to fit a starter motor

Hello! Neil, I have the removal and installation procedures for a starter for your vehicle...It is to large to send via comment...Here is my e-mail (your e-mail will be kept private)...Send a comment and I'll send the procedures in a PDF file saailer

Sep 22, 2011 | 2005 Kia Sedona

1 Answer

SV10 - V6 - Camry no power is getting to my fuel pump the fuse is ok and fuel pump works i can not find a fuel cut or fuel relay. A postion exists however its not in use. All I did was jack it up rotate...

SWITCHES & RELAYS Switches are used in electrical circuits to control the passage of current. The most common use is to open and close circuits between the battery and the various electric devices in the system. Switches are rated according to the amount of amperage they can handle. If a sufficient amperage rated switch is not used in a circuit, the switch could overload and cause damage. Fig. 1: The underhood fuse and relay panel usually contains fuses, relays, flashers and fusible links tcca6p02.jpg
Some electrical components which require a large amount of current to operate use a special switch called a relay. Since these circuits carry a large amount of current, the thickness of the wire in the circuit is also greater. If this large wire were connected from the load to the control switch, the switch would have to carry the high amperage load and the fairing or dash would be twice as large to accommodate the increased size of the wiring harness. To prevent these problems, a relay is used. Relays are composed of a coil and a set of contacts. When the coil has a current passed though it, a magnetic field is formed and this field causes the contacts to move together, completing the circuit. Most relays are normally open, preventing current from passing through the circuit, but they can take any electrical form depending on the job they are intended to do. Relays can be considered "remote control switches." They allow a smaller current to operate devices that require higher amperages. When a small current operates the coil, a larger current is allowed to pass by the contacts. Some common circuits which may use relays are the horn, headlights, starter, electric fuel pump and other high draw circuits. Fig. 2: Relays are composed of a coil and a switch. These two components are linked together so that when one operates, the other operates at the same time. The large wires in the circuit are connected from the battery to one side of the relay switch (B+) and from the opposite side of the relay switch to the load (component). Smaller wires are connected from the relay coil to the control switch for the circuit and from the opposite side of the relay coil to ground tcca6g02.gif
prev.gif next.gif --- I am not aware of an inertia switch on Toyota vehicles. I don't think it's like a ford. Look for a fusible link, fuse, or relay problem.

Jul 26, 2010 | 1996 Toyota Camry

1 Answer

Continental strut retrofit.

Check out " they should have what you are looking for.

Oct 09, 2009 | 1992 Lincoln Continental

1 Answer

Green light ext pwr

The ECT/power light is controlled by the ECT switch on the console. WHat it does is stretches the shift point from 1-2 and 2-3 when you are carrying a large load, or towing something. For maximum fuel economy, the light should be switched off.

Feb 23, 2009 | 1995 Toyota 4Runner

1 Answer

Setting up for a camper

the load rating is why they say you cannot carry camper. Add some load leveling springs and check the load capacity on your tires might wanna upgrade to an "LT" series tire.

Oct 17, 2008 | 1994 Chevrolet C1500

Not finding what you are looking for?
2010 Peugeot 5008 1.6 Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides