Question about Cars & Trucks

1 Answer

While driving my 2008 Dodge ram 1500 the engine quite. After stopping the engine would not turn over... It would not even can... When you turn the key, you will hear two shoot quick buzzes... All the lights in the cab come on... All the fuzes are good... Connections are clean and tight...

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 148 Answers

Check the starter and solenoid. DW

Posted on May 13, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: 1995 Dodge Ram 1500 starter

You said it's a new start that was tested thoroughly, but just wanted to point out that if the drive mechanism is damaged or hung up, the motor may spin but not crank the engine. The drive gear should move out when the starter starts to spin, if it's locked up or turns freely either way, the drive is bad and needs to be replaced.

The other possibility is that the flywheel has some broken or damaged teeth that are preventing the starter from engaging. It may sound far fetched but there are really only a couple of reasons why the flywheel wouldn't be spinning, as a starter has a LOT of torque and shouldn't have any problem at all moving the flywheel.

Posted on Oct 09, 2008

emissionwiz
  • 75797 Answers

SOURCE: 1997 Dodge Ram 1500 transmission will a 1996 interchange

No, the frame is different.

Posted on Nov 30, 2008

  • 6 Answers

SOURCE: exhaust fumes in cab at stop light.

I would suggest taking this to the dealer....it could be coming through the a.c. vents. Since its a brand new truck....let them **** with it.

Posted on Jan 29, 2009

  • 1 Answer

SOURCE: 2004 Dodge Ram 1500 pickup speedometer and odometer quit

I am having the same problem. I replaced the speed sensor on the rear diff. and the problem went away but when i started it the next day the problem came back. If you figure it out let me know.

Posted on Nov 22, 2009

Shorty1_wt
  • 324 Answers

SOURCE: wHERE IS THE iat SENSOR ON A 2008 DODGE RAM 1500,4.7L V8

on the intake manifold passenger side near the front i think

Posted on Jan 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not go in to four wheel drive


Dodge Ram 1500 Questions - 4WD not engaging all the ...

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusOct 18, 2013 - to get it into 4LOW is to 1st get it into HI and then stop and shift it intoLOW. ... I have a 98 Dodge Ram 1500 that I can not get the 4 wheel drive to ... what web site can i go to so i can see how the inside looks on timing gears.

Diagnosing 4WD Engagement Problems on Dodge Ram ...

dodgeram.org > Main > Tech > Maintenance
Nov 1, 2000 - This shift will be easier if you momentarily release the accelerator pedal. Apply a ... Do not attempt to shift to or from 4L while transmission is in gear or clutch is engaged. ... OK, now when you shift into 4WD it gets a little more complicated. .... I have a 97 RAM 1500 Club Cab Sport 4 X4 and I am having

2008 Dodge Ram 1500 Won't Engage 4 Wheel Drive: 20 ...

www.carcomplaints.com/Dodge/Ram_1500/.../drivetrain/wont_engage_4...
Ram 1500 Won't Shift Out Of 4 Wheel Low - Ram got locked into 4 wheel low. Found this ..... It would not go into full time 4 wheel drive or go into 2 wheel drive.

Software Update and Axle Disconnect Actuator ... - RepairPal

repairpal.com > Problems > Dodge > Ram 1500

Feb 08, 2016 | 2004 Dodge Ram 1500

2 Answers

1997 dodge ram 1500 4x4 abs light on runs fine idles good but put it into gear wont go past 35 mph engine running smooth even at 35 mph


Bernard's Blog: Dodge Transmission Output Speed Sensor

bernardsblog.blogspot.com/.../dodge-transmission-output-speed-sensor.h...
Sep 8, 2009 - My 99 Dodge 2500 Ram won't accelerate..transmission is NOT slipping,.... It has been running fine and the check engine light even cleared itself yesterday.... So it wouldn't go into first gear and then 3 minutes later my check engine ... I have a1997 Dodge Ram 1500 with a 5.9L instead of the stock 5.2L. It ...

Dodge Ram Idle and Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Dodge > Dodge Ram Pickup 1500

Aug 17, 2011 - 30 posts - ‎25 authors
Learn more about Dodge Ram Pickup 1500 at the Edmunds.com ... The crank sensorwas put on however it started stalling again. ... The truck starts fine, but will only runat 2000's RPM and only then if .... Then as I start driving about 1/3 of a mile go dead again, I knockout of gear, crank back up immediately.

WILL NOT GO OVER 30MPH WITH PEDLE TO METAL ...

repairpal.com > Questions > Dodge > Charger > 2006 Dodge Charger
I WAS DRIVING FINE AND THE CAR ACTED LIKE IT GOT STUCK IN ... Then the transmission didn't want to change into 2nd gear. .... Whenever i start up my car theabs and esp light turn on and when i try driving it doesnt go over 30 mph even .... in neutral but not it just wont go up hills and i think it has something to do with

Jan 07, 2016 | Dodge Cars & Trucks

1 Answer

Why my A/C condenser fan won t stop running, dodge ram 2008


To clarify, the compressor and fan will run in defrost mode. The compressor and fan runs to dry out the air blowing onto the windshield.
Now if the condenser fan runs in "heat" you may have a problem with the fan relay or the main controller.

Sep 25, 2014 | 2008 Dodge Ram Pickup 1500

1 Answer

2008 Dodge Ram 3.7 cylinder location


standing in front of the engine, number 2 cylinder would be the first cylinder on the left bank.

Apr 25, 2014 | 2004 Dodge Ram 1500

1 Answer

My 97 dodge 1500 ram truck 5.9 starts jerking when driving,when idle the truck starts rev up and wants to go. What could cause this. Engine light has just came on.


Stop by any good parts store (Autozone, Advance, etc...) and have an OBII scan done (fault scan) They do this FREE - this will identify what's troubling your truck. It sounds like a vac leak or crank sensor but that's speculation... Have scan done then you'll know what to look for and you won't be throwing parts at it.

Mar 31, 2011 | 2008 Dodge Ram Pickup 1500

2 Answers

I HAVE A 2008 DODGE RAM 1500 THE SEATBELT LIGHT AND CHIMES WONT STOP EVEN WHEN WEARING SEATBELT, ALSO NOT REGISTERING WHEN SEATBELT IS BUCKLED


sounds like your seatbelt return wiring might be loose check electrical connections and try to pulling the the seatbelt in and out rapidly to free up return mechanicism good luck

Dec 09, 2010 | 2008 Dodge Ram Pickup 1500

1 Answer

99 Dodge Ram 1500 quits running. Guages go to


Sounds like a bad ignition switch.

Jul 25, 2010 | 1999 Dodge Ram

2 Answers

2002 Dodge Ram 1500 A/C Blows Hot When Stopped and Clicking Sound


if the compressor is turning on and and off R1-34 level is low recharge system.

Aug 24, 2009 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...