Question about 2000 Kia Sephia

2 Answers

What is on the btn fuse on a 2000 kia sephia

Car wont start has draw from the btn fuse need to know whats on the fuse to further trouble shoot

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Brake and taillights. Either your brake lights are on all the time, or if your have a trailer hitch the wires for that are messed up?

Posted on May 13, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 57 Answers

Quote: "Since you have isolated which system is guilty you can further isolate the components. Try disconnecting the wires to the tail light assemblies (one at a time) with the fuse in place and see if the draw disappears. Do this with the brake light switch, headlight switch, and even the relays and you may be able to narrow it down to a single component or a certain strectch of wiring..."
https://answers.yahoo.com/question/index?qid=20070213164332AAfd7N5

Posted on May 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 34 Answers

SOURCE: fuse diagram

if you buy the hanes manual it has it in the back

Posted on Nov 30, 2008

StormStrikes
  • 104 Answers

SOURCE: Transmission fluid capacity for 2000 Kia Sephia?

The four speed automatic shows a total fill (that is all the fluid it can hold) is 5.7 Quarts. So if you just dropped the pan and relplaced the filter, you shouldnt need more than 4 quarts and likely you would have a little extra with that.

Posted on Dec 30, 2008

StormStrikes
  • 104 Answers

SOURCE: Cant find thermostat on 2000 kia sephia.

Try tracing out the upper radiator hose from the radiator to the engine. The end that it is connected to on the engine is usually the thermostat housing.

Posted on Dec 30, 2008

  • 3 Answers

SOURCE: 2000 kia sephia clutch

this is a big job for someone who is not mechanically inclined but....here it goes go buy a new clutch new tranny fluid and a haynes manual at the auto parts store your going to have to drain and drop your tranny ... BUY THE CLUTCH WITH THE TOOL theres an alignment tool needed to align the plates n bearings start by pulling off both tires, brakes and both cv axels be sure to remove the intermediate shaft from the tranny on the passenger side (should come out with the axel passenger side only) so do yourself a favor and buy an impact gun with at least 500 ft lbs torque youll need it also have handy your 14mm 17mm and 19mm impact sockets and remember this job usually runs around 1,200 bucks at firestone also DO NOT remove the bolt in the middle of the front springs under the hood just the four around it and the will pop out no prob and wont need to be clamped remove the starter behind your engine its under the oil filter also if your new to this sorta thing its gonna take you about 3 days to do it buy the impact gun if ur in a hurry look at a pawn shop have your flywheel machined its going to be accessible and it needs it hope this helps dont forget the book which you should already have bought anyway its good for your torque specs which you will also need a torque wrench for the clutch also dont crack open ur tranny this isnt a honda

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 motorhome,draining 2 new batteries,unless motor running


For spurious drain situations, put ammeter inline with the battery and then measure the draw that is draining the battery. Remove fuses until the drain goes away. Then when you know the circuit, trouble shoot it specifically to determine where the the problem is.

Apr 09, 2018 | Cars & Trucks

1 Answer

I have a 2002 Hyandai Elantra. It has been dying overnight while parked and nothing is left on. The battery is good I've had it tested. It runs fine.after being jumped but after turning it off it won't...


you have a short in a wire. Best way to trouble shoot this is with a meter on the battery . Pull out on Fuse at a time until the Draw on the battery stops. Then see what that fuse operates and go from there.

Dec 23, 2014 | Hyundai Motor 2002 Elantra

1 Answer

No power to bottom 2 fuses middle row on a 1997 Ford F150 4x4


Hello Suny Gordon,

Just for you... FREE...

I always assume people know These ISSUES
... NOT to SCARE: merely to inform... PLEASE
read the FACTORY WORKSHOP cautions (here)
Ford 150 1997 Workshop Manual


Once you understand the NATURE & RISK
of probing around in wire looms...
ESPECIALLY without EXPLODING those pesky
AIR-BAGs with a simple cross or short....

((Terribly expensive WORK error))....

FREE drawings (and technical service bulletins (TSBs))
are available at BBB Industries website (registration
is required ... these are real drawings): BBB Industries Premium Alternators Starters Power Steering Products

Proper trouble shooting can be ACCOMPLISHED without
AIR-BAG deployment... simply by following the WIRING
DIAGRAMS
...

ALSO...
Reasonably sophisticated NCVT (non-contact voltage testers)
can be utilized in the process... virtually guarantying professional
results (little co-lateral damage... caused by accidental SHORTS & crosses (there ARE reasons talented TROUBLE SHOOTERS
pull down the big money on complex issues... (Care, logic & success... ( It is ALL battery & ground )))).

(((High quality/impedance voltage testers are best))).

I own KLEIN... Cheaper tools are available:
LIMITED TIME SALE Voltage Tester Pen Non Contact with LED Flashlight 12

Jan 03, 2018 | Cars & Trucks

1 Answer

Battery won't stay charged, it is brand new battery, alternator has been checked and it is good, blown BTN 60 watt fuse, on 1994 Mazda Protege.


The 60amp fuse probably is in the circuit between the alternator and the battery. Which would be why the battery is not getting charged.
Someone would need to check for a short in the wiring between the alternator and the battery.

Oct 15, 2012 | 1994 Mazda Protege

1 Answer

2000 kia sephia fuel pump/overheating/not turning over


sorry to tell you but you have a blown headgasket or cracked cylinder head. that is why the coolant blows out of the radiator and the engine won't start due to engine compression getting into the cooling system.

Jun 06, 2012 | 2000 Kia Sephia

Not finding what you are looking for?
2000 Kia Sephia Logo

326 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

79077 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...