Question about 2003 Dodge Caravan

1 Answer

2008 dodge caravan esp and brake and abs lights come on around 12 mph but no codes

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,702 Answers

Could be ABS sensor which is in wheel bearing.You have to replaced bearing to fix the problem.

Posted on May 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tunde007
  • 2382 Answers

SOURCE: ESP/BAS warning light on. went

Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.

If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..

Posted on Feb 13, 2011

  • 422 Answers

SOURCE: Why does the brake light indicator turn on occasionally?

the switch on the parking brake is defective

Posted on Aug 25, 2008

Sgt Fluffy
  • 157 Answers

SOURCE: 2002 Dodge caravan, down shifting hard.

The PO562 is merely a low voltage code. Tranny codes are 700's. It is possible your brakes are dragging and that's forcing a downshift early; hoist it up and check for freewheeling, but I would take it to a reputable tranny shop. Believe it or not, you can ask your Mopar dealer for a recomendation; most dealers do sublet some of their tranny jobs out to independents, esp their used cars. Keep the faith.

Posted on Feb 04, 2009

  • 6 Answers

SOURCE: speedometer intermittent and ABS/Brake light stays on

Vehicle speed sensor located on top of the rear diff at the brake line clamp a single bolt with a wiring harness. replacement from NAPA comes with a new extension harness. use grease on the terminals before assembly.

Posted on Apr 11, 2009

wracefans24
  • 1985 Answers

SOURCE: ABS and ESP BAS is turned on and the fault

C1041 code is-Left Front Tone Wheel Performance
the speed sensor was slower then the other front one to react to something,or the left wheel spun and not the right front one,
or there is a problem in the sensor or wiring

Posted on Nov 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 dodge grand caravan. after short driving time ESP/BAS and ABS and BRAKE lite com on along with the squiggly braking simbol


Could be as simple as a defective ABS sensor or a broken wire,You will have to get the codes checked to locate the wheel or area causing the problem.

May 28, 2017 | Dodge Grand Caravan Cars & Trucks

2 Answers

Traction control light is coming on going around bend at only 50 mph


VWVortex.com - Traction control light flashing, losing power?

forums.vwvortex.com > ... > VW Model-Specific Forums > Golf IV R32

May 20, 2011 - 25 posts - ‎14 authors
So last night I was driving home, went around a pretty sharp turn and my traction control light started flashing for about 5 seconds, then went ... Traction control and ABS light issues
15 posts
Feb 22, 2010
E-Brake warning light stays on -- help
22 posts
Sep 27, 2004
More results from forums.vwvortex.com

Abs and Esp Lights on!? - TDIClub Forums

https://forums.tdiclub.com/showthread.php?t=333091
Oct 18, 2011 - VW MKV-A5 Golf/Jettas. ... Suddenly i noticed that the ABS and the ESP light on the dashboard was on. ... Fuel Economy: 47+ Avg (Passat DSG) 50 Avg (SE Manual) Warm Weather. ... I might suggest that your ABS and traction controlpick up their information ... A bent ring or bad sensor will set both errors. On-and off grinding on hard left and traction control light ...
Nov 3, 2015
ABS brakes activating when slowing down - wheel speed indications ...
Jan 20, 2012
More results from forums.tdiclub.com

Electronic Stability Control - Auto Diagnosis Repair Help


Dec 17, 2015 | Cars & Trucks

1 Answer

The esp bas, abs, traction & brake light come on when I drive


take it to a mechanic! the drive train is failing

Jun 09, 2015 | 2008 Dodge Grand Caravan

1 Answer

The esp light abs lightbas light and brake light came on where is sensor location


What is the question?

What are the codes?

Certainly you have had many times,
when you checked for codes, because
of a vehicle fault

You have to diagnose a vehicle, to find
a problem,you don't throw parts at the unknown

Aug 19, 2014 | 2008 Dodge Grand Caravan

2 Answers

ABS/ Traction control light/BAS & brake light on in 2008 dodge grand caravan


It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

Oct 03, 2012 | 2008 Dodge Grand Caravan

1 Answer

Abs, esp, brake and traction light on


Oh I have exactly the same problem right now!! Machanics are saying the back LH speed sensor is faulty however when they checked the computer there were no error codes. The braking issue has stopped but warning lights have been on constantly for three weeks now :( Its due to go back to the machanic in a few days so they can have another look.... What ended up being the problem with yours?

Jun 19, 2012 | 2008 Dodge Nitro

2 Answers

2008 wrangler. abs, esp and traction control light staying on. checked brake fluid and fuses


Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled. One or some of the wheel speed sensor is disconnected or is being interfered with. This is common for a recent brake job if any occured

Apr 23, 2011 | 2008 Jeep Wrangler

1 Answer

How to get the abs light off


The ABS light only comes on and stays on when a problem like a failed part exists in the ABS system, the ABS control module senses this problem and it disables the ABS brakes and turns on the dash warning light, so right now you have regular brakes, no ABS. So what needs to be done? You must have the ABS control module scanned by the dealer to see what ABS fault codes are in its memory, then a trained technician will perform the necessary diagnostics and repair the system.

Apr 06, 2011 | 2008 Dodge Grand Caravan

1 Answer

Abslight stays on no brake lights


Fuse 12 (10 Amps) may be burned out. Its located in "Junction Block". Losing
fuse 12 would kill the ABS systems and light the ABS dashboard light.

Fuse 11 (20 Amps) may be out. Its located in "Power Distribution Center". Losing fuse 11
would kill the brake lights, and light the ABS dashboard light. If fuse 11 is blown,
check your (3) brake light sockets for shorts of any type, or fuse 11 will just blow again.

Here's your ABS Indicator Light wiring diagram:

archaeology_0.gif

Feb 20, 2011 | 2000 Dodge Caravan

1 Answer

2002 Dodge caravan, down shifting hard.


The PO562 is merely a low voltage code. Tranny codes are 700's. It is possible your brakes are dragging and that's forcing a downshift early; hoist it up and check for freewheeling, but I would take it to a reputable tranny shop. Believe it or not, you can ask your Mopar dealer for a recomendation; most dealers do sublet some of their tranny jobs out to independents, esp their used cars. Keep the faith.

Feb 04, 2009 | 1998 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...