Question about 2012 Dodge Avenger SE Sedan 2.4L 4-cyl. 4-speed Automatic

Open Question

How to remove trim panel around stereo on 2012 dodge avenger

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: how do you remove the door trim panel for a 1999

If you are refer to the door panel there are a couple screws located on the door like there is one were the handle is on the inside and one in the door arm rest then there are a bunch of clips around the outside of the the door which usually can just be pulled out

Posted on Feb 02, 2010

Ad
  • 844 Answers

SOURCE: My 2012 Dodge Avenger has water leaking on the passenger side under neath the dash. I have no idea where it is coming from?

take it back to dealer !!!!! is it water or is it like (smell it ) anti-freeze??

Posted on Sep 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I find the crankshaft position sensor on the 2012 Dodge Avenger 2.4 liter 4 cylinder


Register for free at Autozone.com, and list this Avenger as your car. Then you can look under "repair guides" and find ":component locations" for the sensor. They probably also have removal procedures for helping you locate and remove it.

Oct 07, 2016 | 2012 Dodge Avenger

2 Answers

2012 dodge avenger passager side blows and driver side is hot


My guess would be is that the duct work are the heat vent hose has come lose.

Nov 30, 2015 | 2012 Dodge Avenger

1 Answer

HOW TO REMOVE DOOR TRIM PANEL ON 2012 BUICK VERANO


Most door panels are held to the door with a large 'nail'. You need to get a wide flat blade between the door & panel and gently pry until it pops a nail out. You need to work your way around the bottom and up the sides.
Don't forget to remove the armrest (should be some screw covers, then the screws themselves.

Feb 11, 2015 | 2012 Buick Verano

1 Answer

How to replace the heater core in a 2012 dodge avenger


Most cars now require removal of the whole dash. Buy a shop manual to guide you step by step.

Feb 11, 2015 | 2012 Dodge Avenger SE Sedan 2.4L 4-cyl....

1 Answer

Need to install a driver side mirror 2012 avenger


The whole thing is installed by removing the door panel and then the window and then the bolts that hold the fixture. OR if you are talking about just the glass or something else, let us know.

Aug 30, 2013 | 2008 Dodge Avenger

1 Answer

How do you remove radio, from my 2001 dodge neon, that just went dead, for no reason. I replaced the fuse on the side of dash board. Still nothing.


Safety Precautions
  • Before removing the stereo or any other electrical component, it is vital that you first disconnect the grounding cable from the Neon's battery. The grounding cable connects the battery to the frame or chassis of the vehicle.

    Use a Phillips-head screwdriver to loosen the grounding cable's camp from the negative battery lead. Make sure to rest the clamp away from the negative lead post until the removal is complete.
  • Remove the Dash Trim Panel
  • The dash trim panel that surrounds the Neon stereo needs to be removed to access the stereo. The panel contains, but is not connected to, the climate control knobs on the dashboard.

    Grab the panel at the bottom corners and pry it from the dash. You will likely be able to remove the panel without the assistance of a trim pry tool, but if you are having difficulty removing the panel by hand, wrap a thin cloth around a trim panel removal tool or flat head screwdriver to remove the panel.

    Once the lower edge of the panel is relieved from the panel, you can work your hands (or flat pry tool) around the perimeter to separate the remaining edges.

    Since the panel is not connected to the climate control knobs, you will not need to disconnect the wiring to the knobs. The panel, once free, can be set aside until you replace the stereo.
  • Remove the Stereo
  • The Neon stereo deck is held into the stereo mounting bracket by 10 millimeter bolts on either side of the radio. Remove the bolts and store them in the ashtray for safe-keeping.

    Pull the stereo from the dock. The unit will easily slide from the mounting bracket with an even pull from the left and right of the stereo. Pull the stereo far enough to reach the wiring on the rear of the radio.

    The wiring to the stereo includes the antenna, the power supply and the speaker wires. There may also be patch cables connected if an amplifier is connected to your stereo system. Pull the cables from the stereo. The antenna and power supply are single cables. The speaker wires (and patch cables) will be grouped by wire binders. The plastic wire binders should be pulled as a unit. Do not pull the wires themselves.

    Once the wiring has been disconnected from the stereo, the unit will be completely free from the Neon.

    If you plan to operate the vehicle before installing a new stereo or re-installing the factory deck; reconnect the grounding cable to the negative battery lead. Otherwise, leave the cable away from the negative lead until all of your work is completed.
  • Feb 26, 2011 | 2001 Dodge Neon

    1 Answer

    How do you take of the dash paneling to install a new aftermarket cd player?


  • Disconnect the negative battery cable from the Jeep Cherokee battery with the 10 mm wrench.
  • 2 Remove the five screws on the top edge of the dash panel with a Phillips-head screwdriver.
  • 3 Pry the trim panels surrounding the climate control knobs away from the dashboard with the trim panel removal tool.
  • 4 Remove the trim panel that surrounds the headlamp switches (located to the left of the steering column) with a trim panel removal tool.
  • 5 Remove the two screws behind the trim panel that surrounds the headlamp controls with a Phillips-head screwdriver.
  • 6 Pull the dash panel that surrounds the stereo and covers the instrument panel of the Cherokee, away from the dashboard by hand.
  • 7 Remove the two screws from the stereo mounting bracket. One screw is on the bottom left corner, the other screw is on the top right corner. Each screw can be removed with the 10 mm socket and drive.
  • 8 Pull the factory stereo from the stereo mounting dock.
  • 9 Disconnect the stereo wiring from the back of the factory unit.
  • 10 Connect the Jeep Cherokee factory stereo wiring to a wiring harness adapter. Connect the wiring harness adapter leads to an aftermarket stereo. Slide the aftermarket stereo into the stereo mounting bracket and replaced two screws at the opposite corners with the 10 mm socket and drive.
  • 11 Replace dash panel that stretches across the top of the steering column.
  • 12 Replace the two screws at the top of the headlamp control switch. Replace the trim panel around the headlamp switch.
  • 13 Replace the trim panel that surrounds the climate control knobs.
  • 14 Replace the five screws on the top edge of the dashboard with a Phillips-head screwdriver.
  • 15 Replace the negative battery cable over the negative battery terminal and tighten the cable to the negative lead post with the 10 mm wrench



  • Dec 24, 2010 | 2006 Jeep Grand Cherokee

    2 Answers

    How do I remove the Ster/CD palyer from the dash 2005 Dodge 2500


    the trim plate has to be removed.it is clipped in.then you will see the nuts holding in the stereo.take those off,and the connectors off the back

    Sep 06, 2009 | 2005 Dodge Ram 2500 Truck

    Not finding what you are looking for?
    2012 Dodge Avenger SE Sedan 2.4L 4-cyl. 4-speed Automatic Logo

    Related Topics:

    16 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Dodge Experts

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8273 Answers

    Are you a Dodge Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...