Question about 2000 Chevrolet Impala

1 Answer

2003 impala car won't start

I turn the ignition and it won't fire

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

Cranks? try starter fluid? check for spark

Posted on May 12, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2003 CHEVROLET IMPALA WILL NOT START AT TIMES

I have a 2001 impala with the same problem for years. Took it in many times, replaced battery, alternator, starter, talked about taking the steering column apart. Finally noticed that it never was a problem when I used the original car key. Problem only happened with a key I had made. Started using the original car key and it has never happened again. Other friends have told me similiar results with their cars - a Lexus and a Mustang.

Posted on May 26, 2009

  • 12 Answers

SOURCE: A/c fan blows without car turned on or key in ignition

Either you have connected your wiring incorrectly, recheck all of your wiring connections, Or the power supply for the fan is coming straight from the battery instead of running through the switched relay, most likely the relay is stuck closed allowing the fan to stay on.

Posted on Aug 21, 2009

  • 1 Answer

SOURCE: Replaced ignition switch 2003 chevy impala and car will not start

After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive

Posted on Mar 02, 2010

  • 66 Answers

SOURCE: i have a 2003 chevy impala and my key will not

Do you have battery power? If not, I'm not sure the key switch will unlock.

Good luck.

Posted on Oct 16, 2010

  • 212 Answers

SOURCE: I have a 2003 Chevy Impala and the key won't turn

I have a 2004 impala that did the same thing..the ignition switch needs to be replaced

Posted on Jun 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Drove home last night and this morning my impala 2003 wont start


Security. Turn the key to run. Let it sit for ten minutes, off for thirty seconds. Then try to start. Do this three times for a relearn. Don't try to start.

Sep 07, 2014 | 2003 Chevrolet Impala

2 Answers

My 2005 chevy impala won't start since someone broke into my car


i would say when the person broke into your car they set off the security system which stops the car from starting, the way to reset the security is to put your key into the ignition turn the key until all the dash lights come on and let them stay on about 15 minutes after the 15 minutes have expired turn the key off and wait about 3 seconds and then your car should start. hope this helps.

Jan 29, 2013 | 2005 Chevrolet Impala

1 Answer

Car won't start powerwindows won't work powerlocks won't work all fuses are ok I think when car was boosted they put cables on wrong terminals I tried boosting it will crank but will not start...


check your ignition fuse and relay fuse.also check your master fuses located on the fire wall they are the ones that run from your nattery to your maine master fuse.follow the battery cable the red one all the way to the fire wall and from there it gos to the starter you may have burned thoses fuses out remove the black fuse cover

Sep 09, 2011 | 2004 Chevrolet Impala

1 Answer

"2003 Chevy Impala won't start". Car would not


The alternator is not charging,or the battery wont take a charge.If all accessories work fine when its running after you've boosted it,its likely the battery.
John

Sep 05, 2011 | 2003 Chevrolet Impala

1 Answer

2003 impala everything works won't start won'crank


If you try to start the vehicle and there is a click when you turn the key, but does not start, you may have a solenoid problem. This is usually about 3 inches long and 1.5 inches in diameter and attaches to your starter. Try giving it a sharp tap with a hammer as this is often enough to loosen contact points inside.
Cheers

Aug 13, 2011 | 2003 Chevrolet Impala

3 Answers

I have a 2003 Chevy Impala and the key won't turn


I have a 2004 impala that did the same thing..the ignition switch needs to be replaced

Jun 11, 2011 | 2003 Chevrolet Impala

1 Answer

Hi,please i have 2003 impala some time i try to start it when i turn the ignition and the alarm sign showed up in the centre the car wont start , then i wait 10 min and i try it work ...


Try starting the car, when the security light comes on, leave the ignition switch on for at least ten minutes then switch it off and repeat. On the third attempt to start , the system should be reprogramed.

Jan 09, 2011 | 2003 Chevrolet Impala

1 Answer

Starting


Does a light come on that looks like a lock?? This is GMs Passlock problem. It a fault in the ignition cylinder. The car won`t turn over. If you remove the key, the car will start in 8 to 10 minutes. Some have found that spraying an electronic spray or silicone based spray in the ignition and rapidly turning the key back and forth may help. Repeat this several times. Replacing the ignition switch is an expensive option, but may have to be done.

Jun 29, 2008 | 2002 Chevrolet Impala

Not finding what you are looking for?
2000 Chevrolet Impala Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...