Question about 2000 GMC Yukon XL

1 Answer

Problem with 2000 GMC Yukon XL Blower Motor only runs on high

Blower only runs on high will not run on any other speed.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 549 Answers

Posted on May 12, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: Air Conditioning not running cold on 2005 Yukon XL 2500

bigger hose is usually low side.

Posted on Jun 20, 2009

  • 1 Answer

SOURCE: 1999 GMC Yukon - Blower only operates on high. I

on these models on the harness that plugs into the fan switch goes bad, I changed the switch and found this harness melted together on my 99 yukon

Posted on Jul 19, 2009

c17hydro
  • 2984 Answers

SOURCE: how to replace the blower motor fan assembly in a

Blower Motor Removal & Installation Delphi
Blower Motor Replacement (Delphi)

1fb4643.gif
To Remove:

  1. Remove the instrument panel sound insulator panel (if equipped).
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor insulating cover screws.
  4. Remove the blower motor insulating cover.
  5. Pull the retaining tab down and rotate blower motor counterclockwise to remove.
To Install:

  1. Position the blower motor and turn assembly clockwise until tab locks in place.
  2. Install the blower motor insulating cover.
  3. Connect the electrical connector to the blower motor.
  4. Install the instrument panel sound insulator panel (if equipped).

Visteon

Blower Motor Replacement (Visteon)

878e8d8.gif
To Remove:
  1. Remove the instrument panel sound insulator panel (if equipped).
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor screws.
  4. Remove the blower motor from the HVAC module.
To Install:
  1. Position the blower motor and install mounting screws.
  2. Connect the electrical connector to the blower motor.
  3. Install the instrument panel sound insulator panel (if equipped).

Posted on Oct 02, 2009

ministock48
  • 258 Answers

SOURCE: 1996 GMC blower motor only works on high speed.

more than likely yes the resistor

Posted on Oct 22, 2009

  • 3 Answers

SOURCE: 2002 GMC YUKON XL 1500 MOTOR DIES AFTER GOING

Check the fuel cap!! If the vacuum relief is not working it can impede the fuel flow and cause the engine to shut down or not restart after a stop. Waiting usually gives things a chance to stabalize and the engine will restsrt. When this happens again try loosening the cap and see if the engine will restart.....If it restarts immediately, REPLACE the fuel cap..Do Not leave it loose because this will cause other problems. If it is not the fuel cap the problem may be the filter, the fuel pump, or aome other fuel system malfunction.

Posted on Jan 24, 2010

Testimonial: "Great will try it "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GMC 2004 Envoy blows heat even with blower off ... Why ?


The relay in your blower motor is stuck on, there is a TSB for this issue. Replace the blower motor resistor and you'll be back in business.
How does the resistor get power if the fuse is pulled?
Replacing the resistor will cure both problems. TSB is a technical service bullitin seen below
Subject:HVAC Blower Motor May Run Continuously After Vehicle is Turned Off (Replace Blower Resistor Relay)Models:2004 Chevrolet Avalanche, Silverado, Suburban, Tahoe, TrailBlazer, TrailBlazer EXT2004 GMC Envoy, Envoy XL, Sierra, Yukon, Yukon XLwith Manual Control HVAC (RPO CJ3)Built Prior to August, 2003

Jun 04, 2013 | Cars & Trucks

1 Answer

2005 gmc yukon xl blower is not shutting off. It continues to run after the vehicle is shut off. Any suggestions?


Sounds like a faulty blower motor resistor also check wire connector for melting.Location is next to floor on in heat duct towards the left of pass side feet area.

May 14, 2011 | 2005 GMC Yukon Xl Denali

2 Answers

Blower fan low speeds don't work. Can only get the fan to work on position 3 which is too high. What might have happened such that positions 1, and 2 don't work?


it is the blower motor resistor. I do not know off of the top of my head if it is part of the climate control unit or external for your particular vehicle. However the symptoms match.

Feb 21, 2011 | 2001 GMC Yukon XL

1 Answer

2005 Yukon XL Denali: Heater Blower jsut stopped working?? Is it common for the fuse to go out in these? or something else


Does it work on any speeds? If it still works on high then the blower resistor is bad. On the passenger side under the glovebox is the blower motor and resistor.If possible try wiggling the pigtail plugs that attach to these two components.It is not uncommon to have problems with these pigtails.Also try tapping the bottom of the blower motor to see if it will start working again.If it does The connections are poor and need repaired. If the blower will not work at all check for power at the blower motor pigtail with a test light or dvm. Will be glad to assist further if more assistance is needed.

Oct 26, 2010 | 2005 GMC Yukon Xl Denali

1 Answer

2005 GMC Envoy XL High Speed Blower not working


if the other speeds work it is probably the blower resistor; if applies varying resistance to the voltage running the blower; this allows the fan to run at different speeds; should be located very close to the blower motor; behind a panel under the passenger side of the dash

Jun 27, 2010 | 2005 GMC Envoy Xl

2 Answers

GMC Yukon Denali XL Auxiliary Blower Motor Battery Drain


Could be that the switch itself is shorting and allowing power to flow,if you can get to the switch I would use a voltmeter and see if there is voltage on the output side with the switch off.

May 14, 2010 | 2003 GMC Yukon Denali

1 Answer

Where is blower motor resisteron 2001 Yukon XL


Right next to the blower motor,it controls the speeds only,but it is mounted with two screws,and has about 7 wires plugged into it.It is near the blower,and actually mounts out side,but goes inside to be cooled by the blower motor.

Jan 28, 2010 | 2001 GMC Yukon XL

1 Answer

How to replace the blower motor fan assembly in a 2000 GMC Yukon XL K1500 4X4


Blower Motor Removal & Installation Delphi
Blower Motor Replacement (Delphi)

1fb4643.gif
To Remove:
  1. Remove the instrument panel sound insulator panel (if equipped).
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor insulating cover screws.
  4. Remove the blower motor insulating cover.
  5. Pull the retaining tab down and rotate blower motor counterclockwise to remove.
To Install:

  1. Position the blower motor and turn assembly clockwise until tab locks in place.
  2. Install the blower motor insulating cover.
  3. Connect the electrical connector to the blower motor.
  4. Install the instrument panel sound insulator panel (if equipped).

Visteon

Blower Motor Replacement (Visteon)

878e8d8.gif
To Remove:
  1. Remove the instrument panel sound insulator panel (if equipped).
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor screws.
  4. Remove the blower motor from the HVAC module.
To Install:
  1. Position the blower motor and install mounting screws.
  2. Connect the electrical connector to the blower motor.
  3. Install the instrument panel sound insulator panel (if equipped).

Oct 02, 2009 | 2000 GMC Yukon XL

Not finding what you are looking for?
2000 GMC Yukon XL Logo

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...