Question about 1996 Chevrolet Suburban

1 Answer

Symptoms of faulty starter - 1996 Chevrolet Suburban

Posted by on


1 Answer

Burning smell very slow cranking or no crank at all but the relay is engaging

Posted on May 12, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Symptoms of faulty air flow sensor

  • How to Detect and Clean a Faulty Mass Airflow Sensor ... > Car Repair > Engine Repair 2012-02-24 · Symptoms of a Faulty Mass Air Flow Sensor ... Here are some of the most common symptoms of a faulty mass airflow sensor: ... CARSDIRECT IS AN ...
  • Mass Airflow Sensor: An Easy Fix for Big Problems from a ... news,blog,mass,airflow,sensor,an,easy,fix,for,big,problems,from,a,little,instrument. ... Mass Airflow Sensor: ... What Are the Symptoms of a Faulty Mass Air Flow Sensor?
  • Signs & Symptoms of a Faulty Mass Air Flow Sensor Signs & Symptoms of a Faulty Mass Air Flow Sensor. The Mass Air Flow Sensor is a device used on many fuel injected automobile engines to measure the density of air ...
  • See Bad Mass Airflow Sensor Symptoms on Video embedded · Mass airflow sensor problems can turn on the check engine light. They can also cause a variety of other symptoms before the ... How to clean mass air flow sensor ...
  • How to ' Tell If You Really Need a Mass Air Flow Sensor ...
    • 4 MIN
    2011-08-22 · Video embedded · ... How To Clean a Mass Air Flow Meter and Tell if you really need ... Mass Air Flow Sensor ' Auto Repair ' Wesley Harrison ... Sensor Symptoms ...

  • Videos too.,
  • Go to Bing homepage

    Jul 09, 2016 | Cars & Trucks

    1 Answer

    Symptoms of a starter going bad

    this car has a tsb for starter lever replacement. symptoms are a spinning sound and no start. see dealer for starter lever replacement whole starter does not need to be replaced. labor time is 2.5 hours the arm is 15.00

    Dec 06, 2013 | 2006 Hyundai Sonata

    2 Answers

    Symptoms for a faulty neutral safety switch

    No start (engine doesn't crank with starter motor) in neutral and park position, one or both

    Oct 16, 2012 | Cars & Trucks

    1 Answer

    1996 ParkAvenue Buick want crank turn the key makes no sound but everything comes on radio lights have checked starter, new battery fuses

    GM cars are notorious for faulty anti theft security systems. When these fail, the car thinks its being stolen and shuts down the starter. Most noticeable symptoms are the car not starting, everything else still working, and a light illuminated on the dash that says "security". If you see this light when it doesn't start, then this is 100% your problem. Go to this link for info and ways to fix it yourself for cheaper.

    Aug 09, 2011 | 1996 Buick Park Avenue

    1 Answer

    2002 Ford Taurus-won't start, replaced starter last night, started once, but hasn't since. Battery is good. Any ideas?

    Have you thought of maybe checking the ignition switch that starts your vehicle. A faulty ignition switch will give you the same symptoms as a dead battery or a faulty starter. I hope this helps you out.

    Mar 31, 2011 | 2002 Ford Taurus

    2 Answers

    What causes a P0036 code on a 2005 chevrolet colorado 2.8L?

    P0336 - Crankshaft Position Sensor A Circuit Range/Performance

    Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
    - Lack/Loss of Power
    - Engine Stall
    Possible causes - Harness or connectors (The sensor circuit is open or shorted)
    - Crankshaft position sensor may be faulty
    - Signal plate may be damage
    - Starter motor may be faulty
    - Starting system circuit
    - Dead (Weak) battery

    Mar 03, 2011 | 2007 Chevrolet Equinox LS New Cars

    1 Answer

    Code p1320 code p303 code p732 on a nissian maxiam 1995

    P1320, Ignition Signal, Primary
    If the code was set after the new starter was installed, I'd check the wiring and connections from the starter/solenoid. They may have gotten damaged or the contacts were not cleaned during the install.

    Specifically, 2000-2001 Maxima's have had this problem. It seams as though everybody agrees that the error is caused by the ignition coils.

    P0732, Improper Ratio for Second Gear
    See someone who's familair with those tranny's gear ratio error in one gear might mean it's slipping! Could be a sensor problem though!

    P0303, Cylinder 3 Three Misfire Detected
    A code P0303 may mean that one or more of the following has happened:
    • Faulty spark plug or wire
    • Faulty coil (pack)
    • Faulty oxygen sensor(s)
    • Faulty fuel injector
    • Burned exhaust valve
    • Faulty catalytic converter(s)
    • Running out of fuel
    • Poor compression
    • Defective computer

    Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

    Hope helps (remember to rate this).

    Nov 03, 2010 | 1995 Nissan Maxima

    1 Answer

    Intermitantly, when i turn the key on my 1999 saturn sl2, theres no engine crank, plenty of battery power, justno cranking, i let it cool of for some time and it fires right up, starter going out?

    Could be a starter failing, but more likely a faulty negative battery cable or starter cable connection. Look for corrosion or looseness at the cables. On GM starters, corrosion on solenoid terminals on the starter can often cause these symptoms. On most vehicles over 10 yrs. old, replacing the neg. batt. cable will save many headaches.

    Nov 04, 2009 | 1999 Saturn SL

    2 Answers

    1996 mitsubishi eclipse doesn't start when turning the key. had the starter tested, it was good. all the dash lights come on like normal, but nothing happens. Battery is good and fully charged. Any ideas.

    check for voltage at the small start wire on the starter when cranking the engine--you will need someone help. If there is no voltage you may have a bad neutral safety switch ,which is on the trany have an automatic trans i assume.
    If so try putting in neutral when cranking.

    Oct 08, 2009 | 1996 Mitsubishi Eclipse

    Not finding what you are looking for?
    1996 Chevrolet Suburban Logo

    Related Topics:

    30 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts


    Level 3 Expert

    80339 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides