Question about Jeep Grand Cherokee
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Daihatsu Sirion
I assume you are changing the timing belt. I am a mechanic and although not familiar with your vehicle, you would usually locate the timing mark on the bottom pulley and line this up. Careful not to turn the engine over too hard as pistons can strike valves. then you should look for similar marks on the camshaft pulley[s], and line these up. Then fit belt. This has to be tensiond correctly which is important. Hope this helps. Mike the bike01.
Posted on Aug 19, 2008
SOURCE: 1999 Daihatsu Sirion
Your engine is probably an EJ-DE twin cam 12 valve.
Generally Daihatsu belts have marks on them that line up with dimples on the sprockets for the intial phasing. You rotate the engine to top dead centre on No1 piston and install the belt from there. The cams should be not be putting any pressure on the intake and exhaust valves of No1 when phased correctly.
Posted on Oct 10, 2008
THERE IS NO CAM BELT , THE TIMING BELT IS TURNED BY THE CAMSHAFT , THE POWER STEERING IS POWERD BY THE CRANKSHAFT PULLY WHICH ALSO POWERS THE ALTERNATOR,
Posted on Oct 25, 2009
Hi, the light is basically telling you that there is a problem with a sensor or the sensor circuit. Find the eobd 16 pin plug and bridge the fourth pin on the top and the fifth pin on the bottom row with the ignition off. Now turn the ignition on and the light will flash and display codes. The series of first flashes indicates tens n the second series shown after a longer pause between flashes. Eg code 21 would be 2 flashes then a pause and one flash thereeon. The codes can be gotten from toyota nation. This will direct you to which sensor is faulty. Once the repair is done pump the pedal eight times and the light should blink constantly. Now turn off the key and pull out the bridging wire. Enjoy!!
Posted on May 18, 2011
Tips for a great answer:
Jan 13, 2018 | Toyota Paseo Cars & Trucks
Dec 02, 2015 | Daihatsu Cars & Trucks
Jun 13, 2015 | 2005 Daihatsu Sirion
May 27, 2015 | Daihatsu Sirion Cars & Trucks
Jul 27, 2014 | 1999 Daihatsu Sirion
Jul 17, 2014 | 2005 Daihatsu Sirion
Jul 17, 2014 | 2005 Daihatsu Sirion 1.3
Jun 19, 2014 | 2006 Daihatsu Sirion 1.3
Feb 03, 2013 | Daihatsu Sirion Cars & Trucks
Feb 03, 2012 | 1998 Daihatsu Sirion
32 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: