Question about 2001 Dodge Durango

1 Answer

Remove 4x4 transmission of a dodge durango 4x4

2001 dodge durango 4x4

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 37 Answers

A lot of those dodges have electrical solenoid shift pack assyemblies that cause the vehicle not to shift the kit comes with 4 solenoids and wires

Posted on May 16, 2014

  • colleen_cark
    colleen_cark May 26, 2014

    a lot of those dodges have electrical solenoid shift pack assemblies that cause the vehicle not to shift the kit comes with 4 solenoids and wires

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: transmission code PO753, how to repair?

PO753 code on a Durango can also be caused by a bad transmision relay in the relay -fuse block behind the battery in the engine compartment. (relay # 31 on 1999 Durango) Before you attempt to replace the 3-4 solenoid, or take to a transmission shop, try changing the relay out with another known good relay, reset the code and try it. I learned this today from an honest transmission shop. Shifts normally again, check engine light is out, and the shop did not charge me a dime. Kudos to Trans Medic in Gresham OR.

Posted on Apr 23, 2009

Cutlass85
  • 10 Answers

SOURCE: loacte the fuel filter on 2000 dodge durango 4.7 liter v8

if i am not mistaken the fuel filter is built into the fuel pump. which requires you to drop the tank and replace both.

Posted on Jun 01, 2009

  • 87 Answers

SOURCE: 2005 dodge durango 4x4 I changed the transmission

no you likely cut an o ring on the filter not allowing the pump to build pressure

Posted on Sep 16, 2009

  • 1 Answer

SOURCE: my 2001 dodge durango is overheating an leaking coolant from a round plug type thing in the corner on the passenger side near the windshield

What exactly is the "round plug type thing" near the firewall [passenger side]? Is it a sensor of some type? I, too, have a coolant leak here on my 2001 Durango; its tucked in rather tightly near the hood/firewall corner. My electric fan is not kicking on; vehicle overheated tonight. (4.7 liter)

Posted on Dec 28, 2009

  • 196 Answers

SOURCE: how hard is it to replace the front drive shaft on

Not hard at all. If you climb under it and look, you'll see where it mounts to the front differential and to the transfercase. Grab some tools and have at it! Pretty simple job.

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removal of transmission on 2001 dodge durango 4x4


honestly there is a lot of work to do this job, A LOT!!!! to list every step would take forever so maybe try getting a vehicle specific service manual

May 12, 2014 | 2001 Dodge Durango

1 Answer

Best way change oil pump in 1999 dodge durango


You have to remove the oil pan. It is different for 2wheel drive and 4 wheel drive. In either case, you have to jack up and support the engine. Most of the time you must also remove the transmission rear mount so you can jack up the transmission also in order to get enough clearance to get the pan out between the transmission bell housing and the frame crossmember.

On 4X4 vehicles, you must also first remove the skid plates and the front drive axle to get the oil pan off.

Dec 13, 2010 | 1999 Dodge Durango

1 Answer

Where is the bcm(body control module) on a 2001 dodge durango and what does it look like? all of my electrical is going bad like my parking lights wont turn on my control pannel lights wont turn on and my...


BCM on the 2001 durango was also known as the CTM but regardless it is located on driver side kick panel where your left foot would be if you are driving. there is two screws to remove panel. its a black box with three plug ins.

Oct 06, 2010 | 2001 Dodge Durango

1 Answer

How do you remove the front shocks on a 2004 Dodge Durango 4X4?


how do you remove the front shocks on a 2004 durango limited 4x4. the stabilizer bar and axle links appear to be the way for removing the lower shock mounting bolt

Apr 29, 2010 | 2004 Dodge Durango

1 Answer

Looking for the transmission removal procedure for a 2005 dodge durango 4x4 automatic ?


Why do you need to remove the tranny. How many miles on the Durango? If you are under 70k miles and are the 1st or 2nd owner and paid the xfer fee to have the 7/70 warranty put into your name, your local dealer will make the repair for $100.

Apr 19, 2010 | 2002 Dodge Durango

1 Answer

How do you replace a transmission solenoid on a 2001 dodge durango


I have a 2000 dodge durango 4x4 The transmission works good most of the time but some times it will take off in high gear if i pull the lever down it will go down a gear but if i stop and shut the key off and re start it will work good again some times for a long while and some times for a short while. I just took a 400 mile trip no problem it has been doing it for a long time off and on i have serviced it once a year and have had it since it had 15th miles and it has 200th miles now fluid is clean .I tried another TCM with no luck Thank you Jeff

Nov 07, 2009 | 2001 Dodge Durango

1 Answer

2001 Dodge Durango 4.7L 4x4. A/C is on but no air


Check the resistor pack next to the air motor blower, after you check the fues's the resistor pack is most likely blown but to be sure turn it on to heat and try the blower motor if it still does not run remove the restior pack and look and see if they are burned out, it will look like a fues thats blown. Two 1/4 screws holds it on and has 4 or 5 wires in it. If you need more help please post here.

Sep 05, 2009 | 2001 Dodge Durango

2 Answers

What kind of tranny will work to replace mine?


Yes. They should both be 46RE transmissions and the bolt patterns and the plugs should be the same.

Jun 20, 2009 | 1999 Dodge Durango

1 Answer

TRANSMISSION PROBLEMS IN A 00 DURANGO 4X4 5.9L V-8


they had alot of pump problems on those early model transmissions, you need to go to chrysler to get "Updated" Pump!!!
don't be cheap, chrysler trans are very sensitive!!!

Jun 15, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
2001 Dodge Durango Logo

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...