Question about 2007 Dodge Sprinter

2 Answers

2004 sprinter 2500 fails to start and displays starting error, when this happens, usually the remote entry system using the key won't work either. Engine will not crank. wiggling the positive battery cable has caused a clicking sound, and then engine started normally. this problem has been intermitant and no definite diagnostics seem possible. This spinter has a second battery installed after purchase by a non-dodge dealer shortly after purchase and has run fine up until last November when this trouble started...Screamer module checks ok. If anyone has any ideas about what this problem is, please, please contact me at melcat33@gmail.com. Thankyou in advance for your consideration.. current mileage when trouble started was 360K. This has been a very good van except for this problem...please help...mel 563-940-6659

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 341 Answers

I know it sounds simple but I would replace both the battery cable ends with quality new ones or replace both positive and negative battery cables with the new ends attached. Hope this helps.

Posted on Jun 23, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check your fuses and capacity of batteries.
If the voltage of your batteries is down everytime check if there isnt a bug in your relay for preheating diesel engine.
This start / error could be if the voltage drops to much on starting the engine.
In my case there where a short-circuit in electric.

Posted on Jul 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE A 2004 KIA AMANTI AND IT WON'T LET ME IN AND THE BATTERY IS DEAD HOW CAN I GET INTO THE CAR FROM THE OUTSIDE WITHOUT THE REMOTE OR KEY? I ALSO CAN NOT GET UNDER THE HOOD.


This sounds all to familiar. I was an owner of one of these 2004 amantis as well. If youre 100,000+; sell it before the real problems start. Its a design flaw; I just about flipped when mine did this so I have been there. Only way is to slim jim the door and then pop the hood& pray for power after jumping. The key in the door wont work bc its electric; same goes for key faub, all keyed entry doors,& the trunk! I dont know what these guys were thinkin or smoking when they designed this model. Good luck!

Sep 25, 2012 | 2004 Kia Amanti

1 Answer

Why won't my 2008 Chrysler Aspen start?


You have 2 issue going on. Its not seeing a valid key,and it is starting with the remote.Your remote entry key did it happen to get wet? Or moisture get in? Lock the vehicle up using the key. enter the vehicle using the key fob.After the vehicle unlocks you have 60 seconds to enter the vehicle insert the key in the ignition start it up.Your remote start up is out of step.

Mar 10, 2012 | 2008 Chrysler Aspen

1 Answer

2004 Hyundai Elantra won't start, emergency flashers keep blinking, can't shut off, lights dim, can't jump start, clicking from under dash from relays. What could it be?


The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.

Sep 06, 2011 | Hyundai Elantra Cars & Trucks

2 Answers

I have a 2004 Sprinter. When I first purchased this used van, all was good.By the third day I experienced a no start condition that lights up security code on the dash. Disconecting the battery and...


I would try replacing the vehicle battery. A low or shorted battery can wreak havoc with your computer system. I have seen them cause no-starts when interrior lights, ect look fine. When the system is doing goofy things like you are describing, it is usually caused by a bad/shorted battery or losse/corroded battery cables.

Poeple tend to forget that NOTHING works properly if the battery is not working properly.

Feb 20, 2011 | 2004 Dodge Sprinter

1 Answer

2004 DODGE RAM 2500 WON'T START. LIGHTS AND EVERYTHING ELSE COMES ON, SEEMS LIKE IGNITION IS LOCKED OUT. MY DAUGHTER WAS PLAYING WITH THE REMOTELSS ENTRY PRIOR TO THIS. NOT SURE IF IT IS RELATED.


Unles its an aftermarket alarm system, which requires a turn-off switch or just pressing the brake pedal upon starting, you shouldnt have a prob w/ a factory remote. However, it could be the starter has gone out, a coil over plug is gone. Check your fuses to see if any are blown. Good luck!

Feb 06, 2010 | 2004 Dodge Ram 2500

1 Answer

Schematic belt diagram 2004 dodge sprinter 2500


search on internet, mercedes om 612 engine diagram

Sep 21, 2009 | 2004 Dodge Sprinter

1 Answer

My car wo'nt start.


Your ignation key and Engine Control Unit behind the cluster linked to each other, UCU has to repaired and key must be re-coded. it can not be done by your local friendly mechanic, its electronic fault.

Aug 23, 2009 | 2006 Dodge Sprinter

5 Answers

2006 sprinter 2500 trouble starting


placed vehicle on top of mountain,, pushed it off cliff, cause no one could find a solution.....

Dec 14, 2008 | 2006 Dodge Sprinter

Not finding what you are looking for?
2007 Dodge Sprinter Logo

591 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...