Question about 1992 Mitsubishi Diamante

Open Question

How do I remove the back seat from 2000 mitsubishi diamante?

I need to remove the back seat to gain access to the trunk

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: where is the starter located on a 2000 mitsubishi diamante?


Posted on May 15, 2009

  • 1 Answer

SOURCE: 1997 mitsubishi diamante stereo code

need a radio code for a 1997 mitsubishi diamante

Posted on Jul 27, 2009

  • 1111 Answers

SOURCE: 2001 mitsubishi galant trunk problem

yes a screwdriver or pliers depending if you can see the lever from where the key fits from .just turn it or open the lock itself

Posted on Aug 24, 2009

  • 1068 Answers

SOURCE: How do I remove the radio from my 2000 Diamante

c2a3dd2.jpgthis is the best i can do for a diagram. it is the easiest to explain how to do this job.

Posted on Feb 22, 2010

  • 151 Answers

SOURCE: my2001 Mitsubishi Diamante sunroof wont close i

Does the sun roof do anything whebn you press the button. if not, check your fuses and the sun roof switch. If fuses are good you want to check to see if the sun roof motor is getting power. If it is getting power it could be the motor itself. If it tries to move but can't then you have a mechanical problem. it might be binding so try giving it an assist by pushing on it when pressing the switch.

Posted on Feb 28, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Can I access the fuel tank without dropping the actual tank in a 1996 Mitsubishi Diamante

If there is an access panel it is either in the trunk under the carpet or under the back seat. Very few cars have them so don't be suprised if it doesnt. It will be an obvious panel held on by a handful of screws

Jul 31, 2016 | Mitsubishi Cars & Trucks

2 Answers

How do you get a 2000 dodge neon trunk open when the key won't work? No button in glove box.

The only other way I can think of is to remove the back seat to gain access to the trunk latch.
Otherwise, a locksmith would be my next solution.

Aug 28, 2011 | 1995 Dodge Neon

1 Answer

Trunk wont open on a 2000 mitsubishi diamante with key, remote nor latch in driver side. how can i get to trunck through backseat?

I don't know if yours has it or not, but on later models you can pull down the center arm rest/cup holder in the back seat. Behind that is a small panel or door that you can open that leads to the trunk area. If you reach inside the opening and to the left, there should be a pull handle to release the trunk lid.

Jan 28, 2011 | Mitsubishi Diamante Cars & Trucks

1 Answer


I gather that you are also locked out of your car, or you could use the trunk release. If you are able to get inside the car, remove the bottom part of the back seat. Then you will see the bolts holding the seat back in place. Remove the bolts and pull the seat out far enough to gain access to the trunk. If you are locked out fo your car, you could try a wire coat hanger pushed down through the driver's door weather stripping at the top of the door. You may have to pry the top of the door out a little and wedge something in there to hold it out. Shove the coat hanger through the weatherstripping and try to activate the door locks or the trunk release.

Jan 19, 2011 | 2000 Ford Focus

1 Answer

Trunk is full of Christmas presents and clothes....trunk do will not respond to opener or key fob.

Access the trunk via the back seats, remove the rear seat base first then the back rests to gain access to the trunk

Dec 27, 2010 | 2007 Lexus GS 350 AWD Sedan

1 Answer

How do you remove old brake bulb

Assuming your Diamante is constructed similarly to my 03 GTZ you will need to remove your tail light assemblies in order to replace the bulb. To do this you will need to remove the carpeting on the rear wall of the trunk to access the nuts holding the assemblies on. Remove the nuts on the inside of the trunk and the assemblies will just pull off from the outside giving you access to the bulbs.

Sep 22, 2010 | 2002 Mitsubishi Diamante

2 Answers

How do I fold the back seats of 1999 or 2000 cougar to gain access to trunk? key is lost.

There is a knob behind each seat that you need to pull out and push the seats down at the same time...

May 29, 2010 | 1999 Mercury Cougar

2 Answers

Mitsubishi diamante trunk won't unlatch with the key or the electronic door switch. It worked yesterday to put stuff in and when we got back it made a click noise but did not open. After that it would only...

your diamente, has split rear folding seats, however I can't remember how it operates, I believe the release is on the seat inside the car. you can gain access to the truck this way and there is an emergency trunk release (red handle) inside the trunk.. you can use this to open the trunk.. after you open it check all you mounting hardware for loose bolts or damaged hinges, it sounds as if it has shifted and the latch although is functioning it cannot release the trunk or the mechanism itself is not fully operating

Mar 26, 2010 | 1999 Mitsubishi Diamante

1 Answer

On the Jetta 2000 TDI, does the back seat flip down, enabling access from the trunk? Like a hatch back, I mean/.

Yup - each seat has a latch and you can gain access to the trunk... the seats can fold flat if you take off the headrests

This has been good for me since sometimes my trunk key or automatic opener doesn't work and I need to access the trunk from the car

Aug 21, 2009 | 2000 Volkswagen Jetta TDI

3 Answers

Replacing fuel pump need to remove rear seat need to know how

First you will need to releave fuel pressure......

next remove the rear seat cushion to gain access to fuel pump access panel.....

Removing Fuel Pump....

Jan 29, 2009 | 2003 Mitsubishi Outlander

Not finding what you are looking for?
1992 Mitsubishi Diamante Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides