Question about Mercury Sable

Open Question

Mercury sable 1994 3.8l v6 spark plugs - Sable Mercury Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: how do i reach the rear spark plugs on the 24v 3.0L 1999 Mercury Sable

I recently did a tuneup on my 88 sable, and the back spark plugs were a pain to get to. However, it didn't require any special procedures. You may want to try getting a SMALL ratchet extension to avoid jamming your wrench into the firewall, because without one you won't be able to get far enough into the spark plug seat and a normal sized extension will prevent you from getting in at all. You could also try an appropriately sized deep socket (sorry I can't remember what size the plugs are) and use that instead of a spark plug socket. Just try to use the spark plug socket to put the new ones in, or you may damage the connectors using a normal socket.

Posted on Jun 26, 2008

  • 1 Answer

SOURCE: 2001 Mercury sable bad idle

CHECK THE PCV VALVE HOSE THAT CONNECTS AT THE BOTTOM OF THE THROTTLE BODY, THESE HOSES ARE KNOWN TO DETERIORATE AND ALLOW UNMETERED AIR TO ENTER THE COMBUSTION CHAMBER, WHEN THIS OCCURS THE OXYGEN SENSOR'S SIGNAL TELL THE PCM TO INCREASE THE PULSE WIDTH OF THE INJECTORS CAUSING THE VEHICLE TO ALMOST STALL.

Posted on Feb 27, 2009

  • 202 Answers

SOURCE: changing rear spark plugs

yes you have to take your front motor mount out and come along the motor forward you do not need to take the intake off

Posted on Apr 21, 2009

alicantecoli
  • 22114 Answers

SOURCE: firing order for 99 mercury sable 3.9 v6

153624

Posted on Apr 05, 2010

SOURCE: looking for firing order for 3.0l v6 mercury sable

1-4-2-5-3-6

Posted on Apr 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Plugs and wires 2005 mercury sable


What engine do you have, I will assume a DOHC V6, the DOHC V6 doesn't have spark plug wires, each spark plug (located under the igntion coil) has its own separate ignition coil, it is called direct ignition. You unbolt the coil and remove it with the attached spark plug boot and then you remove the spark plug from the cylinder and replace, do one at a time.

Nov 07, 2016 | Mercury Cars & Trucks

1 Answer

Where are the spark plugs


if it is a V6 or V8 the spark plugs are always on both sides so look down on both sides of your engine and you will see the spark plug wires going to them

Apr 18, 2012 | 2001 Mercury Sable

1 Answer

How do i change the rear spark plugs on the v6 3.0 liter dohc engine?


You will have to remove the intake to be able to get to it to change the plugs.

Feb 11, 2011 | 2002 Mercury Sable

1 Answer

Change spark plugs on a 96 sable v6 dohc, how much do I need to take apart to change them and should I just take it in?


actually if i was u i would take it in cus to get to the back 3 spark plugs u have to drop the back of the motor down about a foot or so until u can reach the plugs, or take the intake manifold off. either way its a pain in the ****. but its up to u. good luck to u and i hope this helps u

Jul 05, 2010 | 1996 Mercury Sable

1 Answer

Digram of firing order for spark plugs, for 1991 mercury sable


For the 1991 Mercury Sable 3.8L V6:

Firing Order:
1-4-2-5-3-6
Cylinders:
.....(back)....
|...1...2...3...|
...................
|...4...5...6...|
......(front)
Distributor:
....(back)
......6..(+)-screw
1..........3
4..........5
(+)...2
....(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Apr 18, 2010 | 1991 Mercury Sable

3 Answers

Need serpentine belt diagram 4 merc sable 3.0


...are under hood, a diagram on top of radiator support.

Feb 12, 2010 | 2004 Mercury Sable

1 Answer

How do you get to the spark plugs on the back of the block on a 2005 Mercury Sable w/ a 3.0L V6 engine?


you have to reach around from up top, no special tricks. just a little maneuvering and some skinned knuckles.

Nov 17, 2009 | 2005 Mercury Sable

1 Answer

Need spark plug gap for 94 Mercury Sable 3.0L


Listed in the owner's manual and under the hood on a placard. Also the parts store where you buy the plugs can supply this info.

Mar 18, 2009 | 1994 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...