Question about 2007 Ford Freestar Limited Minivan

Open Question

How do you fix a rear wiper motor 2007 ford freestar

Rear wiper

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnny5846
  • 379 Answers

SOURCE: 2003 Ford Explorer-Rear Wiper Motor-How to Replace?

the plastic panel pops off , if you had a trim removal tool it would be nice but it can be improvised , they are just tension clips , get some kind of lever behind the panel and give it a pop , once the plastic panel is off its pretty much self explanatory from there , a connector and couple small bolts , now the outside has nut under the w/w blade , a piece of the arm cover pops up to access the nut , remove w/w arm , then a grommet and under the grommet is a bigger nut that helps hold the motor onto the door/hatch , when reinstalling before you put the w/w arm back on run the wiper and make sure it shuts off and in the park position . should be a piece of cake .

Posted on Jan 05, 2009

  • 4369 Answers

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal

  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Posted on Apr 10, 2009

  • 86 Answers

SOURCE: Need to change a rear window wiper motor

Remove the outer wiper arm. Remove inner tailgate coverings. Disconnect wiper electrical connector and retaining bolts to remove. Installation is reverse of removal

Posted on Apr 25, 2009

  • 718 Answers

SOURCE: Rear wiper Ford Explorer 1998 won't work.

Look for the fuse for the rear wiper motor is a 15 amp mini-fuse , in location # 8 of your POWER DISTRIBUTION BOX in the engine compartment. Check in the PD BOX for; - relay # 8 is the rear wiper down relay , and - relay # 10 is the rear wiper up relay .

Posted on May 18, 2009

  • 1 Answer

SOURCE: 2004 ford freestar rear hatch latch broken

have you fixed yours yet? mine started doing this last year

Posted on Mar 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What type of fuse is used for a 2007 Eddie Bauer Ford Explorer rear windshield wipers and where is it placed?


Your owners manual will give you fuse location and identification for the rear wiper. Most likely a wiper motor problem though. Turn on rear wiper and grab rear wiper arm and see if it will move at all. If it does move a bit or starts working....the motor is the problem

May 01, 2015 | 2007 Ford Explorer Eddie Bauer

1 Answer

Service brake master cylinder on 2004 Ford Freestar SE.I am replacing the rear brakes and will need to bleed them But I am unable to locate/get to the master cylinder..Help


The master cylinder is on the drivers side, under the windshield wiper cowling. I remove the cowling. Remove the wiper arms, Remove the six screws in the cowling, pull it off. Remove the ten MM nuts by the windshield, remove the 13 MM bolts on the fire wall. Unplug the wiper motor. Pull out and up at the same time. This would be a good time to replace the valve cover gaskets also. They always leak on the back side, because of the heat.

Nov 15, 2014 | 2004 Ford Freestar

1 Answer

2007 ford freestar their is no blower operation resistor board is okay replaced blower


you may have to have the GEM module checked out as I believe it controls heater control operation.

Aug 29, 2014 | 2007 Ford Freestar Limited Minivan

1 Answer

How can I fix the rear window wiper balde on my Freestar. When we turn it on, it goes down the door under the window and stays there.


All thats wrong is the 13 mm nut has come loose. Make sure the wiper is turned off, remove the cover of end of wiper. Remove arm, reset in place where it would be at rest (not moving). Reistall nut and tighten. You should be good as new

Apr 25, 2011 | 2006 Ford Freestar

2 Answers

How do i get to the rear spark plugs & coil pack on my 2005 Freestar


the coil pack is in the front, but the back plugs can be done (not easily) by removing the 'shelf' over the top of the rear cowl and removing the wiper motor assembly. I hope this helps - rate my answer to let me know and to help others with the same problem

Feb 05, 2011 | 2004 Ford Freestar

1 Answer

2004 Ford Freestar without power to the internal fusebox for both front and rear wipers


Hello sixnuef: My name is Roger and I will help. There are 4 fuses for the wiper system two for the front and two for the rear. In the fuse box under the dash to the left of the steering column.there are two fuses F2.3 and F2.7. Under the hood in the bussed electrical center there are two more fuses. Fuse F1.54 and F1.55. Check all fuses as if one is bad then that part wont work.If the fuses are good then you will need to check for power to the multi function switch. If you have power to the wiper switch but none out. The problem most likely is the switch. Should you need further help please just ask. Pleas rate the answer. Thank You for using Fix Ya. Roger

Feb 01, 2011 | 2004 Ford Freestar

2 Answers

Expansion valve 2004 ford freestar where is it located


they no longer use expansion valve.it has been replaced by a FIXED ORFICE TUBE

Sep 24, 2009 | 2004 Ford Freestar

2 Answers

Front Windsheild Wipers


I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal
  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Apr 09, 2009 | 2006 Ford Freestar

2 Answers

Rear wiper stopped working


my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

Feb 25, 2009 | 2004 Ford Expedition

Not finding what you are looking for?
2007 Ford Freestar Limited Minivan Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...