Toyota torque settings for toyota cressida - 1987 Toyota Cressida

Here is a torque setting site for you to look at.
http://www.championbrands.com/aera-torquespecs.pdf

Toyota Camry Cressida OBD Trouble Codes -

www.troublecodes.net/toyota/toyota-camry-cressida/

Get Help at BAT Auto · Get an ALLDATAdiy Repair Info Subscription ... Toyota Camryand Cressida have two separate diagnostic connectors and two separate diagnostic modes which both provide ... 92-95 Camry 2.2L Engine Code: 5S-FE ... 31, Volume air flow (VAF) sensor-Cressida -circuit, Wiring, VAF sensor, ECM.

petrtol engine alloy head then around 65 if this oldie is cast iron head then 75 is ok but a higher setting can be used to make sure its down and you dont have to do it again after a set time of say 85/90

torque converter drive plate splitting around the bolts

Cylinder head bolt removal sequence


Removal sequence: Front 3 7 11 13 10 6 2 1 5 9 14 12 8 4

***CAUTION*** The above sequence must be followed during removal as to avoid warpage of the cylinder head unit

Reverse sequence to install, Step 1: Torque to 10 Ft/Lbs Step 2: Torque to 18 Ft/Lbs Step 3: Torque to 25 Ft/Lbs Step 4: Turn an additional 90 degrees Step 5: Turn an additional 90 degrees Step 6: Torque the 2 recessed 8mm bolts to 13 Ft/Lbs *** CAUTION *** engine uses Torque To Yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts must be used when cylinder head is replaced or re-installed to obtain proper Torque

Don't forget to rate this answer, Good Luck

if you call auto zone they will be able to give you the torque specs. and the pattern... or you can go to the library and look in the chilton or haynes manuals...

Around 700, to 900 rpm

I would not even think about trying! If everything is not 'exactly' the same, don't put yourself through this! Frankster016