Question about 2005 Dodge Stratus
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: engine light and battery light
No, and a new battery may not cure the battery light being on. A low or no charge condition will turn the red battery light on, a bad battery will not. A low charge condition could have turn the check engine light on. I would have it checked before I would start replacing parts.
Posted on Jan 31, 2009
P0442 is a medium evaporative system leak detected. Check your gas cap and make sure it is on tight and the rubber seal is in good shape. If it was loose, tighten it and the check engine light will exstinguish after a few days on its own. If not this usually means there is a small hose in the system that has developed a small split. It could be several other things as well, it is "usually" a hose. You need to take it to a shop that can proform diagnostics to locate the leak.
Here is a list of possable causes;
LEAK AT GAS CAP
EVAP PURGE SOLENOID OPERATION
INTERMITTENT LDP MONITOR FAILURE
EVAPORATIVE EMISSION LEAK DETECTION
LDP COMPONENT LEAK
Posted on Jun 14, 2009
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
Posted on Oct 18, 2009
jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you
Posted on Apr 13, 2010
Tips for a great answer:
Jul 03, 2016 | Dodge Cars & Trucks
Mar 26, 2016 | 2005 Dodge Stratus
Aug 04, 2015 | Dodge Cars & Trucks
Jan 08, 2018 | 2005 Dodge Stratus
Jun 19, 2013 | Dodge Stratus Cars & Trucks
Dec 10, 2010 | 2004 Dodge Stratus
Nov 18, 2010 | 2005 Dodge Stratus
Jul 19, 2010 | 2005 Dodge Stratus
Apr 15, 2010 | 2005 Dodge Stratus
Apr 04, 2010 | 2005 Dodge Stratus
14 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: