Question about 1988 Ford Bronco II

1 Answer

1988 bronco II, 2.9 4x4. stopped running on the freeway. Feels like ran out of fuel. Added more, both pumps working and spark at plugs. Cranks fine, what else should I be checking?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 3,698 Answers

Fuel filter.

Posted on May 11, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ford_67
  • 34 Answers

SOURCE: NEED WIRING DIAGRAM FOR 1988

Here is the info you neede728afa.jpg

Posted on Aug 07, 2008

MNfisherman
  • 11896 Answers

SOURCE: ford f150 1988 4.9 cranks but doesnt start

If you are getting fuel and spark, than it probably is either a bad ground, or the TPS sensor itself.

Posted on Jun 22, 2009

  • 246 Answers

SOURCE: where is fuel pump relay on 1988 Ford Bronco II

Fuse panel is located inside vehicle under dashboard on driver side. Fussible relays and links are located under the hood on the front of vehicle on drivers side.

Posted on Feb 21, 2010

Rickygittins
  • 715 Answers

SOURCE: no power to fuel pump

check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down injectors and fuel pump, if you are looking for the shut off switch to reset the relay, it is on the passagers side floor board under the dash, gas two wires, orange and pink, I don't remember the color of the stripes, I removed this switch and wired them together without a problem

Posted on Apr 27, 2010

  • 27 Answers

SOURCE: 1988 Ford Bronco fuel injection system isn't getting power to it

i had a similar problem that ended up being the fuel pump relay located in the engine compartment on the drivers side next to the air box. there will be at least 2 relays, the fuel pump one is black and brown. check that first.

Posted on Aug 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1988 bronco2 run for about 30 minutes baugh down it stops


That much time running sounds like the catalytic converter is plugging off and stalling the engine.

Oct 18, 2015 | 1988 Ford Bronco II

2 Answers

1988 bronco II vapor locking?


Just a guess here, but check your ignition coil. Make sure it's mounted nice and tight to the block. a bad ground on a coil will mess with you bad. other than that, I'd check and replace your fuel filter.

Jun 16, 2012 | 1988 Ford Bronco II

1 Answer

1989 Bronco fullsize has sat for the past 6 years and wont start, will turn over, has new gas with fuel stabilizer, still no firing. Replacing spark plugs and the fuel pump are the next two steps. ...


Assuming she ran good before she sat, replacing the plugs, cap and rotor isn't a bad idea.Step 1: Make sure you have good spark. No need to worry about timing right now. Step 2: If you have spark, then we have to see if its getting gas. There are two fuel pumps on this Bronco. One in tank and one on the frame rail. Can you hear either one running? The in tank one should come on for a few minutes and shut off. The front one is harder to hear.If you hear it, borrow or rent a FUEL PRESSURE GAUGE and check your fuel pressure. There is a fitting similar to a tire valve on fuel rail. Pressure should remain constant.If either pump fails you will not get adequate fuel flow. The front pump is easy to get to for trouble-shooting. Don't buy anything unless your sure you will need it. Hope this helps.

Feb 07, 2011 | 1989 Ford Bronco II

2 Answers

The vehicle died during the morning warm up process, now it just cranks and won't fire. It turns over well, but won't start????


Do you have spark at the end of the plug wires? Have you changed your fuel filter lately? Just some things to check first.

Dec 04, 2009 | 1986 Ford Bronco II

1 Answer

Ford Bronco II 2.9L V6 engine starting trouble


You should try checking the fuel pressure to see if it too low. If the pump sat for a long time like that and then was turned on for awhile it may have bought the farm. It may still be pumping, but just not enough. Try givng it a compression check as well just to see if it has any problems there.

Sep 08, 2008 | 1988 Ford Bronco II

1 Answer

My 1986 Ford Bronco II It doesn't run


1985 thru 1988 have two fuel pumps one of them is in the tank check it.the other is on the fram rail.

Jul 28, 2008 | 1986 Ford Bronco II

2 Answers

Bronco 2


possibly a fuel blockage. Is it getting fuel up the top?

May 23, 2008 | 1989 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...