Question about 2010 Jeep Cherokee 3.7

1 Answer

My 2010 Jeep Grand Cherokee, is shifting hard into its gears. Its an automatic transmission, that wont allow me to shift it mannually into the idividual gears, as I always do. It also is dropping the

Whould anyone have any thoughts to what the problem could be?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Dropping the what?
sure, why not scan the PCM first.
using any scan tool. scan it and read the errors and post them.
or read them and look them up in the FSM.

FSM= factory service manual
or at alldata.com

that is my DIY answer.
my other answer is , get it fixed. (serviced)
my guess is?
low ATF fluid levels.
bad tranny controls.
bad tranny sensors.
bad tranny.
my guesses are never right.
to find the true cause in any complex system is a set of tests.
all delinated in the FSM.

Posted on May 12, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Transmission wont shift into reverse

By the grayish color, fluid being thick, and metal shavings, the clutches are pretty much worn out. It's time to either rebuilding your transmission or just installing a good used one. The fluid normally should be a reddish color. The gray is from the actual clutch material going away.

Posted on Aug 17, 2008

  • 6982 Answers

SOURCE: 1993 JEEP GRAND CHEROKEE AUTOMATIC TRANSMISSION

Likely you have a shift control module malfunction. Module is probably on the right side fender in the engine compartment. Check to see if you have one (some do and some dont... go figure...I've got a 91 & 95... I have about five different diagrams and NONE apply to my vehicles)

Posted on Dec 16, 2008

  • 9 Answers

SOURCE: automatic transmission wont shift

no this is a warranty problem any rebuild is obligated to the mechanic for at least a year to me make him refix it ya dig

Posted on Apr 05, 2009

  • 6982 Answers

SOURCE: transmission wont shift until about 4000rpms from 1st to 2nd gea

Have a code check done and see if speed sensor or controller is working properly. if bought from a dealer, get it back there asap...they can't sell it in that condition!!...No test drive before you ploped down your money?

Posted on Apr 17, 2009

csmock132
  • 4669 Answers

SOURCE: My 1996 jeep grand cherokee wont shift into 3rd

Does Reverse work?

Posted on May 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 jeep cherokee automatic transmission hard to shifting gears


several pos causes. 1 dirty fluid/filter 2 improperly adj. throttle cable 3 bad pcm 4 low fluid/ hot

Mar 06, 2013 | 1997 Jeep Grand Cherokee

1 Answer

My jeep wont shift out of passing gear unless i let if the gas


try checking your transmission fluid level , low fluid will cause shifting problems

Jul 31, 2012 | 1996 Jeep Grand Cherokee

1 Answer

My 2001 jeep grand cherokee wont shift into 4th it only goes to third what would cause the 4th gear to not engage


There are several things that could cause that.
> Replacement transmission not equipped with overdrive
> Overdrive solenoid in replacement transmission defective
> Overdrive control circuits damaged or loose pins or connections.
> Gear shift linkage or cable out of adjustment
> Transmission range sensor malfunction or out of adjustment

Since you have a computer-controlled transmission, it would be better to ask the onboard computer that question....you will probably get a much more definitive answer.

Apr 18, 2012 | 2001 Jeep Grand Cherokee

1 Answer

Have a '93 Jeep Grand Cherokee, 4WD, 5.2L, 8 cyl, automatic that's not shifting. Transmission fluid looks good, no burnt smell, no metal bits in fluid, no grinding gears. Won't shift til you...


If the transmission will not go into gear or has trouble finding gears and has the proper amount of fluid, the shifting linkage could be bent or misaligned, especially on automatic models. The linkage can be found on the driver side of the transmission, toward the top of the unit. Inspect it to make sure the components aren't bent or broken and have someone shift the Grand Cherokee while you watch from underneath. Most times, only minor adjustments are necessary.
Also, check Torque Converter and scanned the TCM (Trans Control Module) to know if some fault code is stored there.

Jul 20, 2011 | 1993 Jeep Grand Cherokee

1 Answer

How can you tell what trans is in 01 grand cherokee laurado 4.0


Here is an article I found talking about the Transmission. The second generation Grand Cherokee: 1999-2004 Jeep WJ The first Grand Cherokee was redesigned in 1999, for lower production cost and greater performance and reliability; it was Chrysler's first use of an electronic bus to replace individual wires throughout the body.

Jeep five-speed automatic transmission

An all-new, electronically-controlled transmission with five forward ratios including an alternate second gear ratio for improved performance for passing and better fuel economy is available with the V-8 only, and was designed specifically for Jeeps.

The transmission features unique characteristics such as a tall, 3.00:1 first gear that gives the driver better initial acceleration. Real-time driver adaptive shifting fine-tunes the shift pattern to the driver, while an alternate second gear ratio gives the driver five forward ratios. During acceleration, second gear has a ratio of 1.67. Depending on speed and throttle position, both this gear and an alternate 1.50 second gear ratio are available for kick-down operation, making the down-shift smoother. Its reverse gear ratio is equal to the first gear ratio, to allow for heavier loads.

Other features include three planetary gear sets that combine the widest range of gear ratios available in any transmission in its class. Combined with precise step selections, this brings smooth shifts and maximum power and optimal fuel economy.

The transmission is built at the Indiana Transmission Plant in Kokomo, Indiana, in an all-new 1.2-million square-foot (110,000 m2) facility.


Mar 01, 2011 | 2001 Jeep Grand Cherokee

1 Answer

Just put another tranny in my 95 jeep grand cherokee now it wont shift out of 3rd gear what could be the problem 4.0 engine automatic


it could be a few different things? try un-plugging and plugging back in your wire connector to the transmission control module,or replace the tranny filter

Aug 09, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Automatic transmission wont shift


no this is a warranty problem any rebuild is obligated to the mechanic for at least a year to me make him refix it ya dig

Apr 04, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2010 Jeep Cherokee 3.7 Logo

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...