Question about 2009 Chevrolet Aveo
The car wont start and i have checked all batteries cables and fuses has power to the dash but wont attempt to start at all plus i noticed the fuel pump doesnt come on either when you first turn key on
I am curious to find out why you think it is the inertia switch. Did the car get hit in the rear end or did you back into something? Does the car crank? When did it start happening after putting gas in the car? Is it getting gas? If it doesn't crank it could be the starter. If it started after getting gas it could have water in the tank. If it isn't getting gas it could be a clogged fuel filter, a blown fuse or a bad fuel relay or fuel pump. It is hard to say without being able to check the vehicle. Have you had the battery load tested? there could be enough juice to light the dash but not enough to turn the engine over. Have you checked both ends of the battery cables? The connection on the battery side could be fine but the end at the ground or starter could be loose.
Posted on Jan 21, 2015
These are in one of two places on most all makes. 1st is behind the passenger side kick panel under the dash, most newer vehicles have a hole that you can access the switch (finger). 2nd is in the trunk on the passenger side close to the rear of the car. You'll have to pull back the felt cover on the side.
Posted on May 12, 2014
Check ignition coil boy.
Posted on May 12, 2014
Check engine computer and wireing
Posted on May 11, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1987 chevy r10 won't start
Assuming it is a fuel problem I checked at the carb. to be sure no gas was being pumped through the filter located under the power steering pump then the fuse on my 87 s10 was the ECM fuse.then check for the relay to click and the had to replace the oil pressure sending unit and mine started right up..the oil pressure must be about 4 lbs for the Pump tp operate...I loosened the fuel line to ck. for fuel but thats living dangerously...a pressure guage would be on the safe side......
Posted on May 18, 2009
Put the key in turn it on don't start it wait 10mins turn the key off remove it waits 10 seconds repeat this 3 times this should help if not try this with another key if it still don't work your ignition switch ifs probably bad dealer must replace and reprogram new keys. I got this info from the emission wiz it helped me on 2 different cars
Posted on Mar 24, 2009
My 2000 cavalier has done this for 6 months. You take your key out then open your door, wait ten minutes and the system resets itself and the car will start-annoying you bet!!!
Posted on Aug 21, 2009
Try under the dash, attached to colum is a switch that the rod goes into from your ignition key switch, that may need to be adjusted tword your steering wheel just a touch, they go out of alignmnet from time to time
Posted on Sep 15, 2009
Tips for a great answer:
Jun 11, 2017 | Cars & Trucks
Nov 16, 2016 | 2009 Chevrolet Aveo
Feb 15, 2016 | Cars & Trucks
Oct 11, 2015 | Seat Cars & Trucks
Oct 10, 2014 | 2009 Chevrolet Aveo
Aug 02, 2014 | 1999 GMC Sonoma
Mar 03, 2014 | 2011 Chevrolet Aveo
Nov 20, 2013 | Cars & Trucks
Nov 11, 2012 | Chevrolet Cars & Trucks
Sep 01, 2012 | 2008 Chevrolet Aveo
161 people viewed this question
Usually answered in minutes!