Question about Cars & Trucks

1 Answer

I have a simplicty regent . The speed on it seems to slow . Is there something wrong ? Reverse is really slow

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 20,706 Answers

Is this a car?

Posted on Jun 22, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 Camry Reverse noises

this really sounds like a broken motor mount / trans mount. An easy way to check is have someone sit in the car and shift into reverse, then to neutral, then to drive. Have your "assistant" do this repeatedly with the hood up, parking brake ON and foot FIRMLY applying the brakes while you watch the motor move. if you can see a big difference in "jump" between reverse and drive, that is a bad mount. The motor will lift or "jump" higher on the broken mount side. if your really not sure then try a gentle power brake in each direction.

Mar 31, 2014 | 1998 Toyota Camry

1 Answer

Bell & howell 356 projector runs slow

You have this posted in the car and truck forum, please re-post in the correct product category.

Feb 21, 2012 | Cars & Trucks

1 Answer

2005 Kia Sorento - on dry pavement going forward in 4 wheel drive at slow speed turning left the rear wheel driver side seems to be trying to go reverse, can hear is catching or locking on the road,...

you shouldnt use 4x4 on dry road its made for pulling or snow mud etc type situations if you feel its ok then check tire size are they all the same size tires and the pressure all the same if you dont have a check eng light on then there is nothing wrong with the 4x4 but dont forget all wheel drive works with abs tcm if one wheel spins faster or slower then the rest it puts on the abs to slow it down or the trans shifts up to speed it up so there are a few things to check

Jun 21, 2011 | Kia Sorento LX Cars & Trucks

1 Answer

Heter blower is 50 - 50 to work or not from start up. 'if' it comes on it works for minutes, it will slow down as engine speed increases, back to full when clutch dipped to change gear, then slows down...

Items to check with blower motor:
First there is NO correlation to engine speed and blower motor.
Blower motor may be dying, Blower resistors are defective, on/off switch.
If there is no voltage to the reverse switch, then you have to back probe that wire and see where the open is.
The answer to your question yes there is a common connection. Probably at the fuse box. Like I said earlier you have to back probe wire to reverse switch and find out where it is open. Good luck

Jun 17, 2010 | 1998 Audi A4

1 Answer

Ford fiest 2005 gear problem

try shifting trough all speeds with the engjen off if you can do that then you need to remove your trans 7check your syncronizers & input shaft for wear,pitting or binding

Jun 03, 2009 | 2000 Ford Escort

1 Answer

92 sable shuts off when slowing down

its over heating, check water pump

If you need further help, I’m available over the phone at

Apr 30, 2009 | 1992 Mercury Sable

1 Answer

Engine is slow to accelerate when up shifting.

thats a carb or fuel injection on the 86? i had a similar problem on an amc eagle ....turns out that the timing chain had jumped a tooth,

Mar 30, 2009 | 1986 Toyota Pickup 4WD

1 Answer

Check engine light

Yes, the speed sensor is really easy to get to after you jack the car up. The trans. computer is detecting something is wrong and puts the car into "limp in" mode. I've seen alot of these speed sensors go out on the Chrysler products.

Aug 18, 2008 | 1999 Plymouth Breeze

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides