Question about 2005 Chevrolet Cobalt

Open Question

2008 shevy cobolt ac compressor doesnt turn on

All fuses/relays & wiring ok.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 206 Answers

SOURCE: which fuze controls the cigarette lighter in a 2008 cobolt?

It should be under the hood in that fuse panel labeled pwr outlet

Posted on Mar 01, 2009

Ad
  • 95 Answers

SOURCE: 1999 Chevy Tahoe AC compressor cycles on and off.

That would be the fan clutch on the compressor itself... if it wont take a charge with all setting on high and running then you'll need to get it replaced , have a specialist inspect it to make sure the innards of the compresor arent junk...I have same pronblem with my 97 z28.. but it will take a charge and last 3 months then i have to recharge...The clutch and innards of my compressor are going bad..So its a chevy known issue,,,best of luck...Ohh one more thing do you hear a hiss when you turn it off and on, the ac that is

Posted on May 18, 2009

emissionwiz
  • 80339 Answers

SOURCE: horn doesnt work but fuses and relay are good

In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to follow factory Airbag disarming protocol can result in an unexpected Airbag deployment and possible serious personnel injury or death.

Posted on May 26, 2009

  • 54 Answers

SOURCE: No power for AC compressor

It sounds like you may be low on freon, if the low pressure switch, senses low freon pressure, it won't let the A/C come on. You either have low freon, or the low pressure switch on the accumulator has gone bad. Both common problems with that vehicle.

Posted on May 28, 2009

SOURCE: 2005 Cobalt air conditioning compressor will not

have the a/c system checked for leaks and recharge the a/c system

Posted on Jun 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Is there a fuse or shut off for the fuel pump, can't get it to pump fuel to the engine?


In this diagram, the asd relay supplies voltage to fuel pump. See the red wire, hot all the time, protected by fusible link. Use a test lite check for voltage on that wire? If it is hot, unplug the asd relay use a jumper wire on load side of relay, the load side is that line with arrowhead. Use a jumper wire between red and dark green wire terminals, if the pump runs, hopefully it is ok. The problem would be on control side of relay, right side in picture. The control side of relay needs both voltage and ground.
Any applicable trouble codes?
asd relay-t0ipf1pjp5q14wy0jhyzzx1m-3-0.jpg

Apr 09, 2017 | Cars & Trucks

2 Answers

No hot wire to power right and left frt windows. relay or fuses ?????


I assume everything else works so start with the schematics and determine which fuse(s) and circuit(s) these power windows are on. Find the fuses. If these are OK, check wires for shorts, breaks and/or loose connections. If they are OK, check power window switches, then you'll probably have to deal with the window motors and connections.

Feb 17, 2014 | 1986 Ford Thunderbird

1 Answer

2004 Tacoma - tail lights don't work but brake lights and reverse lights do work. Bulbs look ok. fuse looks okay. Wiring looks ok. Could it be a relay or is there something else to check? Than


try cheaking the light switch its self may be faulty not normally a relay for but it shold tell you on fuse box which relay runs light ign ect

Sep 21, 2012 | 2007 Toyota Tacoma

1 Answer

Car won't start when I turn the key to start the #10 fuse engine relay pops I checked every thing down to the fuel pump and every thing is fine the few times I got it started I took it around the block and...


I had a similar problem where the battery was ok but there was no sound from the starter and also there no lights on in the dash when the key was turned. Checked the fuse and checked wire from the fuse back to the ignition switch. The wire from the fuse was ok in fuse box but had no voltage at the ignition sw. The was also no voltage to terminal 30 in the starter relay. Ran a new wire from the fuse to the ignition and it fixed everything. Check for voltage at terminal 30 on the starter relay

Feb 24, 2011 | 2000 Dodge Neon

2 Answers

Do not have power to a/c clutch what can cause this


If the fuse is OK, the the A/C relay is a very likely candidate. This can often be tested by swapping with an identical relay from another system. If the fault moves with the relay, the relay is the problem. If the relay is OK, the A/C switch is the next most likely cause.

Nov 25, 2009 | 1994 GMC Sierra

2 Answers

Power windows don't work


I had the same problem. There was a wire broken into where the wires go from the door to the inside of the cab. There is a rubber boot over the wires that you have to take loose to see the wires. I changed fuses, checked switches, and relays but i finally found the problem. I hope this helps. DVPNN

Mar 06, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

No power to fule pump relay is ok gray wire hase no power canot


hi ted , the grey wire at the fuel pump goes to the fuel pump relay , and the relay gets its power from the ECM B fuse 20 amps , located in the underhood fuse relay center , when you tested for power , how did you do the test ? a test light at the grey wire while someone was cranking the motor ? i'm looking for a fix ya vote , so if finding your fuse doesn't solve your problem comment back before voting and i will help you , thanks .

Jan 11, 2009 | 1999 GMC Safari

2 Answers

Indicators keep blowing fuses Hazards ok


THE WIRES ARE NORMALLY PUSH ON LIKE SPEAKER WIRES BUT IF IT IS MELTED THERE IS A SHORT IN THE WIRE SOMEWHERE IT COMES OUT OF FUSE BOX THEN TO RELAY UNIT THEN FROM RELAY TO SWITCH THE RELAY MIGHT BE FAULTY CAUSING WIRES TO HEAT UP RELAYS ARE LOCATED IN FUSE BOX THERE IS ALWAYS MORE THAN ONE SO SWAP FOR ANOTHER RELAY REPLACE FUSE AND TRY LIGHTS AGAIN TO SEE IF THE RELAY IS THE PROBLEM HOPE THIS HELPS GLENN

Nov 14, 2008 | 1999 Isuzu Trooper

Not finding what you are looking for?
2005 Chevrolet Cobalt Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...